ّ Q1g. In the circuit shown below, all resistors have thethe 25 V voltage source is 400 mA, the current flowing through the 10 V voltage source is 300 mA,and the current flowing through R2 is 100 mA. What is the resistance of the resistors?(A) 33 Q(B) 50 Q(C) 100(D) 200 £2(E) 300 Q(F) None of the above.

Answered: Image /qna-images/answer/22cf8b31-3ee2-4269-bc71-f1e28e3a84b7.jpg

Q1g. In the circuit shown below, all resistors have the 25 V voltage source is 400 mA, the current flowing through the 10 V voltage source is 300 MIDA, and the current flowing through R2 is 100 mA. What is the resistance of the resistors? (A) 33 Q (B) 50 Q 25V (C) 100 Q (D) 200 £2 (E) 300 Q 10V (F) None of the above.

Q1g. In the circuit shown below, all resistors have the 25 V voltage source is 400 mA, the current flowing through the 10 V voltage source is 300 MIDA, and the current flowing through R2 is 100 mA. What is the resistance of the resistors? (A) 33 Q (B) 50 Q 25V (C) 100 Q (D) 200 £2 (E) 300 Q 10V (F) None of the above.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Two resistors (R1 and R2) are used to build two circuits, one in series and the other in parallel. When connected inseries with a battery of 8,0 V; you read the voltage in R1as 2,0 V with a multimeter. When connected in parallel, you read the current in R2as 1,5A. Find the values for the two unknown resistors.
The three series resistors R1,R2 and R3, what is the value of resistor R1 if voltage V1=25 V and total resistance equal 15 ohm and total voltages equal 50 V. A. 7 ohm B. 6.5 ohm C. 7.5 ohm
Two resistors R1 and R2 of 12 Q and 6 N are connected in parallel and this combination is connected in series with a 6.25 Q resistance R3 and a battery which has an internal resistance (in series with the battery e.m.f.) of 0.25 2. Determine the e.m.f. of the battery. (note: the current through 6 ohms is 0.8 A)
In the circuit, Determine: a. the total resistance (R7) of the circuit in kl. (. . places for the final answer) b. the current flowing in mA for each of the resistors, R1, R2, R3 and R4 ( use 2 decimal places for the 12V final answer) c. the voltage in V across each of the resistors, R1, R2, R3 and R4 ( use 2 decimal places for the ; use 2 decimal R = 3000 R3 = 4000 R2 = 1000 R4 = 1ka %3! final answer)
With the switch in the circuit of Figure a open, there is no current in R2. There is current in R1, however, and it is measured with the ammeter at the right side of the circuit. If the switch is closed (Figure b), there is current in R2. What happens to the reading on the ammeter when the switch is closed? a) The reading increases; b) The reading decreases; c) The reading does not change.
A 12.1-mA current flows through a 10 percent, 2.7-k2 resistor. What range must the resistor voltage be in?
Draw the flow of current for the given circuit and discuss thouroughly how the five voltage drop are develop across each resistors. E2 R4 R2 R3 R1 E1
A 25mv, 2mA dArsonval movement is to be used in voltmeter whose full scale reading is 100v. The resistance inserted by 100v meter into circuit is Select one: a. 1 x 106 ohm b. None of all c. 1 x 104 ohm d. 1 x 105 ohm e. 1 x 103 ohm
Resistor R2 has a resistance of 220 ohm and a voltage drop of 44 v. What is the current flow through resistor R3
The circuit shown Figure has a current of 2.5 mA. Find the following quantities: a. The total resistance of the circuit. R 3.3 k E-45 V b. The value of the unknown resistance, R2. c. The voltage drop across each resistor in the circuit. d. The power dissipated by each resistor in the circuit. R2 1- 2.5 mA R3- 5.6 ka
The circuit shown Figure has a current of 25 mA Find the following quantities a. The total resistance of the circuit. b. The value of the unknown resistance, R2. c. The voltage drop across each resistor in the circuit d. The power dissipated by each resistor in the circuit. E-45 V
Two resistors R1=100 Ohm and R2=100 Ohm (parallel connection) are connected in series with a battery 3V. The current in each resistor is: Select one: a. 15 milli Ampere b. None of the above c. 7.5 milli Ampere d. 30 milli Ampere