Q/Choose the true or false for the following sentences 1-The maximum admittance locus is any line from the origin extended to the last point at the end of the locus (true or false) 2-In order to tune a parallel resonance circuit to a lower frequency, the capacitance must be decreased (true or false) 3-In a series RLC circuit that is operating above the resonant frequency, the current leads the applied voltage. (true or false) | 4-The total current locus is greater then the admittance locus when the applied voltage is equal to one. (true or false)

Q/Choose the true or false for the following sentences 1-The maximum admittance locus is any line from the origin extended to the last point at the end of the locus (true or false) 2-In order to tune a parallel resonance circuit to a lower frequency, the capacitance must be decreased (true or false) 3-In a series RLC circuit that is operating above the resonant frequency, the current leads the applied voltage. (true or false) | 4-The total current locus is greater then the admittance locus when the applied voltage is equal to one. (true or false)

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter23: Resistive-inductive-capacitive Series Circuits

Section: Chapter Questions

Problem 1PA: You are an electrician working in a plant. A series resonant circuit is to be used to produce a high...

See similar textbooks

Similar questions

You are an electrician working in a plant. A series resonant circuit is to be used to produce a high voltage at a frequency of 400 Hz. The inductor has an inductance of 15 mH and a wire resistance of 2 . How much capacitance should be connected in series with the inductor to produce a resonant circuit? The voltage supplied to the circuit is 240 V at 400 Hz. What is the minimum voltage rating of the capacitor?
In the circuit of Figure, the magnitudes of V₁ and V at the resonance are twice L C that of VD. The inductance of the coil for R* 50 Hz is 520⁰ VR www. 502 Vc ell V₁
A series circuit consists of a 120V, 50HZ source, a 300 resistor, a 100mH inductance, and a variable capacitance. Find the capacitance required to create a series resonance condition at this frequency. O 202.8uF 507.12uF O 101.4uF O 676.16uF
The inductance coil in the series resonant circuit is 0.2 H, and the resistance coil is 50 Q. At what capacitance value does resonance occur at 1500 kHz in this circuit? Assuming a 100 V r.m.s. e.m.f. at the source.
A series circuit consists of a reactor of 0.1 henry inductance and 5 ohms resistance and a capacitor of 25.5 μ F capacitance. Find the resonance frequency and the percentage change in the current for a divergence of 1 percent from the resonance frequency. [100 Hz, 1.96% at 99 Hz; 4.2% at 101 Hz]
A tank circuit contains a capacitor and an inductor that produce 30 2 of reactance at the resonant frequency. The inductor has a Q of 15. The voltage of 277V is connected to the circuit. What is the total circuit current of the resonant frequency? Show your work. a) IT= 0.615 A b) IT= 0.423 A c) IT = 0.846 A d) IT= 0.321 A
A series circuit consisting of a 302, resistor and a 4µF capacitor is connected in parallel with a variable inductor. For what value of inductance will the circuit be in resonance if the frequency of the source is 1,200cps?
Eill in the blank with corect answers B Frequency Series Resonance - Impedance vs. Frequency. The graph of impedance against frequency for an RLC series resonance circuit is shown in the picture. At which point the current will be maximum At point A At point C At point B At point D The inner most layer of an optical fhotI Is cantu Impedance
For the circuit shown in figure determine the capacitive reactance at resonance. Vs a) 15 b) 20 c) 25 d) 30
In a series RLC circuit, the applied voltage is 120V. At resonance, the frequency is 200rad/sec, and the circuit current is 6.26 A. What is the resistance of the circuit (in Ohms)? (Use 2 decimal places. Unit is not required.)
Subharmonics are the interharmonics with frequencies lower than the fundamental frequency. True False
Calculate the bandwidth in kHz Blank 1 and an inductor's Q Blank 2 at100MHz. It has an inductance of 6mH and a series resistance of 1.2k2.