The results of all problems must be expressed in SI units, unless the problem tells you indicate in other units. A shop floor jack is used to lift a load of 1.1 x 10 3 N on a piston of area 680 cm2. How much pressure must be applied on the jack to lift the load?

The results of all problems must be expressed in SI units, unless the problem tells you indicate in other units. A shop floor jack is used to lift a load of 1.1 x 10 3 N on a piston of area 680 cm2. How much pressure must be applied on the jack to lift the load?

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter1: Physics And Measurement

Section: Chapter Questions

Problem 1.67AP: A rod extending between x = 0 and x = 14.0 cm has uniform cross-sectional area A = 9.00 cm2. Its...

See similar textbooks

Similar questions

How many cubic meters of helium are required to lift a light balloon with a 400-kg payload to a height of 8 000 m? Take Hc = 0.179 kg/m3. Assume the balloon maintains a constant volume and the density of air decreases with the altitude z according to the expression pair = 0e-z/8 000, where z is in meters and 0 = 1.20 kg/m3 is the density of air at sea level.
A rod extending between x = 0 and x = 14.0 cm has uniform cross-sectional area A = 9.00 cm2. Its density increases steadily between its ends from 2.70 g/cm3 to 19.3 g/cm3. (a) Identify the constants B and C required in the expression = B + Cx to describe the variable density. (b) The mass of the rod is given by m=allmaterialdV=allxAdx=014.0cm(B+Cx)(9.00cm2)dx Carry out the integration to find the mass of the rod.
A horizontal pipe 10.0 cm in diameter has a smooth reduction to a pipe 5.00 cm in diameter. If the pressure of the water in the larger pipe is 8.00 104 Pa and the pressure in the smaller pipe is 6.00 104 Pa, at what rate does water flow through the pipes?
An airplane passenger has a volume V1 of air in his stomach just before the plane takes off from a sea-level airport. What volume will this quantity of air have at cruising altitude at the same temprerature ( body temp. ), in terms of V1, the pressure on the ground P1, and the cabin pressure at cruising altitude P2? What is this volume, in cubic centimeters, if the initial volume is 110 cm^3 and the cabin pressure drops to 7.5x10^4 Pa when the plane is at cruising altitude?
In a car lift used in a service station, pressure is transmitted by an incompressible liquid from a small piston of circular cross section with a radius of r1 = 5.00 cm to a second piston of radius r2 = 15.0 cm. Calculate the minimum force that must be exerted on the smaller piston to lift a car weighing 13300 N. What are the relevant givens in the problem above?
Solve the following problem. Round off the final answer to three decimal places. The density of silver is 10.50 g/cm^3. If 5.50 g of pure silver pellets are added to a graduated cylinder containing 11.0 mL of water, to what volume will the water in the cylinder rise?
The density ρ of a fluid changes proportionally with depth from the surface h according to the following formula: ρ(h) = ρ0 + ch. where ρ0 is the density of the fluid at the surface (h = 0), and c is a constant. a)Write an expression for the gauge pressure p as a function of the depth. b)A pressure gauge is placed at a depth of 6.3 m in a fluid with density that varies with depth as described above. The constant c is 720 kg/m4. The density of the fluid at h = 0 is 0 kg/m4. What pressure, in pascals, would the gauge read?
The gage pressure of air in a pressurized water tank is measured simultaneously by both a pressure gage and a manometer. The differential height h of the mercury column is to be determined. Assumptions The air pressure in the tank is uniform (i.e., its variation with elevation is negligible due to its low density), and thus the pressure at the air-water interface is the same as the indicated gage pressure. 90 kPa SG= 0.72 75 cm Air Water 30 cm Mercury SG= 13.6
Question: Some oil is passing through a tube of length w and radius r. The pressure difference between two ends of the tube is P. The viscosity (measure of a fluid's resistance to flow) of the oil is given by: n = [P(r2 – x?)]/4vw here v is the velocity of oil at a distance x from the axis of the tube from this relation the dimensional formula for 17 is. A) [M][L][T¯1] B) [M][L][T] C) [M][L~1][T=1] D) [M][L][T²] E) [M][L²][T]
The karat is a dimensionless unit that is used to indicate the proportion of gold in a goldcontaining alloy. An alloy that is one karat gold contains a weight of pure gold that is one part in twenty-four. What is the volume of gold in an 18.0-karat gold necklace whose weight is 1.90 N?
Systemic blood pressure is expressed as the ratio of the systolic pressure (when the heart first ejects blood into the arteries{max}) to the diastolic pressure (when the heart is relaxed{min}). Systemic pressure = Systolic pressure / diastolic pressure. Both pressures are measured at the level of the heart and are expressed in millimeters of mercury although the units are not written. Normal systemic blood pressure is 120/80. What are the maximum and minimum forces (in Newtons) that the blood exerts against each square centimeter of the heart for a person with high blood pressure, 145 / 85 ? Note: this is a conversion question...follow the units. Answer to 2 sig figs. (1.013 x 10^5 N/m^2 = 760 mmHg =1 atm) (1m = 100 cm) maximum force = {Systolic} minimum force = {Diastolic
Systemic blood pressure is expressed as the ratio of the systolic pressure (when the heart first ejects blood into the arteries{max}) to the diastolic pressure (when the heart is relaxed{min}). Systemic pressure = Systolic pressure / diastolic pressure. Both pressures are measured at the level of the heart and are expressed in millimeters of mercury although the units are not written. Normal systemic blood pressure is 120/80. What are the maximum and minimum forces (in Newtons) that the blood exerts against each square centimeter of the heart for a person with high blood pressure, 145 / 85 ? Note: this is a conversion question...follow the units. Answer to 2 sig figs. (1.013 x 10^5 N/m^2 = 760 mmHg =1 atm) (1m = 100 cm)