Problem 184: EE The total inductance of two coils, A and B when connected in series aiding is 0,5 H and 0.2 H when connected in series opposing. Coil A when isolated from coil B has a self-inductance of 0.2 H. Calculate the self-inductance of coil B. ard A. 0.16 H В. 0.12 Н C. 0.20 H D. 0.15 H

Q: 20 V Si 10 2 20 2

A:

Q: Upload answer sheets i) With a neat sketch explain the construction and operation of a Moving coil i...

A: Since you have asked multiple question ,we will slove the first question for you .If you want any sp...

Q: Charge Q=18 nC is located at the origin in free space. Determine the electric field intensity at poi...

A:

Q: 1. You wish to design an FIR filter to approximate a desired amplitude response given by { S 1, 0< |...

A:

Q: D1 2 4 2V R1 V1 2.5k2 10V 1kHz 3 0° +

A:

Q: 12. A copper wire of diameter 1 cm had a resistance of 0.15 Q. It was drawn under pressure so that i...

A: Resistance: It is a material that resists the flow of current and its unit is the ohm.

Q: Please answer quickly thank you. Draw the waveform in a graph of a voltage with a peak voltage of 15...

A:

Q: 4.87 O Consider the circuit of Fig. P4.39 with R1 = 10k2. The diodes have turn-on voltages of Vf = R...

A: According to the question, for the given as shown below We need to find (a) Smallest value of V1 an...

Q: Get the impedance. Explain each step.

A: We have to find the impedance of the circuit 

Q: ree-phase lines: • Load 1: Delta-connected, 500KVA at 0.85 lagging Load 2: Wye-connected, 75KVA at u...

A: Given that utility feeder=5milesVL=4.16kV

Q: Please help me answer this problem. Choose the correct answer from the given choices. NOTE: Show you...

A: 15) POWER RATING P = 60W VOLTAGE V=230V RESISTANCE R=V^2/P = 230*230/60 = 881.667 ohms at 2000 degre...

Q: Question 1: A single-tone conventional amplitude modulation (AM) signal is given by u(t) = cos(2n x ...

A:

Q: 5. In a Haynes-Shockley experiment, maximum amplitude of minority carriers at ti = 100 µs and at t2 ...

A:

Q: benefits of organic light-emitting diode (OLED) screens over LCD panels

A: THE BENEFITS OF OLED OVER LCD ARE 1)LOW POWER CONSUMPTION THE OLED CONSUMES LESS POWER COMPARED TO L...

Q: 17. If in the circuit shown in below, the reading on the voltmeter is 5 V and the reading on the amm...

A: Answer of question number 17 from given circuit voltmeter reading or voltage across the resistance =...

Q: Q1.Find the center and radius of the sphere x2 + y2 + z2 + 4x - 4z = 0? Q2. Find the angle bca of th...

A:

Q: design a circuit that would be able to shift bits but also store them for a duration of time. explai...

A: A shift register is a form of digital circuit that employs a cascade of flip-flops, with each flip-o...

Q: (b) A circuit is connected as shown in Figure Q1(b). If a voltmeter is used to measure the voltage d...

A: In this question,  We need to calculate the value of internal resistance of voltmeter R  If relative...

Q: The stationary windings or magnets of a DC motor are called the

A: In the DC motor, there are stationary windings are also called magnet of the DC motor. 

Q: Find the equivalent resistance between terminals a and b R3 a 30 k. R2 R5 ' 90 kΩ 50 kſ. 75 45 kN b ...

A:

Q: For a silicon pn junction with T = 300 K, determine the diode current. The Is (reverse saturation cu...

A:

Q: Charge Q=20 μC is located at the origin in free space. Determine the flux density at point (2, -1, -...

A:

Q: Calculate the voltage on the secondaty side: Given: Number of turns on the secondary side is 3000 tu...

A:

Q: In the circuit in the figure below, determine the following. 40.0 V 360 V - 80.0 V 200 N 80.0 Ω Σ 20...

A:

Q: 43. Using Thevenin's theorem, find the current in 10 Q resistor in the circuit shown. * 40 Ω 60 Ω 12...

A:

Q: The following forces act on the particle P: Fi = 2a, + 3a, – 5az. F2 %3D — 5а, + а, + За, Fз — а, — ...

