Situation 1 Determine El6 at point B and end of the overhang. Round off your final answer In 2 decimal places. W1 W2 A C ID X1 X2 X3 Given: 7m X1 %3D X2 = 6m 5m X3 = 34kN/m W1 W2 = 30kN/m a.) El&B %3D %3! b.) Els at the end of the overhang

Q: Three lines have the following north azimuths: AB 114o36’, CD 254o45’, and EF 302o14’. What are the…

A:

Q: Question 25 Which of the following most nearly gives the slope at B? A 0.000361 rad B 0.000115 rad…

A:

Q: A 7° circular turnout is to connect a railway track, leading due east, to the mouth of a tunnel…

A: Given: Degree of curve, D=7° For 7° curve, ⇒sin D2=10R⇒sin 7°2=10R⇒R=163.80 m

Q: Situation 1 Determine Els at point B and end of the overhang. Round off your final answer in 2…

A:

Q: Reduce the set of profile notes in Table 2-7, and perform the arithmetic check.

A:

Q: Given the following differential level notes: STA ELEVATION BS HI FS 1.73 346.50m BM-A TP 1 i.85…

A: Given height of instrument method HI = elevation + BS elevation = HI - FS given elevation of BM a =…

Q: ts X and Y, 240 m apart. The reduced level of the invert at the outfall X is 82m. In order to fix…

A: GIVEN  gradient= 1 in 200 reduced level at X = 150.82m

Q: Q6/ If a = (3,1,2) , b = (-1,1,0) and c = a × (b x c) # (a x b) x c %3D (0,0, –4), show that

A: Given: The values of a, b, and c are:

Q: Determine angles Cable to moin tain W=8ON quilibrium· A smooth R 140

A:

Q: od to cal culabe the slope ond M.

A:

Q: Lines of levels are run from BM1 and BM2 over three different routes. If the elevation of BM1 is 100…

A:

Q: Find: Max. V =? Max. M= 7

A: x=83=2.67 from A ∑MA=0 15×8×4 + 20×2.67 - RB×8 = 0RB = 66.675 kN∑V=0RA+RB=15×8 + 20RA = 73.325 kN

Q: a misclosure of the given transvers is ? Answer. 1°00' show solution B. the adjusted interior angle…

A:

Q: ?? 250x(kd)? /2= 8x1473(600-kd) → solve to get kd = 1

A:

Q: 12. The slope of a ramp should not be more than: A. O 1 in 35 B. O 1 in 20 C. O 1 in 15 D. O 1 in 10

A:

Q: to 2 vertical an The are of the section is 42 Find the dimension of the section if it is most…

A:

Q: 1. Complete the following differential level notes for a double-rodded line from BM1 to BM2. Show…

A: 1. Complete the following differential level notes for a double-rodded line from BM1 to BM2.

Q: SITUATION 2: A simply supported prismatic beam is loaded as shown. El = 1 000 000 kN.m² 1000 kN 500…

A: Given data: EI= 1000000 KN/m2

Q: 3-) Complete the set of differential leveling using Collimation Method, notes in Table and perform…

A: Taking elevation of BM1 = 110m that is given in question

Q: 20° B 50 D 55° VQ

A: To find the force in cable TDE and Q -

Q: HA) 120KN Find slope and B deflection at B 3m 2m (B) W KN/m Find slope and deflection at B (C) 10…

A:

Q: Q1 B) Find Q in l/s and -V%= 2.5 m/s D-300 mm find V3 in ft/min Q=? V - 3 m/s DI = 500 mm V= ? -D,…

A:

Q: line of levels is run from BM1 to BM2, which is 12 km long. Elevation of BM1 was found out to be 100…

A:

Q: O Findz Vertical defection at points C and E; rotation at point B. Use conjuqarte beam method. 30 to…

A: Given data: EI=1500×29×103EI=435×10-5 K.in2EI=302083.33 K.ft2

Q: An open channel is to be designed to carry 1.5 m3/s at a slope of 0.007. The channel material has an…

A: solution  Given discharge Q = 1.5m3/secslope S =0.007n=0.012 for the most efficient rectangular…

