نقطتان (2)*The value ofinductance of the coilis dependent onthe area within the coil Othe length OOthe permeability of the corematerialto the number of turns of wirein the coilOall of above O

Inductance of the coil is given by : L=μN2Al Here, μ is magnetic permeability N is number of turns…

Answered: نقطت * The value of inductance of the…

Engineering

Electrical Engineering

نقطت * The value of inductance of the coil is dependent on

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter3: Power Transformers

Section: Chapter Questions

Problem 3.7MCQ: Consider Figure 3.5. Match the following, those on the left to those on the right. (i) Im (a)...

See similar textbooks

Related questions

Q: 03: (a) For the bandpass filter shown in Fig. Q3, calculate foff ₂ Q and B. (b) in the input voltage…

Q: illustrates the piecewise linear approximation of the I-V characteristics

Q: The speed of light in a vacuum is O 1x10^8 m/s O 3x10^8 m/s O 5x10^8 m/s O 6x10^8 m/s

Q: Apply the method of partial fractions to the following equation and choose the correct answer I(s) =…

A: To apply the method of partial fraction of the following equation

Q: Consider the following non-linear device which has two linear segments in its IV characteristics: I…

Q: The parameters that are mainly used in * electronics circuits are. Z Parameters Y Parameters H…

A: In this question we will write about two port parameters....

Q: Write down the equation for 12 R₂ R₁ www I₁ 13 1/joc V₂ joLi -0000 jout 12 elle jwL2

A: In this question We need to write the equation for current I2 In this circuit, Mutual inductance…

Q: Given: R1 = 2 kQ2 R2 = 1.3 kQ R3 = 5.8kQE = 12 V D1: Si, rB = 3 Q, rR = 225 kQ D2: Si, rB = 40, rR =…

A: Given data, R1=2kΩR2=1.3kΩR3=5.8kΩE=12kΩ

Q: FET Construction 1. In the depletion type MOSFET there are two modes of operation : 1 2 2. In an…

A: Since you have posted the multiple questions so we are supposed to answer 3 questions only.

Q: Given the circuit as shown, what is the expected approximate output dc voltage (Vout) if diode D1 is…

A: It is given that: Vrms=12 VVmax=122V

Q: Q1: For the circuit shown in Figure below. Draw the s-domain equivalent, then use the mesh-current…

Q: A 440 V, 3-phase, 10 pole and 50 Hz synchronous motor delivering a torque of 50/m Nm. Delivers a…

A: The toque of the synchronous motor is given by the expression as shown below:…

Q: Q2: B: In PCM system, the output signal to quantization ratio is to be hold to a minimum of 25 dB.…

A: We need to find out number of levels

Q: Find the voltage vo(t) in the circuit of Fig. by means of the Laplace transform.

A: For the circuit given as follows- The s-domain circuit is drawn as shown below-

Q: aranteed availability of AWS S3 is __

A: AWS S3 : AWS S3 is known as amazon simple storage service which main function is to store the object…

Q: Problem • Given the op-amp configuration, determin the value of R, required to produce a close loop…

Q: Problem: A certain rectifier filter produces a dc output voltage of 75 V with a peak-to-peak ripple…

A: In this question We need to determine the ripple factor We know Ripple factor = ∆V/Vdc Where ∆V…

Q: 16.35 Obtain the transfer function H(s) = V/V, for the circuit of Fig. 16.65. VS + 0.5 F 1 H m 2i 3…

Q: Compare the motor action with generater action principle.

A: Comparision of the motor action with generater action.

Q: Which configuration will have a zero electric field at the origin? * 2q 5q -3q 3q 2 5q 3q 2q 3 5q…

A: Electric field : Coulomb's law can be determine to calculate the electric field of a point charge,…

Q: The H Parameters for the circuit shown * is O O www 50 Ω 3001₁ 1₂ h11= 75 Ohm, h12= 0 Ohm, h21= 200…

A: We need to find h parameters for given circuit

Q: The waveforms shown below are V₁ and Vo of a schmitt trigger circuit. From these waveforms the…

A: The Given waveforms the values of the two comparison voltage V1 and V2 To Schmitt trigger circuit Vi…

Q: Appling the histogram equalization on an image, converts that image to high blurring image. O True O…

A: Basic Image processing tools in Image Interpolation Filter Sampling Histogram Equalization

Q: he logic function realized by the circuit below is X= テー DI T cont AK B 3-5 X

Q: For the automobile ignition circuit shown, R-502, Vs=12V, L=7mH switch takes us to open. The voltage…

Q: In a Two port network analysis, if the output port is short circuit, we will put a in the input port…

A: In this answer we will find the solutions to the above two questions by using the concepts of…

Q: Given the discrete time system : Check: 1. Linearity. 2. Shift invariance. 3. Stability. y[n] = sin…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: The H Parar is

Q: What is the power rating (in kW) of a device which has a resistance of 150 ohms and draws 6Amps of…

A: Given: Resistance R = 150 ohms Current I = 6A We need to determine power rating of…

Q: Fig 7. Shows the circuit diagram which a student used in the implementation

Q: Please show solution 2. Find the inverse Fourier transform of the following signals. (a) X(jw) =…

Q: 11. These limits are set by the geographic coordinates of the Earth station and antenna e about the…

A: The geostationary satellites are those satellites which revolve the earth in a geosynchronous orbit.…

Q: Explain the oprating principle of synchronous machines

A: synchronous machines - Synchronous Machine constitutes of both synchronous motors as well as…

Q: b) Derive the formula for total voltage and impedance for series RC circuit. Find the equation of…

A: Circuit diagram of series RC circuit is given by,

Q: Inverse Laplace Transformation: s² +9s +2 ¹(s − 1)²(s + 3) - Find 2-¹[7

A: The formulae used is provided below.

Q: A 12- bit ADC has an input range of 0 to 5 V. What will be the maximum percentage quantisation error…

Q: HW: Use Gauss Elimination method to solve the following systems of linear equations. (i) x + 2y + 3z…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Michael is designing a motor driver for a wheeled mobile robot.

Q: E1 2Volt 싸 |R1=2 Ohm Q3: Find the value of the current passing through the resistance R2 using the…

A: We need to find out the current for given circuit

Q: H. W iew is d 1- Determine the transfer function of Figure 1 ei(t) Ans C. 11 mm R₁ i C₂ e(t) R-JXc…

Q: One of the applications of the mutual inductance is Wireless Charging of Electrical Vehicles O…

A: Application of mutual inductance is

Q: H.W. Consider the following sys. find the of this network. R Jo (s) ; (s) ? Via) с

Q: 1. Let us assume that two homogeneous, isotropic di electric mediums with dielectric constants=3 and…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: A germanium diode carries a current of 1 mA at room temperature when a forward bias of 0.15v is…

A: In this question, We need to calculate the reverse saturation current at the room temperature? We…

Q: The antenna of transmitter device has been design with antenna gain 2dB transmits the power 500mw at…

A: We need to find received power for given system

Q: What is the unit impulse response of the system shown in figure for t≥ 0? R(s) 1 (s + 1) 1. S C(s)

A: Given system: Unit impulse response, ht=? for, t≥0

Q: The total inductance for the following three coupled coils is 13 10 12 O 11 m 7H 4 H 2 H m 8 H 5 H…

A: When current enter or exist at the same polarity Leq=L1+L2+2M When current enter or exist at the…

Q: Find the F.I of The following signal Danlity X(t) = A sinc (2Bt) X(t) = ²X (B₂ X(t)

Q: The Final value of the voltage of capacitor for t>O is t = 0 50V 1 O 25V O 20V O 30V O 50V +1 1 + 2…

Q: (s) 2- obtain the transfer function V₂CS for Figure (2) Vi (s) Ans= i C HH on line R₂² b 13 Figure…

A: Note Capacitive reactance inversely proportional to the frequency ( 1/cs) Inductive reactance is…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

نقطتان (2)
*
The value of
inductance of the coil
is dependent on
the area within the coil O
the length O
O
the permeability of the core
material
to the number of turns of wire
in the coil
O
all of above O

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

b) A certain winding made up of copper has a resistance of 100 Q at room temperature. If resistance temperature coefficient of copper at 0 C° is 0.00428/C°, calculate the winding resistance if temperature is increased to 45 C°. Assume room temperature as 25 C°.
The principle operation of LVDT is based on the variation of Select one a. Self inductance b. Reluctance c. Mutual inductance d. Permanence
Consider Figure 3.5. Match the following, those on the left to those on the right. (i) Im (a) Exciting current (ii) Ic (b) Magnetizing Current (iii) Ie (c) core loss current
You are working as an electrician in a large steel manufacturing plant, and you are in the process of doing preventive maintenance on a large DC generator. You have megged both the series and shunt field windings and found that each has over 10 M to ground. Your ohmmeter, however, indicates a resistance of 1.5 across terminals S1andS2. The ohmmeter indicates a resistance of 225 between terminals F1andF2. Are these readings normal for this type machine, or is there a likely problem? Explain your answer.
A snubber circuit has snubber time constant (10 msec), voltage source (10 kV), discharge current of the Thyristor (5 µA) and frequency (50 Hz). Find the rate of voltage changing with time and snubber circuit power losses?
What are the two necessary conditions for a thyristor to begin conduction?and Once a thyristor begins to conduct, what condition(s) is necessary to cease conduction? Also, why is the conduction angle greater with an inductive load than with a purely resistive load?
The compensating winding carrying the current parallel path armature current O field current O none of the above
A certain laminated core has a permeability of 2,500. The length is 5.5 cm and the cross section is 2.1 sq. cm. What is its reluctance? Draw the diagram for the question
4. With reference to the Paschen curve below, Breakdown voltage (V) 60 55 50 45 40 35 30 0.5 1.0 1.5 2.0 2.5 3.0 3.5 4.0 pd (cm-torr) If a discharge at p = 0.1 torr, d = 20 cm is to be initiated, what is the voltage required to cause a breakdown? What will be the breakdown voltage if p = 0.025 torr, d= 20 cm?
Explain the operation of a full subtractor with necessary diagrams. What is the differencebetween half and full subtractor?
Need help with finding paramters
DETERMINE AND LABEL THE LOOPS. Solve the missing values of electric currents using Kirchhoff's laws. FInd the value of electric current flowing in and out of junction b