Ms. Tan came to the laboratory for blood tests because her physician suspected renal disease. The tests ordered were serum BUN, creatinine, and electrolytes. The blood specimen was obtained and processed. When the laboratory scientist received the serum to perform the tests, he noticed that the serum had a reddish tinge. What factor/s could cause this to happen to a serum specimen?     2. Is the sample acceptable for use? Elaborate your answer

Q: An analytical chemist weighs out 0.054 g of an unknown monoprotic acid into a 250 mL volumetric…

A:

Q: Use the information and table to answer the following question. A student wants to determine how…

A: From the above table. The following conclusions are given

Q: Four test tubes with 20mL of water and cut flowers were set up. Three of the test tubes had food…

A: as per question its the Time that is 10:00 am that is kept constant for observation of the color

Q: You are required to analyze the semiconductor wastewater samples containing with cadmium. A sample…

A: A question based on qualitative analysis of cations that is to be accomplished.

Q: 16. A doctor has ordered that a patient be given 30.00 dg of glucose, which is available in a…

A: (16) Given that -  Mass of ordered glucose = 30.00 dg  Concentration of glucose available = 20.00…

Q: You have a 3.5 M H3PO4 solution available. Complete the following questions about this solution:…

A: The process by which the concentration of a solution is reduced by adding a suitable amount of…

Q: A fake banknote can be investigated by dissolving the ink off the paper. You are provided with four…

A: Chromatography is a technique for separating mixtures into their constituent substances and studying…

Q: What specific value from the graph is needed to calculate the molar concentration of the NaOH(aq)?

A: Use the titration formula. If the titrant and analyte have a 1:1 mole ratio, the formula is molarity…

Q: It is always important to label everything in the dispensary or the medicinal chemistry laboratory.…

A: We can use two different techniques to distinguish between Aspirin and paracetamol namely…

Q: 0.05 g of acetyl salicylic acid has been dissolved to the volume 25.00 ml to create a stock…

A:

Q: Data of Candy: Mass of candy: 6.1115g Concentration of NaOH (M): 0.09639 Volume of NaOH solution…

A:

Q: At room temperature, table sugar has a solubility of 200. g in 100 mL of water. In boiling water,…

A:

Q: The following volumes of 0.000300 M SCN- are diluted to 15.00 mL. Determine the concentration of…

A: Concentration of diluted SCN-1 can be calculated by using formulaM1V1 = M2V2Where M1 & V1 is the…

Q: An unknown sample containing a mixture of NaCl and Na2CO3 was analyzed to determine the %…

A: Here we have to determine the percentage of Na2CO3 in the mixture by given volumetric analysis data…

Q: You have a 0.561 M solution of magnesium chloride. You pour out 389.8 mL. of this solution. How many…

A: Given that:  Molarity of Magnesium chloride (MgCl2) = 0.561M  Volume of solution = 389.8ml =…

Q: In a few lines, describe the IMMENENT IMPORTANCE of “Green Chemistry" and its importance to Society.

A: Green chemistry: The branch of chemistry which deals with the reduction of the harmful effect of…

Q: A group of students performed a series of titrations in the laboratory and found that their unknown…

A: 1. Given that, the exact value of concentration is Cexact = 15.47 M. The calculated value of…

Q: which method we are going to use in ipecac syrup define and explain this method.

A: Ipecac is commonly made from alcohol extraction of the plants Cephaelis acuminata and Cephaelis…

Q: An analytical chemist weighs out  0.149g  of an unknown diprotic acid into a  250mL  volumetric…

A: Answer:- This question is answered by using the simple concept of stoichiometry using balanced…

Q: One way in which the useful metal copper is produced is by dissolving the mineral azurite, which…

A: Given, the balanced equation: Fe(s) + CuSO4(aq) → Cu(s) + FeSO4(aq) The volume of copper(II)…

Q: 7. When measuring 15ml of a solution, which of the following graduated cylinders will you use and…

A:

Q: A 20.0 g sample of HF is dissolved in water to give 2.0 x 102 mL of solution.  The concentration of…

A: Given:   The mass of HF is 20.0 g. The volume of solution is 2.0×102 mL.

Q: 1. Astudent analyzes an aspirin tablet using a method similar to the one used in this experiment.…

A: 1) HOW MIGHT THERESULTS DIFFER IF A STUDENT ANALYZES A RECENTLY PURCHASED TABLET V/S A LONG EXPIRED…

Q: A chemist wishes to mix a solution that is12​% acid. She has on hand 8 liters of a 8​% acid solution…

A: Given: 8 litres of 8% acid solution is added to some 16% acid solution to get the desired 12% acid…

Q: Four test tubes with 20ML of water and cut flowers were set up. Three of the test tubes had food…

A: In the experiment, the dependent variable was:

Q: In titration, what solution is placed inside the Erlenmeyer flask? Group of answer choices diluted…

A: During titration two solutions are used. One with known concentration which placed in burette.

