Question 19 The primary function of equipment grounding is to protect individuals interacting with an appliance appliances connected on the same circuit the voltage source an individual electrical device Question 20 The U-shaped blade of the plug and the U-shaped hole in the receptacle are the connections. ground neutral hot ungrounded

Question 19 The primary function of equipment grounding is to protect individuals interacting with an appliance appliances connected on the same circuit the voltage source an individual electrical device Question 20 The U-shaped blade of the plug and the U-shaped hole in the receptacle are the connections. ground neutral hot ungrounded

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter20: Special-purpose Outlets For Ranges, Counter-mounted Cooking Unit , And Wall-mounted Oven

Section20.2: Wall-mounted Oven Circuit And Free-standing Range

Problem 12R

See similar textbooks

Similar questions

b) Why Generation Voltage Levels are low in the range of 11 kV/ 33 kV etc? c) Why ACSR Conductors are preferred over Copper Conductors?
What is the minimum trade size PVC conduit to contain 201 #12AWG TW75 Copper conductors.
Which of the following Surge Diverter use non-linear resistances in its fabrication? Rod - Gape SD. Lightning Arrester SD. Expulsion Tube SD. O All of the above.
b. traveler (ti)*) D. Several factors or conditions can cause conductors to overheat, but often overlooked is the possibility A a. induction heating b. ambient temperature C. the size of conductors d. grounding
Which of the following is?are an application of electrimagnets. A) relays, B) generations, C) magnetic cluches, D) all of the above. When using the left hand rule for conductor, the fingers point in the direction of_______. A) the electron flow, B) the field around the conductor, C) both a and b, D) none Upon what does the strength of an air-cored coil depend?A) amount of current flow, B) number of turns, C) permeability of the core, D) all above
Describe the construction and symbol of semi conductor device
h.1. In an alternating-current system, the maximum size for a copper grounding electrode conductor isA. 250 kcmil.B. 3/0.C. 500 kcmil.D. 4/0. h.2. The figure shows a fault condition in an ungrounded electrical system. Which of the following will occurbecause of the fault in this system?A. Only the overcurrent protector at Point A will trip open.B. The ground fault will heavily damage the service.C. Nothing will happen until a second ground fault occurs.D. The overcurrent protection will trip, shutting off all the line side power.
3. With respect to conductor insulation, describe the following location ratings: a. Dry b. Damp c. Wet
3. The three bus-bar conductors in an outdoor sub-station are supplied by units ofpost insulators. Each unit consists of a stack of 3-pin insulators fixed one on the top of the other. The voltage across the lowest insulator is 8-45 kV and that across the next is 7-25 kV. Find the bus-bar voltage of the station. [38-8 kV]
3. What are the classifications of Core Loss and Copper Loss?
13.a. Eddy-current loss in the stator core can be reduced by usingA. alloys with low resistivity.B. annealed iron laminations.C. silicon alloys of copper.D. thin laminations of steel.13.b. Which one of the following is damaging to many insulating materials used in alternators?A. Eddy currentsB. SaturationC. CoronaD. Hysteresis
110 About indistrial piping WHY IS THE ASME 31.3 ALLOWABLE VOLTAGE A COMBINED VOLTAGE?