In a simple AC circuit, the voltage is 110 VAC at 60 Hz (the American standard) and the resistance is R. Determine: (a) maximum voltage; (b) rms current; (c) maximum current; (d) maximum power dissipated in the resistance; (e) average power dissipated in the resistance. R 300 ohm; a) b) c) d) (e) 111

In a simple AC circuit, the voltage is 110 VAC at 60 Hz (the American standard) and the resistance is R. Determine: (a) maximum voltage; (b) rms current; (c) maximum current; (d) maximum power dissipated in the resistance; (e) average power dissipated in the resistance. R 300 ohm; a) b) c) d) (e) 111

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter15: Alternating-current Circuits

Section: Chapter Questions

Problem 3CQ: In an RLC series circuit, can the voltage measured across the capacitor be greater than the voltage...

See similar textbooks

Similar questions

Can the instantaneous power output of an ac source ever be negative? Can the average power output be negative?
Check Your Understanding What happens to the resonant frequency of an RLC series circuit when the following quantities are increased by a factor of 4: (a) the capacitance, (b) the self-inductance, and (c) the resistance?
Check Your Understanding The resonant angular frequency of an RLC series circuit is 4.0102 rad/s. An ac source operating at this frequency transfers an average power of 2.0102W to the circuit. The resistance of the circuit Is 0.50 Q. Write an expression for the emf of the source.
In an RLC series circuit, can the voltage measured across the capacitor be greater than the voltage of the source? Answer the same question for the voltage across the inductor.
Check Your Understanding An ac voltmeter attached across the terminals of a 45-Hz ac generator reads 7.07 V Write an expression for the emf of the generator.
An ac source of voltage amplitude 100 V and variable frequency f drives an RLC series circuit with R=10 , L = 2.0 mH, and C=25F (a) Plot the canal through the resistor as a function of the frequency f. (b) Use the plot to determine the resonant frequency of the circuit.
(f) A capacitor C of 50uF and a resistor R of 820 are connected across an AC source as shown in Figure 3, where v,(t) (400)sin (100t + 60°) V. R. VR Vc Is Vs Figure 3 (i) Calculate the supply current Is in polar form (RMS). (ii) Determine the voltage drop across R VR in polar form. (ii) Calculate the voltage drop across C Vc in polar form. (iv) Draw a phasor diagram showing the supply voltage Vs, the supply current Is, the voltage across R VR, and the voltage across C Vc. (v) Calculate the circuit power factor from the phasor diagram.
om the Ăn AC voltage source has an amplitude of 96. V and frequency 400. Hz. The voltage was zero lower at t = 0 and was increasing. (a) What is the effective rms voltage? (6) What is the instantaneous voltage at 1.00 ms? %3D 2 (c) When will the voltage be 40. V?
If the current in an AC circuit is represented by the equation, i=5 sin (300t - π/4) Here, t is in second and is in ampere. Calculate, (a) peak and rms value of current. (b) frequency of AC. (c) average current. Peruss
A 1.5 - kΩ resistor is connected to an AC voltage source with anrms voltage of 120 V. (a) What is the maximum voltage acrossthe resistor? (b) What is the maximum current through theresistor? (c) What is the rms current through the resistor?(d) What is the average power dissipated by the resistor?
When a certain resistor is connected to anac generator with a maximum voltage of 15 V, the average powerdissipated in the resistor is 22 W. (a) What is the resistance of theresistor? (b) What is the rms current in the circuit? (c) We knowthat Pav = I2rmsR, and hence it seems that reducing the resistanceshould reduce the average power. On the other hand, we alsoknow that Pav = V2rms>R, which suggests that reducing R increasesPav. Which conclusion is correct? Explain.
At an instant of time during the oscillations of an LC circuit, the current is at itsmaximum value. At this instant, what happens to the voltage across the capacitor? (ii) Nowconsider an instant when the current is momentarily zero. What happens to the magnitudeof the voltage across the capacitor at this instant? (b) Verify that the time constant of LRcircuit has unit of time.