signal of bandwidth 4 kHz is samples at Nyquist rate and transmitted using PCM with uniform quantization. If the number of quantization levels L is increased from 64 to 256. Find the following: The number of bits sample in the old and new PCM systems. The change in SNR measured in dB. (improved or decreased, and by how many times). The transmission bandwidth before and after increasing the quantization levels. Find the percentage of change in the bandwidth.

Q: 4. Find the per unit value for each component and draw the impedance diagram. Y Generator 10 kV 100…

A:

Q: The circuit in the image given below is a differential amplifier driven by a bridge. Find vo. Given…

A: In this question,  We need to determine the output voltage Vo .  We are solving this problem using…

Q: A few cycles at a periodic current waveform and shown in the figure. Determine the effective value…

A:

Q: 1. For the following circuit find the value of the current ID, and the voltage V +8 V 1.2 ΚΩ lp •…

A:

Q: Determine the current across R2. 10 92 www R₁ 5V 0 570mA O 140mA 430mA C wwww 592 R₂ D

A: In this question,  We need to choose the correct option Assume diode is silicon type so forward bias…

Q: 1+ Z 1+ 3 2 ² 1 a) Find XC03, X[1] and [2] if ROC is 121 2) X(2): (6) Find 2003, 25-13 and ROC is…

A:

Q: ure. 2 ΚΩ 4 ΚΩ Μ Use the differential equation approach to find io(t) for t> 0 in the network in t =…

A:

Q: For the circuit given below, determine the value of R which will draw the maximum power and compute…

A: The maximum power will be delivered to the load if the thevenin's equivalent resistance is equal to…

Q: Unsimplified Boolean expression and truth table pls

A:

Q: Find the current taken by a 20μF capacitor when connected to a 220V, 50 Hz supply

A: Given: C=20 μF, Vin=220 V and f=50 Hz. Required: Current.

Q: 4 Find the F.T. of the following Signals using differentiation prop. 2 2 2 2 Ans F(w) = 4(sin²(w) -…

A: In this question we need to find a Fourier transform of the given signal.

Q: 18. Find the sensitivity of T[s] with respect to a, when s² + (1 + a)s +2 s3 + 2as² + 4s + 10a…

A:

Q: Determine the output y[n] = x[n] * h[n] given that input x[n] is applied to an LTI system with…

A:

Q: Determine the Discrete-time Fourier series representation for the sequence below. Show the details…

A:

Q: 4. Determine the total impedance. ZT 202 M 452 WIE -j62 M 3.12 m j42

A:

Q: 2. An analog signal f(t) has the continuous-time Fourier transform F(w) = e-3|w| Find an expression…

A: We need to find out the inverse Fourier transform for given signal .

Q: D 1 0 0 0 1 0 Output D D D Q02 2 3 4 1 0 0 1 0 0 Input 0 1 0 1 0 0 0 00 。。。 0 0 0 1 1 1 0 1 X X

A:

Q: Problem 3: For what emf & does the 2002 resistor in Fig.3 dis- sipate no power? Should the emf be…

A: The given question can be analysed by using the kirchhoff's law and mesh analysis. The power…

Q: 4. What is the equivalent output of a circuit in dBm if it has an output of 10 watts? 5. If four…

A: here we need to convert power from watts to dBm

Q: Find the current taken by a 20μF capacitor when connected to a 220V, 50 Hz supply

A: Capacitance (C) = 20µF Voltage (V) = 220 V Frequency (f) = 50 Hz

Q: 2 At what time is necessary for a current on a series RL dc circuit to reach 83.5 % of the final…

A:

Q: 5. Identify the appropriate name for each terminal. Terminal #1 Terminal #1: Terminal #2: 6. Sketch…

A:

Q: 2. For a causal LTI system described by the following input-output relation. y(n) = 2ay(n − 1) −…

A:

Q: リ Jo 1 J15

A: We need to find out the equivalent impedance and equivalent admittance for given circuit .

Q: To sketch the characteristic curve of the diode you need to vary voltages on diode and measure…

A: The diode will conduct only during the forward bias and it will not conduct during reverse bias. The…

Q: What is the source of transient in electrical circuit / system? Need a simple

A: There are two type of trasients based on the supply voltage: DC transient AC transient

Q: Find the steady-state error when G[s] e(t)=r(t)-y(t). (a) ess = 0.091 (b) ess = 0 (c) ess= (d) A…

A: We need to find out the steady state error for given system .

