The nickel level in a soil sample was determined using AAS. A 3.0 g sample was dissolved in acid and then diluted to a total volume of 100.0 mL. The absorbance of this solution determined at a wavelength of 232 nm, was found to be0.3. Several standard solutions were tested under the same conditions and a calibration curve shown below was obtained. Calculate the mass of nickel in mg.

The nickel level in a soil sample was determined using AAS. A 3.0 g sample was dissolved in acid and then diluted to a total volume of 100.0 mL. The absorbance of this solution determined at a wavelength of 232 nm, was found to be0.3. Several standard solutions were tested under the same conditions and a calibration curve shown below was obtained. Calculate the mass of nickel in mg.

Chemistry for Engineering Students

3rd Edition

ISBN:9781285199023

Author:Lawrence S. Brown, Tom Holme

Publisher:Lawrence S. Brown, Tom Holme

Chapter1: Introduction To Chemistry

Section: Chapter Questions

Problem 1.77PAE

See similar textbooks

Similar questions

+ Moore 5e_Ch11 SP2020.pptx: SP X * OWLV2 | Online teaching and lea X oping Cart | The UAB Blazer x VtakeAssignment/takeCovalentActivity.do?locator=assignment-take [Review Topica) [References) Use the References to access important values if needed for this question. In a study of the decomposition of hydrogen iodide on a gold surface at 150 °C HI(g)% H2(g) + % I(g) the following data were obtained: HI), M 0.401 0.201 0.101 5.05x102 seconds 519 779 910 Hint: It is not necessary to graph these data. (1) The observed half life for this reaction when the starting concentration is 0.401 M is s and when the starting concentration is 0.201 M is req (2) 2req The average rate of disappearance of HI from t=0 s to t= 519 s is Ms! (3) The average rate of disappearance of HI from t = 519 s to t= 779 s is Ms! (4) Based on these data, the rate constant for this v order reaction is Submit Answer Retry Entire Group 9 more group attempts remaining Cengage Learning | Cengage Technical Support Tch 55 F7…
kindly help me with this problem Thank you! Subject: Physical Chemistry Instructions: solve as neatly as possible and show complete solution.No rounding-off for your decimals (include all decimals in your calculator in your computation). The following data were obtained for the adsorption of acetone on charcoal from an aqueous solution at 180C. Y (millimoles/g) C (millimoles/liter) 0.208 2.34 0.618 14.65 1.075 41.03 1.5 88.62 2.08 177.69 2.88 268.97 a) Find the constants k and n of the Freundlich equation. b) Find the constants a and b in the Langmuir equation. c) Find the constants k and n in the Temkin isotherm. d) Which of the isotherm fit the data best?
(b) The tabulated data has been determined for the hydrołysis of ethyl iodide (CHSI) CHI (aq) +OH (aq) CHSOH(aq) +F (aq) k (M's) 5x 10-5 3.68 x 104 6.71 x 103 59.75 0.119 TCC) 15.83 32.02 90.61 Construct the appropriate plot and determine the activation energy (Ea) for this reaction. (R=8.314 J mol K) (c) Draw a potential energy diagram showing an exothermic reaction Of two highly exothermic reactions with different activation energies which would need to be monitored more carefully: the one with the smaller activation energy or the one with the higher value? Why?
Part D Let that Za(OH) () is pely insoluble, which signs that the precipitation reaction with NaOH(aq) (pred in the transition) would go to completion Za (aq) + 2NaOH(aq) Zn(OH), () +2Na (₂) you had a 50 L son containing 200 M of Za" (aq) and you wished to add enough 1.30 M NaOH(aq) to precipitate at of the metal, what is the minimum amount of the NaOH(aq) solution you would As that the NaOH(o) son is the only ace of OEE (n) for the precipitation Capress the volume to three significant figures and include the appropriate View Av Haljuj ml. 7
what is solution homogenous catalysis?
The adsorption equilibrium isotherm for aqueous phenol solution and activated carbon can be determined from the following data: c kg phenol/m3 solution q kg phenol/kg carbon 0.3220 0.150 0.1170 0.122 0.0390 0.094 0.0061 0.059 0.0011 0.045 Determine the appropriate isotherm for this experimental run
6. A dilute silver nitrate solution is added to a slight excess iodide solution. A solution of AgI is face adsorbs.chemohollic.com formed whose surface adsorbs. (a) I (b) NO3 + (c) Nat (d) Ag*
eleganceextreme1 X (208) + X 7571&snapshotld=1324548&id =563649000&takeld=4bfba59b09f0e5b& aSearch this course References Use the References to access important values if needed for this question. A student ran the following reaction in the laboratory at 639 K: H2(g) + I>(g 2HI(g) A-Z When she introduced 0.311 moles of HI(g) into a 1.00 liter container, she found the equilibrium concentration of HI(g) to be 0.249 M. Calculate the equilibrium constant, K, she obtained for this reaction. Kc Submit Answer K from [Initial] and One [Equilibrium]: This is group attempt 1 of 5 Next Autosaved at 12:59 PM Back 1:05 PM 4x 11 9/24/2019 hp delete prt sc insert 12 f11 10 144
(Q3) (a) Derive the Langmuir adsorption isotherm in terms of pressure of a diatomic molecule for the case in which the diatomic molecule, A2, dissociates upon adsorption to the surface.
Benzene on graphite follows the Langmuir isotherm. At a pressure of 1 atm, theThe volume of benzene adsorbed on a sample of graphite was 4.2 mm3 atconditions T = 0°C and 1 atm. At 3 atm it was 8.5 mm3. Suppose 1 molecule ofbenzene occupies 30Å and estimate the surface area of graphite.
(c) State the assumptions and limitations of Langmuir's Adsorption equation for a gas on solid.
Define the following terms :(i) Desorption(ii) Critical micelle concentration(iii) Shape selective catalysis