Q: Which piece of lab equipment is used to obtain a small, accurate volume from a stock solution for a…

A: The amount of solute dissolved in the solution is known as the concentration of the solution. In the…

Q: Discuss whether your data in Part C (Quantitative Analysis of Salt Solutions) appears to follow a…

A: Conductivity of a solution is related to concentration by the equation : λm = κ/C where λm is molar…

Q: A certain chemical dissolves in water at a rate proportional to the product of the amount undissoved…

A: Total mass of saturated solution = 100 gm Mass of solute that can be dissolved in solution = 50 gm

Q: If you calculated from your titration that there was 13.75 mg of vitamin C in your fruit juice…

A: The concentration (in mg/mL) is given as: Concentration=MassVolume

Q: Use the table and graph below to answer Questions 2–6. 2. What must be a constant during the…

A: Hi, since you have posted multiple questions. We will answer the very first question for you. Kindly…

Q: A mixture of spaghetti and water is separated using a strainer, a physical method of separation.…

A: Filtration : It is the process of separating solid matter from the fluid one using a structure…

Q: An analytical chemist weighs out 0.083 g of an unknown monoprotic acid into a 250 mL volumetric…

A: find the moles of base.  then find the moles of mono protic acid  then find the molar mass using…

Q: You want to compare a patient's measured calcium ion concentration to the normal calcium ion…

A: Given that calcium ion concentration in blood serum ranges between 4.5-5.5 mEq/L Blood results show…

Q: An unknown substance dissolves in water but separates and floats in oil.

A: We have given that   An unknown substance dissolves in water but separartes and float in oil.…

Q: There are a flask, and burette containing an acid, and a base, respectively The first, a flask…

A: Given that,  Volume of unknown acid* in flask V1 = 10.0 mL * here unknown acid assumed as monoprotic…

Q: Data of Candy Mass of candy: 6.1115g Concentration of NaOH (M): 0.09639 Volume of NaOH solution…

A: The acid-base titrations such as sodium hydroxide versus hydrochloric acid can be used to determine…

Q: 10. A student reacted dilute nitric acid with lead (II) oxide to prepare lead(II) nitrate. The…

A: Common chemistry laboratory apparatuses : Equipments that are used in experiments are called…

Q: what are the differences and similarities of "The Chemical Professional's Code of Conduct" with Good…

A: The Chemical professional code of conduct is established to maintain the scientific integrity and…

Q: Mrs A is currently taking Mucogel® suspension at a dose of 10 mL after her three meals and at…

A: The dosage of Mucogel = 10 mL Mucogel contains 195 mg per 5 mL. Each dose of mucogel suspension is…

Q: Part C MnO2 (s) + Cu(s)→CU2" (aq) + Mn²+ (aq) Express your answer as a chemical equation. Identify…

A: Part A)  The given reaction is, Cr2O72-aq + Cu+aq → Cr3+aq  + Cu2+aq The balanced chemical equation…

Q: The protocol for a given lab experiment specifies that you should prepare a diluted solution by…

A:

Q: A 50.00 mL burette is reported to have an uncertainty of 0.03 mL in volume measurement. A titration…

A: Given , Initial reading =(1.00±0.03 )mL final reading =( 15.05 ±0.03)mL

Q: A student dissolves 106 g of compound Q in one liter of hot water. All of compound Q dissolves.  The…

A:

Q: A student submerges an 18.0 gram metal sample in water. The density of the metal is known to be 12.5…

A: The given data: The mass of the sample = 18.0 g The density of the metal = 12.5 g/mL The final…

Q: Household vinegar is a dilute solution of acetic acid. A sample of household vinegar was measured to…

A: “Since you have asked multiple questions, we will solve the first question for you. If youwant any…

Q: You want to compare a patient's measured calcium ion concentration to the normal calcium ion…

A: Molarity is the term used to express concentration of a solution. It is equal to the ratio of number…

Q: During a laboratory experiment, a student mixed two homogeneous aqueous solutions.  After mixing a…

A: Since the solution is having a precipitate in it. Hence we want to separate the solid from liquid.

Q: What is the volume (in mL) of 0.185 M   (sulfuric acid) containing 0.574 g ? Volume =  mL

A: The molarity of the given sulfuric acid solution is defined as the number of moles of the sulfuric…

Q: 2. Fifty cubic meters of water containing 28mg/L solids passes the Gallo River in one minute. There…

A:

Analytical Tools

Analytical tools or analysis tools help one to get into a conclusion or results from the data collected. Analytical tools can be applied for simple data sets and also in the case of big data analytics.