Q: Building's basement elevation is 379.1 m. The stub-out connection elevation is 370.8 m „lf the…

A: Given that:                      Elevation of basement elevation=379.1 mElevation of Stub-out =…

Q: An open traverse that runs from A to G has the following deflection angles : B = 52deg 25’ L ; C =…

A: Diagram

Q: The Figure shows a schematic arrangement of a profile level route from BM1 and BM2. Elevation of BM1…

A: A. Create a complete level notes for profile elevation.  B. Find the difference in elevation between…

Q: 2. O= 0. 56 cfr 6" = 175 ft B f= 0.04 D =6 30 ft WITH TH£ WATEE A AT A DETERMINE THE LEVEL

A: Given that:

Q: 6. If the elevation of A is 240.05m, determine the elevation of C. 1 Conc. Wall- -Bottom Line Bottor…

A:

Q: Q1) Choose A or B A/ A leveling process has conducted to construct a tunnel. The following staff…

A: Given information in question  R.L of first point Back sight Fore sight Intermediate sight which are…

Q: Least count of leveling staff is: O a. 0.5 b. 0.05 Ос. 0.0005 O d. 0.005

A:

Q: 15.20 Refer to Figure 15.53. Using the ordinary method of slices, find the factor of safety with…

A: As Per company Guidelines, we will be able to solve only one Independent Question. So in this…

Q: Fill in the blanks Smaller angle: Larger angle: s = 20 ft Determine the two possible angles so that…

A: Determine the two possible angles so that the water strikes at B.?

Q: Situation 1 Determine Elő at point B and end of the overhang. Round off your final answer in 2…

A:

Q: Use E... b Draw the longitudinal section ( profile) of the leveling process if vou know that the…

A: Longitudinal profile is constructed to understand elevation as well as horizontal distance between…

Q: from point A in bet. B and C, the angles of elevation of B and C are 18deg30' and 8deg15'…

A:

Q: Q=455 N E B 2m P= 320 N D с 2 m

A:

Q: R1=8.666 & R2=11.334??

A:

Q: Water is ejected from the water nozzle with a speed vo = 46 ft/sec. For what value of the angle 0…

A: To find  Angle theta and distance X?

Q: B. Find station and elevation of highest point using EQUATION OF THE PARABOLA. GIVEN: G1 = +4.5 %…

A:

Q: How many slope deflection equations are created for a beam with 6 spans? 04 O 5 07

A: Slope deflection equations  Equation which comprise of slopes and deflections.  These equations are…

Q: C.L Elev.=??m 17 m 5 m 3 m 7 m Elev.=15m 4 ?? m Elev.=13m

A: Schematic diagram of the given problem:

Q: 15K A 2oft 有

A:

Q: Determine El8 at point B and end of the overhang. Round off your final answer in 2 decimal places.…

A:

Q: c) Determine the project control accuracy of the traverse. (Primary, Secondary, Tertiary, or "not…

A: (c) Here azimuth is given from south. converting it from north for easiness of calculation. Sample…

Q: Q4 In the same sketch, draw plausible longitudinal profiles of (a) specific energy head, (b) water…

A: Introduction : a ) Specific energy head : The total head relative to the channel bottom is known as…

Q: An engineer's level with stadia constant of 0.30-m was set up on the line between A and B, the…

A: Given: The stadia constant is 0.30 m. The stadia interval factor is 100. The crosshair readings…

Q: Steel cable A.= 2(104) m2 E = 200(103) kN/m2 %3D %3D 2 m LA A, = 0.06 m2 I, = 5(104) mt E, =…

A: the Free body diagram of structure by unit method deflection due to…

Q: ROBLEM: Calculate he vertical isplacement at point and rotation at B. 30 k Tc 8 ft I 40 k-

A: unit displacement method is also called a virtual work method. degree of static indeterminacy, DS =…

Site Plan Requirements

A site plan (also known as a plot plan) is a diagram or process to show the proposed improvements on an existing property. A site plan is important, as it provides information regarding the landscape features of a given plot of land.  Zoning is done or can be understood with the help of a site plan.