Q: 15.12 The voltage transfer function for either high-pass prototype filter shown in Fig. P15.12 is…

A: Magnitude scaling increase the impedance by factor while keeping the frequency constant. Frequency…

Q: 4. For the circuit shown in Figure 4, use Kirchhoff's Current Law to write a nodal equation for the…

A:

Q: Q2. Design a digital circuit that indicates via an LED output whether a 4-bit unsigned number is a…

A: The Lucas number is an integer sequence and it is just the complement of Fibonacci number.

Q: 1 A 3.5 H inductor has an internal resistance of 10.5 ohms and is connected in series with 30-ohm…

A: We need to find current for given RL circuit .

Q: B3 A3 B A Cin Full Adder Cout S Cout S3 B₂ A₂ B A Cin Full Adder Cout S S₂ B1 A1 B A Cin Full Adder…

A: From the given figure.... We can see that a combinational circuit consisting of four full adders.

Q: Determine the equivalent inductance and equivalent current of the inductive circuit in Figure Q4. If…

A:

Q: 1. Find i(t) and V.(t) for t>0.

A:

Q: 20. Using superposition, find Vo. 5Ω Μ Μ 4Ω V₂ (+1) 1Ω Μ 3 Ω 9V 3V

A:

Q: Evaluate all answers must be expressed in RECTANGULAR forms, and use 2 decimal places. Use…

A: The required parameters can be obtained by using the mesh current and the mesh current can be…

Q: The activation function in the example is assumed to be linear as f(x) = x. Repeat the example and…

A: We have to drawn update code functionthe given Activation Code function

Q: 1. Consider a continuous-time LTI system with impulse response e-3t, te [2, 4] otherwise h(t) = {…

A:

Q: Find the following given the problem on the left: a. starting line current drawn by this motor at…

A:

Q: A signal g(t) is produced by switching on a continuous-time signal v(t) for a limited time -0.5T ≤ t…

A:

Q: Find the following given the problem on the left: a. output torque of the motor at rated conditions…

A:

Q: Ex:- find the band width (BW) in which 75% of total power contained use in the fig Show below.…

A: Here , lower half power f1= -0.04 Higher half power f2 = 0.04 Resonant frequency f0 =√f1f2

Q: 3. Find v(t) for t>0. 2F + V 12V 352 Xt=0 총 42 12A

A: In this question,  We need to determine the voltage v(t) across the capacitance C as shown the…

Q: Use loss of precision theorem to determine # of bits of significants are lost in the subtraction…

A:

Q: D4 0 Key = Space D3 0 Key = Space D2 0 Key = Space U1A 7404N U2A 7408N U3A 7432N U4A 7432N Q1 O Q2…

A: SOLUTION       FROM THE LOGIC CIRCUIT DIAGRAM  The output of U3A OR…

Q: I a) Design a noninverting amplifier with a gain of 100 using ideal op amps and practical values of…

A:

Q: 4-The following sequence represent one period of a sinusoidal sequence of x[n] = Acos(w。n + p).…

A:

Q: A battery, resistor, capacitor and switch are connected in series to form an RC circuit as shown…

A:

Q: Question 14 For an NMOS FET to be operating in the linear region of the ID-VDS characteristic: Gate…

A: Metal-oxide-semiconductor field-effect transistor is referred to as MOSFET. It has a MOS…

Q: A single phase transmission line is made up of copper wire 400 mils in diameter. How long is the…

A: A single phase transmission line is made up of copper wire 400 mils in diameter. loop resistance…

Quantization and Resolution

Quantization is a methodology of carrying out signal modulation by the process of mapping input values from an infinitely long set of continuous values to a smaller set of finite values. Quantization forms the basic algorithm for lossy compression algorithms and represents a given analog signal into digital signals. In other words, these algorithms form the base of an analog-to-digital converter. Devices that process the algorithm of quantization are known as a quantizer. These devices aid in rounding off (approximation) the errors of an input function called the quantized value.

Probability of Error

This topic is widely taught in many undergraduate and postgraduate degree courses of: