Answered: impedance of a series RC circuit is…

impedance of a series RC circuit is given as (8- j6) ohms and is connected to an ac source of 200.50HZ then the value of capacitive reactance is Select

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.18MCQ

See similar textbooks

Related questions

Q: Suppose that the modulating signal m (t) is sinusoid of the form m (t) = 10 COS ( 2π103t) and the…

A: Given Note : It is the kind notice that according to the guidelines of the company is supposed…

Q: (a) Determine the equivalent frequency domain impedance, Z for the circuit shown in Figure Q2(a). Z…

Q: For the circuit in the figure below, determine the load impedance that maximizes the average power…

Q: Let be FT open loop, using the LRs method, design if necessary, a phase Lead compensator to obtain…

A: The open loop transfer function is given by Gs=1ss+2To draw the root locus-→No. of open loop poles…

Q: QI: Draw the impedance diagram for the series R-C circuit for the figure, then find the : Q2: For…

Q: 1. Write down a formula for the three-phase power factor, assuming perfectly sinusoidal and…

A: 1. Write down a formula for the three-phase power factor, assuming perfectly sinusoidal and…

Q: 3. Sketch the AM modulated signal (assume sinusoidal signal modulating a sinusoidal carrier) in both…

A: Signal modulation- It is a process in which any of the parameter of the signal is modulated. The…

Q: Calculate the impedance ?? for the maximum average power transfer in the circuit shown in Figure 3.…

A: In this answer we will try to find out the answer by developing the thevenin's equivalent of the…

Q: The open circuit and short circuit impedance of a transmission line are 200 ohm and 50 ohm…

A: Given data:

Q: For maximum average power transfer in the circuit shown in the figure, set the impedance ZL and ZL…

A: In the circuit, For maximum average power transfer in the circuit shown in the figure, impedance…

Q: A circuit branch is found to have an equivalent impedance of Z=120−j45Ω. It is given that this…

A: Impedance: Impedance of a circuit is the combination of all the resistance as well as reactance. It…

Q: What is nodal analysis/node-voltage method for Ac circuits. Also, please give me atleast 2 circuit…

A: NODAL ANALYSIS/NODE ANALYSIS FOR AC CIRCUITS: 1. One method of calculating the current and voltage…

Q: The total impedance Z, of a circuit containung an inductor with inductance L and resistance R in…

A: we need to find out R and L.

Q: Find the impedance ZL and the value of the maximum average power transferred to ZL for the maximum…

A: 4=Voc1-j1 Voc =4-j4 v

Q: Is it possible to measure the phase-shift angle in an AC single-phase circuit by an indirect method…

A: The electrical circuits have resistance, inductance and capacitance as their elements. In the…

Q: A series RLC circuit is connected to an AC power source, as shown in the figure. Given that the…

Q: The load Z, consumes an average power of 75 W and a reactive power of -125 V AR. What component is…

A: Given Data: P = 75 W Q = -125 VAR vs = 75 w = 250

Q: 2. In the simple system below, draw the V-Q curve for the load bus if P-D0. What is the maximum…

A: As per the guidelines given, We can only provide the solution of the first question in multiple type…

Q: Find the impedance Zl and the value of the maximum average power transferred to Zl for the maximum…

Q: at

Q: Enumerate five step-by-step procedures of Maximum power transfer theorem method in application to ac…

A: MPT theorem: This is used to find the maximum power in the load.

Q: Sketch and fully label the impedance diagram (also show the exact value for the magnitude and phase…

A: In this question we will find zt magnitude and phase angle and impedance diagram..

Q: State and prove maximum power transfer theorem for DC circuits.

A: Maximum power Theorem: It state that, A resistive load which is connected to a dc network, receives…

Q: Derive an expression for the input impedance Zin in terms of the load impedance Z₁ and the…

A: Given We need to derive an expression for input impedance in transmission line. Please find the…

Q: For the cct shown Find ZT, I,e, phaser diagram =100L I.

A: Given U =100∠0°R =8 ΏXL =6Ώ

Q: Impedance is an AC quantity is composed of both resistance and ______________. A. complexity B.…

Q: For a current of r.m.s. value 5 A, and frequency 2 kHz, write down the standard expression. Hence,…

A: The R.M.S value of the current is 5 A. The frequency of operation is 2 kHz. The expression of the…

Q: Q#5. Illustrate the variation of output power taken from the wind turbine? How the frequency in wind…

A: In the case of the Wind turbine generated power will vary with the wind flow. So the power will…

Q: For the maximum average power transfer in the circuit shown in Figure 2, use the impedance ZL and ZL…

Q: The circuit shown in Figure Q5.1 consists of a current source connected to a load via a cable. The…

A: Current is given , On comparing with standard equation. Taking cos as reference current will be,

Q: Find the natural frequency for this system with its closed-loop poles as shown.

Q: A 50-ohm source has an RMS open-circuit output voltage of 1 volt at 100 MHz a. What peak voltage…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: For the given circuit (A) Find the TOTAL IMPEDANCE Zr in polar form, the CURRENT I and the…

A: Power Factor- Power factor is defined as the ratio of active power to apparent power.…

Q: The impedance of zl for the maximum average power transfer in the circuit shown in Figure 3 and ZL…

Q: For the circuit shown, solve for IB, IC, VCE, IC(sat) and VCE(off). Also, construct a dc load line…

A: BJT is current controlled electronic device in which their mode of operation controlled by base…

Q: The function f (t) in the figure is given by a) Find the coefficients a0, an and bn in the Fouries…

Q: For the circuit shown, solve for IB, IC, VCE, IC(sat) and VCE(off). Also, construct a dc load line…

A: The circuit diagram is shown below, Where,RB=390kΩRC=1.5kΩβ=150

Q: Consider the circuit below and answer the following questions. Vi1 R3 R1 Vo Vi2 R2 a. Determine an…

A: Please find the detailed solution in below images.

