Questions: 1. You weigh 1.0 gram of protein and dissolve it in 1.0 mL of water to make a stock solution with a concentration of 1 gram / mL (or 1000 mg/ml). la Using your 1g/mL stock solution (Hint: C₁), you wish to make 100mL of a 50 mg/mL solution. (Hint: V2. and C2) How do you make this working solution? What is the DF for this dilution? (Hint: Review how to calculate DF in lab manual.) 100mL of 50mg/mL from 1g/ml stock I 200mL of 0.02mg/mL from 1g/ml stock Volume Stock 200mL of 0.02mg/mL from 100mg/ml stock Final Volume 1b. You also wish to make 200mL of a 0.02 mg/mL solution. (Hint: NEW V2. and C2). Calculate the two different ways to make this solution. Volume Stock D.F. Final Volume D.F.

Questions: 1. You weigh 1.0 gram of protein and dissolve it in 1.0 mL of water to make a stock solution with a concentration of 1 gram / mL (or 1000 mg/ml). la Using your 1g/mL stock solution (Hint: C₁), you wish to make 100mL of a 50 mg/mL solution. (Hint: V2. and C2) How do you make this working solution? What is the DF for this dilution? (Hint: Review how to calculate DF in lab manual.) 100mL of 50mg/mL from 1g/ml stock I 200mL of 0.02mg/mL from 1g/ml stock Volume Stock 200mL of 0.02mg/mL from 100mg/ml stock Final Volume 1b. You also wish to make 200mL of a 0.02 mg/mL solution. (Hint: NEW V2. and C2). Calculate the two different ways to make this solution. Volume Stock D.F. Final Volume D.F.

Curren'S Math For Meds: Dosages & Sol

11th Edition

ISBN:9781305143531

Author:CURREN

Publisher:CURREN

Chapter13: Dimensional Analysis/units Conversion

Section: Chapter Questions

Problem 1.3P

See similar textbooks

Similar questions

Lalculate: You need a digestion buffer consisting of the following: 15 mM NaCI 75 mM Tris-CI, pH 8 16 mM EDTA, pH 8 0.8% sodium dodecyl sulphate O NWU° 83 0.75 mg/mL proteinase K You are supplied with the following: NacI (Mr = 58.443 g/mol) * 2.5 M Tris-CI, pH 8 solution (1 litre) EDTA, sodium salt (Mr = 380.2 g/mol) 10% sodium dodecyl sulphate solution Proteinase K solution (50 mg dissolved in 1 mL dd.H20) How will you prepare 500 mL of the digestion buffer? Show all your steps * and calculations.
. A protein gives, under conditions of buffer composition, pH, and tem- perature that are close to physiological conditions, a molecular weight by sedimentation equilibrium measurements of 140,000 g/mol. When the same protein is studied by SDS gel electrophoresis in the absence or presence of the reducing agent B-mercaptoethanol (BME), the pat- terns seen, respectively, in lanes A and B are observed. Lane C contains standards of molecular weight indicated. From these data, describe the native protein, in terms of the kinds of subunits present, the stoi- chiometry of subunits, and the kinds of bonding (covalent, noncova- lent) existing between subunits. / A B - BME + BME STD Serum albumin, 67,000 Ovalbumin, 43,000 Carbonic anhydrase, 30,000 Trypsin inhibitor, 20,000 10 2. 4. Co cm migrated
Size Size Crude Anion Cation 2) Exclusion Exclusion Lysate Exchange Exchange 1 2 Total Protein Concentration 15.2 6.6 2 3.75 4.7 (mg/mL) Final Sample Volume 60 30 20 4 3 (mL) Enzyme Specific Activity 0.43 1.7 7.25 18.3 12.5 (units/mgprotein) Based on your protein purification sample data, in which of the purification steps in your protocol did you effectively purify your enzyme? Select all that apply. a) anion exchange correct b) cation exchange correct c) size exclusion 1 correct d) size exclusion 2
Protein Solubility 3.5 5.5 5 5 0.068 0.028 Absorbance 0.098 Conc.(mg/ml) 0.195 0.130 0.044 0.9% 2.786% 9.429% 11.3: % solubility 4.179% The above table indicates the concentration of protein in the diluted supernatant and the supernatant before dilution at different pH. Dilution Factor 30 22.5 15 PH 7.5 1.5 4.5 5 0.027 3 0.042 Protein Solubility Versus pH 6.5 6 4.5 pH Value The above figure shows a plot of protein solubility versus pH. 50 7.5 7.5 50 0.032 0.053 8.5 50 0.054 0.100 21.429% 9 Please provide a brief discussion and explanation of the results. (using isoelectric point and net charge to explain)
2. 0.1 mL of a protein solution of concentration of 7 mg/mL was diluted to a total volume of 4.0 mL with water (i.e. 0.1 mL of the solution was added to 3.9 mL of water). 3 mL of this solution was then mixed with 27 mL of water. What is the concentration of the diluted protein solution? Space to show your workings:
5 You need to separate the following three proteins, Protein A (MW 76 600 Da; pI 4.5); Protein B (MW 70 000 Da and pI 8.2) and Protein C (MW 42 000; pI 8.6). Describe what column/s you would use, the pH of the buffer/s you would use, which proteins are retained on the column and how you would elute the bound protein/s. How would you monitor where the protein peaks elute and whether the protein in each peak is pure of not?
MW of LA Volume of NaOH used (ml) x Normality of NaOH x % t.a. (expressed as lactic acid)= 1000 x100 Volume or weight of sample (g or ml) Molecular Weight of Lactic Acid (MW of LA) = 90 g/mol %3D
A protein gives, under conditions of buffer composition, pH, and temperature that are close to physiological conditions, a molecular weight by sedimentation equilibrium measurements of 140,000 g/mol. When the same protein is studied by SDS gel electrophoresis in the absence or presence of the reducing agent β-mercaptoethanol (BME), the patterns seen in lanes A and B respectively are observed. Lane C contains standards of molecular weight indicated. From these data, describe the native protein, in terms of the kinds of subunits present, the stoichiometry of subunits (that is, how many of each subunits are present), and the kinds of bonding (covalent, non-covalent) existing between subunits
Calculate protein concentration in unknown samples 1, 2, 3: Absorbance of Unknown 1 = 0.541 Absorbance of Unknown 2 = 0.85 Absorbance of Unknown 3 = 1.02 Standard Curve: Y = 0.0073x
Given the following information, calculate the total activity in the undiluted protein sample. Activity of 1 ml of diluted sample = 0.5 Total volume of sample = 5 ml Dilution factor = 10 25 50.5 250 2.5
A protein gives, under conditions of buffer composition, pH, and temperaturethat are close to physiological conditions, a molecular weight by size exclusion measurements of 140,000 g/mol. When the same protein is studiedby SDS gel electrophoresis in the absence or presence of the reducing agent β-mercaptoethanol (BME), the patterns seen, respectively, in lanes A and B are observed. Lane C contains standards of molecular weight indicated. From these data, describe the native protein, in terms of the kinds of subunits present, the stoichiometry of subunits, and the kinds of bonding(covalent, noncovalent) existing between subunits.
* Express the strength of a solution in the form of a fraction, a ratio, and a percent if 200 mL of the solution contain 50 mL of a drug. * Express the strength of a solution in the form of a fraction, a ratio, and a percent if 8 mL of the solution contain 3 g of a drug. * How many milliliters of a 0.5% solution contain 4 grams of a drug?