Pair up the correct descriptions with the codes written in Sketch for Arduino : void setup () A. Run setup and set pin 13 to be an output B, Run loop repetitively C Set pin 13 to high (LED on) pinMode (13, OUTPUT); D. Delay for half a second, and then Set pin 13 to low (LED off) E. Delay for a full second : Void loop 0 F. Complete one iteration of the loop, and run it again G. Delay for 500 seconds, and then Set pin 13 to low (LED off) H. Run loop once : digitalWrite (13, HIGH); e delay (500): digitalWrite (13, Low): delay (1000);
Pair up the correct descriptions with the codes written in Sketch for Arduino : void setup () A. Run setup and set pin 13 to be an output B, Run loop repetitively C Set pin 13 to high (LED on) pinMode (13, OUTPUT); D. Delay for half a second, and then Set pin 13 to low (LED off) E. Delay for a full second : Void loop 0 F. Complete one iteration of the loop, and run it again G. Delay for 500 seconds, and then Set pin 13 to low (LED off) H. Run loop once : digitalWrite (13, HIGH); e delay (500): digitalWrite (13, Low): delay (1000);
Chapter22: Sequence Control
Section: Chapter Questions
Problem 1SQ: Describe what is meant by sequence control.
Related questions
Question
Expert Solution
This question has been solved!
Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.
This is a popular solution!
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 1 images
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.Recommended textbooks for you