Q1 #4Solve the ff. problems. Use 2 decimal places and BOX your final answer. The ff. data are the observed elevation of a point by running a line of levels over four different routes.Elevations340.22340.30340.26RouteProbable Errors1.±02+04±06340.32+08a.) What is the weight of route 3 assuming the weight of route 1 equal to 1?b.) What is the sum of the weighted observation?c.) What is the most probable value of the elevation?

Answered: Image /qna-images/answer/a63d7183-e61c-4b2c-b526-0f31bac192c1.jpg

The ff. data are the observed elevation of a point by running a line of levels over four different routes. Probable Errors ±02 +04 Route Elevations 340.22 340.30 340.26 340.32 +06 4 +08 a.) What is the weight of route 3 assuming the weight of route 1 equal to 1? b.) What is the sum of the weighted observation? c.) What is the most probable value of the elevation?

The ff. data are the observed elevation of a point by running a line of levels over four different routes. Probable Errors ±02 +04 Route Elevations 340.22 340.30 340.26 340.32 +06 4 +08 a.) What is the weight of route 3 assuming the weight of route 1 equal to 1? b.) What is the sum of the weighted observation? c.) What is the most probable value of the elevation?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

12. PROBABLE ERROR. A surveying instructor sent all the 10 students in his class out to measure a distance between wo points marked on a runway. The students working in of groups tollows: 920.45, 921.05, 921.65, 920.25, 92o.15, 921.85, 921.95, 920.45, values are equally reliable and that variations result oaly trom accidental errors, determine the relative precision of four came up with 10 different measurements as 921.15, and 921.35 me ters. Assuming these a single measurement and the relative precision of the mean.
19. Using this data set explain how you could estimate how often control needs to exist if you want to keep error ellipses and elevation coordinate standard deviations under .1 ft. 20. Job1n.1d and job1n.2d are results from the same .obs processed very differently compared to job1.
Q.3 A level circuit is shown in figure. The survey, needed for local engineering project, commenced at BM 35, the elevation of new benchmarks 36, 37, 38 and 39 were determined, and then the level survey was looped back to BM 35, the point of commencement. Fined the adjusted new BMs. ВМ 35 Elevation(m) 185.000(fixed) 35 36 37 38 39 35 184.242 187.299 186.251 188.397 184.933 BM 36 0.9 km. вм 35 0.8 km OBM 37 0.8 km 0.6 km BM 39 BM 38 0.7 km
Q3): The following data were collected while running a closed traverse ABCDA starting from A toward B. Calculate: 5- Linear misclosure 6- Traverse precision Line Length (m) Azimuth AB 181°25' BC CD DA 330 767 411 727.438 89' 50 355 263° 32' 17" Point A (fixed) B C D A (calculated) Easting (m) 337.499 392.341 1159.34 1123.518 N Northing (m) 600.500 270.601 272.832 682.268 D Angles B = 88° 25' C = 85° 10'
To get the topography of a given area, a transit was set up at point A and sighted points B and C. The distance of points B and C from A are 200 m and 60 m, respectively. The stadia intervals were determined to be the ff: Stadia Interval Rod at B 2.001 m Rod at C 0.600 m 1. Compute the stadia interval factor. a. 99.93 b. 89.23 c. 94.12 d. 100.01 2. An additional point D was sighted with a stadia interval of 2.12 m. The vertical angle observed is 422'. If the elevation of the point where the instrument was set up is 100 m. compute the elevation of point D if the stadia constant is 0.30 m. a. 176.22 m b. 125.23 m c. 151.23 m d. 116.11 m 3. Compute the horizontal distance from the point where the instrument was set up to point D. a. 284.11 m b. 119.73 m c. 182.33 m d. 210.92 m
Three triangulation stations A, C and E are points on the shore whose position were observed from X. The angles were measured using a sextant from the boat at X to the three triangulation stations. The following data were recorded during the survey procedure: Distance AC = 700m Distance CE = 680m Angle ACE = 148o Angle AXC = 45o Angle CXE = 35o Angle CAX = 70o a.) Compute the angle CEX. b.) Compute the distance AX. c.) Compute the distance XE.
A level loop was run and the raw elevations in Table 2 were calculated based on backsights and foresights. A plan view of the loop is shown in Figure 2. The true elevation of BM1 is 195.00 ft. Adjust the elevation of each station such that the error is evenly spaced. Show sample calculations of your work. Also determine the accuracy ratio of the survey. BM₁ 5 mi 3 mi BM2 BM4 3 mi BM3 4 mi Figure 2 Table 2 Station Raw Elevation [ft] BM1 195.0 BM2 205.6 BM3 209.8 BM4 204.7 BM1 195.5
Linear Error of Closure Given a closed traverse with sum of south latitudes exceeds the sum of north latitudes by 3.550 m and the sum of east departures exceeds the sum of the west departures by 2.830 m, determine the following: a.) The Linear Error of Closure. b.) The Bearing of Error. c.) The Relative Precision of the measurements made. Note: EXPRESS YOUR ANSWER UPTO 3 DECIMAL PLACES. (Please provide a proven solution and be accurate. Kindly be mindful for the decimal places. Thank you so much.)
The interior angles X, Y, and Z of a triangular traverse were measured with the same precision. The results were as follows: Station Interior Angle No. of measurement X 410 3 Y 650 4 Z 750 2 Determine the most probable value of the interior angles.
Problem No.6 The following data are the observed elevation of a point running a line of levels over 6 different routes. Determine a) Relative weight of each route. b) Most Probable Value of the Elevation. S Route 1 2 3 4 5 6 Observed Elevation 340.22 340.30 340.26 340.24 340.32 340.25 Probable Error +0.011 ±0.008 ±0.018 +0.012 +0.0085 +0.013
Given the accompanying tabulation are the observed data for a traverse obtained from a transit-tape survey. Determine the latitudes and departures of each course and balance these quantities by employing the Transit rule. Tabulate values accordingly.A. Compute the total linear misclosure for departure CD.B. Compute for the total linear misclosure for Latitude CL. C. Compute for the correction needed for the latitude of course AB and EAD. Compute for the correction needed for the departure of course AB and EA.E. Compute for the Adjusted length of course AB and EA. F. Compute for the Adjusted bearing of course EA.
Linear Error of Closure Given a closed traverse with sum of south latitudes exceeds the sum of north latitudes by 3.550 m and the sum of east departures exceeds the sum of the west departures by 2.830 m, determine the following: a.) The Linear Error of Closure. b.) The Bearing of Error. c.) The Relative Precision of the measurements made. Note: EXPRESS YOUR ANSWER UPTO 3 DECIMAL PLACES. Please provide a proven and accurate solution. Thank you so much