A: We need to find resultant vector and we need to find out magnitude of resultant vector

Q: 3. A 120KVA, 0.65 lag pf is connected in parallel to a 150KW, 0.8 lead pf and to 300KVA, 120KVAR ind...

A: First find the active and reactive power each load and than find total total active and reactive pow...

Q: Given the scalar field defined by Ø(x, y, z) = 3x²z – xy% + 5 find Ø at the points: Match each item ...

A: This question belongs to basic electrical . It is based on Cartesian coordinate system . It is based...

Q: A two-pole Y-connected synchronous generator has a voltage level of 2300 V, a capacity of 1000 kVA, ...

A: Given P=2 V=2300 V S=1000 kVA pf=0.8 lagging Ra=0.15 Ω Xa=1.1  Ω f=50 Hz PFW=24 kW Pcore=18 kW

Q: The diameter of a given bare conductor is 0.50inch . A thermoplastic insulation with thickness of 0....

A: Given data: The diameter of a given bare conductor, d = 0.50 inch                                   ...

Q: On a three phase 480/277V system the color typically used to identify phase X(A) is

A: Wire Color Standards for 277/480 Volts These high-voltage connectors can be found in a variety of ma...

Q: Evaluate the following items below, if Z1 = -1 + I, and Z2 = 2 – 3i, (a). 2Z1 + 4Z2 (b). Z1Z2 (c). 3...

A: Using general rule of adding real and imaginary parts individually find the unknown values.

Q: 2 the Tx 2 3

A:

Q: Given the scalar field defined by Ø(x, y, z) = 4y2° + 3xyz – 2 + 2 Find: - Match each item to a choi...

A: We need to find out value of function for given x, y, z .

Q: When a 1 2 resistor is placed across a and b what is the current thru it? 20 3 3Ω ξ a b 150 V = 20 2...

A:

Q: Laplace Transform method,

A: For the two system as cascaded- In time domain- Ht=h1t*h2t In s domain- Hs=h1s.h2s

Q: Determine the value of the voltage V0 using mesh analysis

A:

Q: Identify the proper plot violations in the theoretical plot below. Plot List all violations 1.600.00...

A: Plot-  Plot is generally define as a graph or a pattern which shows the relation between the two par...

Q: 14. The resistance of the field coils of a dynamo is 173 Q at 16 deg C. After working for 6 hours on...

A: The solution is given below

Q: c. Amplitude spectrum of x(n) for 0 <= n <= 1 with x(0) = 1, x(1) = 1 is Ak with AO = 2, A1 = 0. %3D...

A: (c) Amplitude spectrum of x(n) for 0 &lt;= n &lt;= 1 with x(0) = 1, x(1) = 1 is Ak with A0 = 2, A1 =...

Q: Given the two pointsA(2,3,-1) and B(4,250, 1200). Find the spherical coordinates of A and Cartesian ...

A: Given that Two point A and B A(2,3,-1) B(4,250,1200)

Q: resistor. 0.3 A upward 0.5 A upward 0.5 A downward 0.3 A downward

A: Answer of question no. 35 We find current in every branch by using nodal analysis. Nodal analysis st...

Q: Direction. Answer each problem and show your solutions cleanly and clearly. Draw circuit diagrams. P...

A: In transformers by using transformation ratio we can get the required solution. And these ratios are...

Q: Find the current on RL using Thevenin method

A: Find the current on RL using Thevenin method

Q: A three phase, 4 - pole, 50 Hz induction motor has full load speed of 1455 rpm. What will be the fre...

A:

Q: A 120 V electrical outlet with 4 A of current flowing from it has a power value of O 480 W O 48 W 24...

A:

Q: Example 2: calculate the RMS noise voltage arising from thermal noise in two resistors 100 & 150 res...

A:

Q: 1. How much current is flowing in a circuit where 1.27 x 10^15 electrons move past a given point in ...

A: Current is defined as the rate of change of the charge across the conductor. The total charge corres...

Q: The cylindrical surface ρ = 6 cm contains the surface charge density ρs = 10e-10 IzI nC/m2. a.) What...

A:

Q: 3) A potential divider is used to provide an output voltage Vo from a 10 V supply as shown below. Th...

A:

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.