Q: Please show steps, thanks.
A: We have PV = nRTIf volume remains constant, then P∝T So , PiPf=TiTfFinal absolute pressure…
Q: Suppose a 175 kg motorcycle is heading toward a hill at a speed of 34 m/s. The two wheels weigh 12…
A: The objective of the question is to find out how high the motorcycle can coast up the hill without…
Q: Find the energy of the photon emitted when an electron drops from the n=18 state to the n=2 state in…
A: Step 1:Given data:The initial energy level is n1=18The final energy level is n2=2The Rydberg…
Q: A. Two balls move as shown in the figure. (Figure 1) What is the speed of ball 1 in a referece frame…
A:
Q: Suppose 1.00x10^2 moles of monatomic ideal gas undergoes an isothermal expansion as shown (vertical:…
A: I can still help you solve the problem of finding the work done by the gas during an isothermal…
Q: Don't provide hand writing solution
A:
Q: A bullet of mass m = 8.00 g is fired into a block of mass M = 270 g that is initially at rest at the…
A:
Q: 2. &=3.00 V, &= 1.00 V, R₁ = 4.00 £2, R2 = 2.00 2, R3 = 5.00 £2, and both batteries are ideal. What…
A: The objective of the question is to find the rate at which energy is dissipated in resistors R1, R2,…
Q: 2. A 75 N force is applied at an angle of 60° from the horizontal to the handle of a shopping cart…
A: Given the following data:F=75NAngle θ=60oHorizontal Component of the force:Fx=cos60oVertical…
Q: A car of mass 1670kg initially at a speed of 80 km/m crushes into a wall, if the accident lasted for…
A:
Q: A long solenoid with a axa square cross section has n turns per length sits iwth a vertical central…
A: The mutual inductance between the long solenoid and the flat circular coil can be found by…
Q: Determine two force members first. Two blocks are each pin connected to a massless horizontal link.…
A: The objective of the question is to find the largest force P that can be applied before motion…
Q: Plastic beads can often carry a small charge and therefore can generate electric fields. Three beads…
A: Step 1:The sum of the charges of q1 and q2is −8.3μCThe net charge of all the three beads is…
Q: The diagram shows a loud speaker. The speaker consists of several parts: a strong permanent magnet…
A: Since the voice coil is carrying a current, it experiences a force due to the interaction between…
Q: Which wavelengths in the visible light spectrum will be reflected brightly by free standing thin…
A: The objective of the question is to determine which wavelengths in the visible light spectrum will…
Q: Part A A subatomic particle moves through the laboratory at 0.90 c. Laboratory experimenters measure…
A:
Q: Don't provide hand writing solution
A: The objective of the question is to find the speed of the block just after the collision and the…
Q: Light of wavelength 0.61 μm passed through two slits separated by distance d=2.2 μm and creates an…
A: Given wavelength of the wave (λ) = 0.61 μm slit separation (d) = 2.2 μmdistance from screen to…
Q: A point with mass m is a distance d from the end of a bar, which we'll call x = 0. The…
A: The objective of the question is to find the force at x = 0. The force is due to the gravitational…
Q: Scenario 2: Hospital MRI scan • Operating personnel must wear the standard clothing and footwear…
A: Absolutely, let's delve deeper into the reasons behind the MRI safety protocols you described:…
Q: What is the thinnest soap film (excluding the case of zero thickness) that appears black when…
A: Using the concept of destructive interference, we want the two reflected rays to interact…
Q: The component of the external magnetic field along the central axis of a 50 turn coil of radius 40.0…
A: Approach to solving the question: Detailed explanation:Examples: Key references:
Q: Can you help with this question? thanks ahead of time.
