Q2: For the following soil profile and retaining wall condition shown, find the active earth force on the wall and its location. If the groundwater was lowered to 15.0 m, what would be the value of the active force on the wall? (Assume the total unit weight of soil after groundwater lowering is 20.0 kN/m³). 9-50.0 kPa H-10.0 m Sandy soil kN m² Year 20 @=30.0⁰ 8=0.0 - 00 e,-0.676 17.78%

Q2: For the following soil profile and retaining wall condition shown, find the active earth force on the wall and its location. If the groundwater was lowered to 15.0 m, what would be the value of the active force on the wall? (Assume the total unit weight of soil after groundwater lowering is 20.0 kN/m³). 9-50.0 kPa H-10.0 m Sandy soil kN m² Year 20 @=30.0⁰ 8=0.0 - 00 e,-0.676 17.78%

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter8: Stresses In A Soil Mass

Section: Chapter Questions

Problem 8.13P

See similar textbooks

Similar questions

What is the equivalent coefficient of permeability (k) for soil layers of k2 and k3? where k2= 1.03 k1 and k3= 2.45 k1 82 O HA 10 K2 N KS N С KA D Z! k1 1.740 .b k1 3.480 .C k1 17.400 .d k1 8.700
What is the equivalent coefficient of permeability (k) for all soil layers? where equivalent k(2 and 3) = 4.58 k1 and k4 = 4.23 k1 10 8 IB D K2 N K3 N K1 K4 .a k1 2.738 .b k1 44.050 .C k1 3.568 .d k1 2.382 28
What is the equivalent coefficient of permeability (k) for soil layers of k2 and k3? where k2= 1.03 k1 and k3 = 2.45 k1 6 10 8 D. K2 N K3 N K1 K4 .a k1 1.740 .b k1 3.480 .C k1 17.400 .d k1 8.700 28 12
3500 kN 3 m x 3 m 0.6 m Ya = 17.5 kN/m³ Sand 0.6 m GWT Sand Ysat = 18.3 kN/m3 1.2 m Y sat = 17.1 kN/m³ C, = 0.06 Clay 1.2 m e, = 1.4 Cc = 0.38 %3D
Plz give the correct answer. Compute the intensities of active and passive earth pressure at depth of 8 m in dry cohesionless sand with an angle of internal friction of 30 degrees , and unit weight of 18kN / (m ^ 3) What will be the intensities of active and passive pressure if the water level rises to the level? Take the saturated unit weight of sand as 22kN / (m ^ 3) .
the soil profil shwon in figure BI below.determine total and effective vertical stresses and powr water Pressure at Points A, B, and C. For the soil 3m 4m 6m I Sand A5=2167 €=0.69 B C w=9% Silt Gs =2170 = 2₁70 e=0.60 clay = 2.72 @= 0.5 G₁ 5 = 70%
Calculate the settlement of the 10-ft-thick clay layer that will result from the load carried by a 5-ft-square footing. The clay is normally consolidated. Use the 2:1 method to calculate the average increase of effective pressure in the clay layer. 10 ft 10 ft 10 ft 5 ft ↓ Dry sand Footing size 5 ft x 5ft Sand Clay Ydry = 100 pcf Groundwater table Ysat = 120 pcf Ysat = 110 pcf % = 1.0 LL=40
Scenario The wall footing at right is to be constructed to carry an inclined load at 85 degrees with the horizontal, as shown. Assume that there is impenetrable bedrock below the Sample point shown in the figure. Question #1: Calculate the expected primary settlement of the soil at the Sample point. Also, determine the time it will take for 60% of the expected primary settlement to occur. 2.5 m 0.5 m 120 kN/m 2 m y = 17.7 kN/m³ • Sample Cc = 0.190 Cv = 0.5 cm²/day eo = 0.83 Silty clay Question #2: Determine the factor of safety against bearing failure of the soil for the wall footing if qult of the soil is 160 kN/m².
7. Assume the water table drops 3 feet for the soil profile shown. What settlement will occur? Assume the unit weights above the water table for the initial condition will extend downward to the water table at its new position. 14' V Sand, y = 110 lb/ft³ Sand, Ysat 116 lb/ft³ = Cc = 0.25 C₁ = 0.06 e, = 0.9 N.C. clay Ysat = 120 lb/ft³ sand
Why is the passive soil pressure coefficient greater than 1?
Subject Geotechnical engineering : soil mechanics A layer soil shown has the following data H1= 3m. K1= 2x10^-2 cm/sec H2= 4m K2= 3.2x10^-2 cm/sec H3= 6m K3= 4.1 x 10^ -2 cm/sec Compute the equivalent coefficient of permeability in vertical direction. Compute the velocity if h= 4m
Estimate the ratio of the horizontal to the vertical permeability of these four strata. k₁ = 10³cm/sec k₂ = 2x10 cm/sec k3= 10 cm/sec k4= 2x10³ cm/sec H₁ = 3' H₂=3' H3 = 3' H4=3'