In an automatic clothes drier, a hollow cylinder moves the clothes on a vertical circle (radius r = 0.314 m), as the drawing shows. The appliance is designed so that the clothes tumble gently as they dry. This means that when a piece of clothing reaches an angle of 0 above the horizontal, it loses contact with the wall of the cylinder and falls onto the clothes below. How many revolutions per second should the cylinder make in order that the clothes lose contact with the wall when 8 = 69.0°? Number i eTextbook and Media Units

In an automatic clothes drier, a hollow cylinder moves the clothes on a vertical circle (radius r = 0.314 m), as the drawing shows. The appliance is designed so that the clothes tumble gently as they dry. This means that when a piece of clothing reaches an angle of 0 above the horizontal, it loses contact with the wall of the cylinder and falls onto the clothes below. How many revolutions per second should the cylinder make in order that the clothes lose contact with the wall when 8 = 69.0°? Number i eTextbook and Media Units

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter7: Rotational Motion And Gravitation

Section: Chapter Questions

Problem 56AP: Keratinocytes are the most common cells in the skins outer layer. As these approximately circular...

See similar textbooks

Similar questions

Keratinocytes are the most common cells in the skins outer layer. As these approximately circular cells migrate across a wound during the healing process, they roll in a way that reduces the frictional forces impeding their motion. (a) Given a cell body diameter of 1.00 105 m (10 m), what minimum angular speed would be required to produce the observed linear speed of 1.67 107 m/s (10 m/min)? (b) How many complete revolutions would be required for the cell to roll a distance of 5.00 103 m? (Because of slipping as the cells roll, averages of observed angular speeds and the number of complete revolutions are about three times these minimum values.)
A point on a rotating turntable 20.0 cm from the center accelerates from rest to a final speed of 0.700 m/s in 1.75 s. At t = 1.25 s, find the magnitude and direction of (a) the radial acceleration, (b) the tangential acceleration, and (c) the total acceleration of the point.
In circular motion, a tangential acceleration can change the magnitude of the velocity but not its direction. Explain your answer.
Merry-go-rounds are a common ride in park playgrounds. The ride is a horizontal disk that rotates about a vertical axis at their center. A rider sits at the outer edge of the disk and holds onto a metal bar while someone pushes on the ride to make it rotate. Suppose that a typical time for one rotation is 6.0 ss and the diameter of the ride is 16 ftft . 1. For this typical time, what is the speed of the rider, in m/sm/s? Express your answer in meters per second. 2. What is the rider’s radial acceleration, in m/s2m/s2? Express your answer in meters per second squared. 3. What is the rider’s radial acceleration if the time for one rotation is halved? Express your answer in meters per second squared.
A disk of radius 4.00 m spins with an angular speed of 90.0 degrees/second. What is the speed of the ladybug sitting halfway, in m/s?
There is a CD-rom that's spinning a CD at 2,000 rpm. There is a bit of dirt, weighing 0.220 g, attached to the CD 3.50 cm from the centre. What must the force of friction between the CD and the dirt be so that the bit of dirt continues to rotate in a circle and doesn't fly off? Give your answers in units of mN (millinewton), to three significant figures
There is a clever kitchen gadget for drying lettuce leaves after you wash them. It consists of a cylindrical container mounted so that it can be rotated about its axis by turning a hand crank. The outer wall of the cylinder is perforated with small holes. You put the wet leaves in the container and turn the crank to spin off the water. The radius of the container is 12.2 cm. When the cylinder is rotating at 2.45 revolutions per second, what is the magnitude of the centripetal acceleration at the outer wall? Number Units #
Merry-go-rounds are a common ride in park playgrounds. The ride is a horizontal disk that rotates about a vertical axis at their center. A typical size is a diameter of 12 ft. A rider sits at the outer edge of the disk and holds onto a metal bar while someone pushes on the ride to make it rotate. Estimate a typical time for one rotation. (a) For your estimated time, what is the speed of the rider, in m/s? (b) What is the rider’s radial acceleration, in m/s2? (c) What is the rider’s radial acceleration if the time for one rotation is halved?
. A centrifuge will be used to give astronauts a gravity “spin-up” for one hour per day while on Mars. If thecentrifuge begins at rest and increases to 18 revolutions per minute. Find (a) the angular acceleration and (b)the final angular velocity in rpm.
A three-blade wind turbine, which spins perpendicularly to the ground, is set on a pole that is 38 m tall and completes 5 revolutions in one minute. The length of one blade is approximately 4 m long. One particular blade lies parallel to the ground before the turbine started to spin. b) What is the height of the tip of the blade after one second from start?
An advertisement claims that a centrifuge takes up only 0.127 m of bench space but can produce a radial acceleration of 2700 gg at 4800 rev/min. Calculate the required radius of the centrifuge. Express your answer in meters. Is the claim realistic?
A string under a tension of 59.0 N is used to whirl a rock in a hortzontal circle of radius 2.45 m at a speed of 20.1 m/s on a frictionless surface as shown in the figure below. As the string is pulled in, the speed of the rock increases. When the string on the table is 1.00 m long and the speed of the rock is 50.5 m/s, the string breaks. What is the breaking strength, in newtons, of the string? Need Help?