A:
Q: Two blocks connected by a string are pulled across a horizontal surface by a force applied to one of…
A: Approach to solving the question: Detailed explanation: Examples: Key references:
Q: A 15 olhm resistor, a 25 microF capacitor, a 19 mH inductor and an AC volte source are connected in…
A: To find the frequency at which the current is maximum and its maximum value, we can use the concept…
Q: A uniform thin rod of length 0.17 m and mass 4.5 kg can rotate in a horizontal plane about a…
A: The objective of this question is to find the speed of the bullet just before it hits the rod. This…
Q: Don't provide hand writing solution
A: Approach to solving the question: Step 1: Identify the given information: - Diameter of the water…
Q: Consider the two-sided chamber shown, where the right half has a volume of V = 490 L and the left…
A: The objective of the question is to find the new pressure of the gas in the chamber after the seal…
Q: A ww R Switch B 0000 L HH Vo C
A: The objective of the question is to understand the effect of the electromotive force (emf) of a…
Q: Determine the angular momentum of a 78-g particle about the origin of coordinates when the particle…
A:
Q: Don't provide hand writing solution
A: Step 1:The beat frequency is:fL=2Hz SPEED OF SOUND AT 30 DEGREE CENTIGRADE IS 349.08M/SEC Fs =445…
Q: For a circular velocity profile of the type (r) = ar¹/9, where a is a constant and r is the radial…
A: Step 1: Step 2: Step 3: Step 4:
Q: 4. A pipe strut BC is loaded and supported as shown. The strut has a uniform cross section and a…
A:
Q: A conducting massive sphere of radius a is surrounded by a thin conducting spherical shell of radius…
A:
Q: At time t = 0, an RC circuit consists of a 17.0-V emf device, a 54.0-Q resistor, and a 152.0-μF…
A: ANSWER : ( a ) ANSWER : ( b ) Whent=0.5τ Whent=2τ Whent=4τ
Q: A 210 g ball is dropped from a height of 2.3 m and bounces on a hard floor. The force on the ball…
A: Approach to solving the question: Detailed explanation:Examples: Key references:
Q: Hemoglobin has a molecular mass of 64 500 u. Find the mass (in kg) of 598 molecules of hemoglobin.…
A: The objective of the question is to find the mass of 598 molecules of hemoglobin in kilograms.…
Q: = A small block of mass m. = 0.540 kg is released from rest at the top of a frictionless,…
A: Approach to solving the question: Detailed explanation: Examples: Key references:
Q: A hairdryer with a resistance of 30 ohms is plugged into 120 V socket if the hairdryer is used for…
A: The objective of this question is to calculate the amount of electrical energy used by a hairdryer…
Q: Help :,) I can’t seem to figure out what’s going on here, an explanation to this problem would help…
A:
Q: Common speech often uses the term "work" to refer to situations where, according to the physics…
A: According to physics, work is said to be done when a particular force applied to some body produces…
Q: Two springs are attached side by side to a box of mass Mas shown in the figure. The springs have…
A: The objective of the question is to find an expression for the period of motion of a box attached to…
Q: Don't provide hand writing solution
A: The objective of this question is to find the acceleration of the blocks and the tension in the cord…
Q: An object at rest on a flat, horizontal surface explodes into two fragments, onewith mass 100g, the…
A: The objective of the question is to find out how far the lighter fragment slides after the…
Q: The gauge pressure in your car tires is 2.55 × 105 Pa at a temperature of 35.0°C when you drive it…
A:
Q: Calculate the orbital Bohr radius in nanometers of the n=8 excited state in a hydrogen atom. Give…
A: According to Bohr's theory , for Hydrogen atom Radius of nth orbit is given by…
Q: Charge Q acts as a point charge to create an electric field. Its strength, measured a distance of 30…
A: The objective of the question is to find the electric field strength at a distance of 30 cm away…
Q: A 1 cm tall object is 20 cm in front of a convex mirror that has a -60 cm focallength. Calculate the…
A:
Q: The drawing shows three identical rods (A, B, and C) moving in different planes. A constant magnetic…
A: A: The emf is zero because the velocity of the rod is parallel to the direction of the magnetic…
Q: 2. A student makes the following measurements in the lab: x 2.51 ± 0.01 cm y = 1.0592 ± 0.0005 cm z…
A: Measurements and Uncertainties:x = 2.51 cm ± 0.01 cmy = 1.0592 cm ± 0.0005 cmz = 4.939 cm ± 0.002…
Step by step
Solved in 2 steps with 4 images
- Question 20 Convert 104 mm into cm Paragraph V B I U A Lato (Recom... v 19px... ✓ T Question 214 Convert 962 cm into km EQ C + v www 5 11.Given IDSS=12 mA and ?? = − 4.5 ?, (i) Determine ID at VGS =-2 and -3.6 V (ii) Determine VGSfor for ID = 3mA and 5.5 mAA sled and rider, weighing 30 lb and 150 lb, respectively, travel down a smooth slope that has the shape shown. If the rider does not hold on to the sides of the sled, determine the normal force which he exerts on the sled when the sled is (a) at point B, where it has a velocity of 15 ft/s, and (b) at some point C in mid air.
- 2.50x10^5 x 2.5 in calcu 625,000 but in your answer is 1.25x10^3N = 125KN pls give a explanation for thatIn the system shown, suppose the block has a mass of 2.7kg, the spring has a force constant of 480 N/m, and the coefficient of kinetic friction between the block and the floor is 0.16. a) Find the work done on the block by the spring and by friction as the block is moved from point A to point B along path 2. B) Find the work done on the block by the spring and by friction if the block is moved directly from point A to point B.x(t) = 3.00t²e-0.5t