The state of stress at a point in a structure is shown in the following figure. Determine: (a) The forces acting on an element oriented at an angle in the direction counterclockwise angle = 40 ° from the x-axis (Show results in a sketch of correctly oriented) (b) Find the maximum shear stress with its average stress (Show the results in a correctly oriented sketch).

The state of stress at a point in a structure is shown in the following figure. Determine: (a) The forces acting on an element oriented at an angle in the direction counterclockwise angle = 40 ° from the x-axis (Show results in a sketch of correctly oriented) (b) Find the maximum shear stress with its average stress (Show the results in a correctly oriented sketch).

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter2: Matter And Energy

Section: Chapter Questions

Problem 12RQ: The specific volume of red brass is 0.001865 ft3/lb. Whatwould be its density?

See similar textbooks

Similar questions

Determine (a) the principal stresses and (b) the maximum in-plane shear stress and average normal stress. Specify the orientation of the element in each case.
mBC=20kg
10 cm| 10 cml -20 cm B A 20 cm
a)The bore of each cylinder in a six-cylinder car engine is 45 mm and the stroke for each piston is 125 mm. calculate the cubic capacity of the engine in cubic centimetres (cm3 ); and calculate the clearance volume per cylinder for a compression ratio, r, of 8.75. b) The bore of each cylinder in a four-cylinder four-stroke internal combustion engine is 38 mm and the stroke of each piston is 165 mm. During testing, the engine runs at 180 revolutions per minute (rpm) with a pressure-volume indicator diagram showing a mean net area of 3.4 cm2 and a diagram length of 1.2 cm. The pressure scale on the indictor diagram is set to 150 kN/m2 per cm. Calculate the mean effective pressure (m.e.p) and the indicated power developed by this four-cylinder four-stroke engine.
1.0 MPa 2.0 MPa 1.5 MPa Figure Q4
Solve it asap What should be the working pressure of a cylinder with 3 in. piston diameter so that it can balance a force of 600 lbs? [Answer:84.9 psig]
Please give me full explanation in 1hr
Show complete solution and FBD
Answer step by step show solutions and use mpa unit
The specific volume of red brass is 0.001865 ft3/lb. Whatwould be its density?
Sy=370 MPa
Good day. I am trying to review for examinations and require assistance for these questions... Horse Power: An amount of work performed is 11,500ft-lb per seconds. How much hp is expended in this case? Piston Displacement: A four-cylinder aircraft engine has a total displacement of 275 cu. in. What is its cylinder bore or diameter if each of the four cylinders has a stroke of six inches? Compression Ratio: If there are 243 cubic inches of space in the cylinder when the piston is at the bottom and there are 27 cubic inches of space when the piston is at the top of the stroke. Find CR and V1 (Litre). **Would appreciate a detailed explanation. Thank you so much.