Q: A capacitor is connected to an AC source, the current is a) leading or lagging? b) by many degrees?…

A: In this question we will write about inductor ans capacitor voltage and current relationship and…

Q: (c) In an electric power system, it is given that the effective impedance of the generator station…

A: It is Given that:RS=200Ω Rl=300ΩL=250 KmVS=45 kV f=60Hz Pmax=VS2Zth

Q: From the circuit given below, How can I find the value of load Z for the maximum power transfer and…

A: According to question: The value of 'Z' for maximum power transfer is calculated as…

Q: V Z+Zc where: 10 rad w = angular frequency in E Z = 2000 , jw 4-A) Show that the can be written as:…

Q: How much is the Zt for a 20-Ω resistor in series with a 20-Ω capacitive reactance? If a 20 V is…

Q: For the maximum average power transfer in the circuit shown in Figure 2, use the impedance ??. and…

Q: What will be the average power in the load for the circuit shown, when alpha = π/4 Assume SCR to be…

Q: Evaluate the following twiddle factor: W48

A: In this case, the following twiddle factor needs to be evaluated: W84

Q: 1) For the circuit shown blow， calculate ?_out assuming that ?_1 = 5?Ω ?_2 = 15?Ω and ?_in 12V .…

A: It is given that: R1=5ΩR2=15ΩVin=12 V

Q: What is the relationship between R, L, and C components in a series AC circuit?

A: The solution is given below

Concept explainers

Single Phase Induction Motor

The single-phase induction motor or engine consists of a single rotating phase in the stator and a rotating cage in the rotor. When phase one supply is connected to the stator winding, a magnetic field is generated. In the pulsating field, the rotor does not rotate due to inertia. So, a single-phase import motor does not start and requires some initial methods.

Question

If the impedance of a series RC circuit is given as (8- j6) ohms and is connected to an ac source of 200.50HZ then the value of capacitive reactance is Select one: a.3 Ohm b .None of these c. 5 Ohm d. 2 Ohm

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

An inductive impedance made up of a resistor and an inductor has the characteristic that its currentadvances in phase to the voltage at the impedance A) lags in phase with the voltage across the impedance B) is in phase with the voltage across the impedance. C) None of the above
Shown in the figure below is an "RL" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 9.84 Volts and is running at a frequency of f = 8.585e+04 Hz. The resistor has a resistance of R = 2170 and the inductor has an inductance of L = 3.54e-03 Henries. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Determine the numerical value of Ztot = 2890.5 Determine the numerical value of $z= = 41 Determine the current through the circuit: • I(PEAK) = 4.81E-3 • I(RMS) = 3.404E-3 Determine the voltage across the resistor: • VR(PEAK) = 7.387 • VR(RMS) = 5.22 ✔✔ Amps ✔Amps Write the FORMULA for the phase of the total impedance of the circuit z... = | tan-1 2701 R x Volts X Volts Determine the voltage across the inductor: • VL(PEAK) = 9.184 • VL(RMS) = 6.49 ✔ Volts Volts L R²+ WL- ✔ degrees 2 If a second circuit were connected in parallel with the inductor, this circuit would be considered as: O a low-pass filter O a capacitive switcher…
Shown in the figure below is an "RC" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 11.58 Volts and is running at a frequency of f = 1.326e+04 Hz. resistor has a resistance of R = 3750 2 and the capacitor has an capacitance of C = 3.17e-09 Farads. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit tot = Determine the numerical value of Ztot = Determine the numerical value of Pztot= Determine the current through the circuit: • I(PEAK) = • I(RMS) = Determine the voltage across the resistor: Amps Amps S2 C degrees
A 220 Ω resistor is in series with an 80 mH inductor. The AC source is 48 at 1 kHz. The power factor is ________. Hint: Draw the circuit and get Vs and Is
A series RC circuit with R=4k ohms and C= 0.40 mF is connected to an AC voltage source e(t)= 100 sin200t. Determine the following: a). The overall power factor ( indicate big leading or lagging) b). The voltage drop across the resistor and the capacitor
Problem Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V dc voltage source.
d) 3-A 500 ohm resistor is connected in series with a coil with a self-inductance of 800 mH and the maximum It is fed by a sinusoidal source with an amplitude of 15 V and a frequency of 15.92 Hz. According to this Which of the following can represent the voltage across the coil? 14.81cos(wt - 9.09) V 2.5cos(wt - 21.2) V 7.20cos(wt - 11.45) V 2.37cos(wt - 81) V 8.5cos(wt - 41.2) V leave blank 3075
The below figure shows the waveform of the voltage and current in a purely inductive AC circuit. Voltage Current Using the voltage phasor as the reference, the current phasor Lags by 90° Is in phase with the voltage Leads by 90° Lags and then leads by 160°
What is the value of capacitance if the capacitive reactance is 50 Q .Assume frequency of supply as 50 Hz ? a. 53.3x10-5 F O b. 5.3x10-5 F c. 6.36x10-5 E d. 63.3x10-5 F
Apply a sinusoidal input voltage with 2V p-p and vary the frequency according to the table below. Measure the voltage Vr and current I from the voltage across R and find the phase angle between the Vi and I.
Two lossy capacitors with Equal capacitance values and power factors of 0.01 and 0.02 are in parallel, and the combination is supplied from a sinusoidal voltage source. The power factor of the combination is ?
4- A Circuit of zero lagging power factor behaves as a. A capacitive circuit b. An inductive circuit c. RC circuit d. RL circuit