The table below give the velocity, in feet per second, of a rider on a Ferris Wheel at an amusement part. The time, t, is measured in seconds after the ride starts. The rider moves smoothly and the table gives the values for one complete revolution of the wheel. The rider boards the Ferris Wheel at the bottom. to 5 10 15 20 25 30 35 55 60 40 45 50 v(t) 0 1.6 2.7 3.1 2.4 1.6 0 -1.6 -2.7 -3.1 -2.4| -1.6 0

The table below give the velocity, in feet per second, of a rider on a Ferris Wheel at an amusement part. The time, t, is measured in seconds after the ride starts. The rider moves smoothly and the table gives the values for one complete revolution of the wheel. The rider boards the Ferris Wheel at the bottom. to 5 10 15 20 25 30 35 55 60 40 45 50 v(t) 0 1.6 2.7 3.1 2.4 1.6 0 -1.6 -2.7 -3.1 -2.4| -1.6 0

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A bicycle moves along a straight road such that its speed is described by the continuous function f(t). You are asked to determine the magnitude of the displacement of the bicycle between 5.1 and 21 seconds. To do this, you must solve the integral below. What should the bounds on the integral be? Write your answer to one decimal place. As - fo f(t)dt a = Number b = Number seconds seconds
Q1. The image below shows an example of "absolute dependent motion analysis", where the motions of two objects depend on each other, and the goal is to find the relations in their motions (i.e., in their positions, velocities, and accelerations). Please put the suggested steps of analysis in the correct order. VA A B VB Differentiate the entire equation with respect to time, and extract the relation in velocities. Repeat for acceleration if needed. Set up a coordinate (s) along the direction of motion from a fixed point (O) or a fixed datum line. Represent the positions of the objects respectively. In some cases intermediate objects need to be considered too and their positions need to be represented as well. Recognize the constant length(s) and find the depending geometric relations between the position variables.
1. The wheel starts rotating from rest, 2) if its angular velocity Was a function of angular position 0 is W=0.1-0², where O is in radian, and its radius ris 0.2 m, what is the magnitude of the angular acceleration (in rad/s?) of the wheel after the wheel has turned 1.1 revolution(s) from rest. Please pay attention: the numbers may change since they are randomized. Your answer must include 2 places after the decimal point. P
A bicycle moves along a straight road such that its speed is described by the continuous function f(t). You are asked to determine the magnitude of the displacement of the bicycle between 3.1 and 18.2 seconds. To do this, you must solve the integral below. What should the bounds on the integral be? Write your answer to one decimal place. As = få f(t)dt a = Number b = Number seconds seconds
1) From 0 to 10 sec, find alphaA1, alphaC1 in rad/s^2, omegaA1(t), omegaC1(t) in rad/s, thetaA1(t), thetaB1(t) and thetaC1(t) in rad, and the distance made by the load s1 in inches and in feet made by the load during this time.
What is the displacement based on the following graph? Position vs. Time 20 12 -5.0 m 15.0 m -0.5 m 2.0 m
A Moving to another question will save this response. Quèstion 9 The figure below shows a skier sliding down a frictionless circular slope. What is the speed of the skier at B if his speed at A is 14 m/s? 40° 30 m F9 F10 F8 F6 F7 Esc F3 F4 F5 F1 F2 & 23 6. 7 V 8N 4 5
Q1: The graph below shows the acceleration of a hydraulic elevator in a four story school building as a function of time. hydraulic elevator - acceleration (m/s²) vs. time (s) +0.8 +0.6 +0.4 +0.2 0 -0.2 -0.4 -0.6 -0.8 5 c. velocity-time d. position-time 10 15 The graph begins at t = 0 s when the elevator door closed on the second floor and ends at t = 20 s when the door opened on a different floor. Assume that the positive directions for displacement, velocity, and acceleration are upward. Determine... a. the maximum speed of the elevator b. the duration of the brief jerk experienced by the elevator centered on 17.5 s Sketch the corresponding graphs of... Determine... e. the most likely floor on which the elevator stopped 20
The end of the cable at B is pulled down with a constant speed. A 3 B V1 Values for the figure are given in the following table. Note the figure may not be to scale. Variable Value m S V1 3 Using absolute dependent motion analysis of 2 particles, a. Determine the speed of the anvil, VA. b. Is the anvil going up or down? VA= Round your final answers to 3 significant digits/figures. m Is the anvil going up or down? O up O down
A ball is shot vertically into the air at a velocity of 57 m/s. After 5 seconds, another ballis shot vertically into the air. If the balls meet 116 m from the ground, determine therelative position (in m)of the first ball to the second ball 9 seconds after the first ball wasshot into the air. Use 9.81 m/s? for the acceleration due to gravity. Round off your finalanswer to five decimal places.
The MDF sheet shown in the figure below iscut by a laser pointer, which moves through the curved groove. Your distance in meters measured along the slot is given by s = 9t2– 2t, with t in seconds. The laser is at A at time t = 0.2 s and at B when t = 9.2 s. Determine to two decimal places of precision:a) the magnitude of the average acceleration between A and B;b) the average vector acceleration between A and B
An airplane flying at an altitude of 5 kilometers passes directly over a radar antenna. When the airplane is 10 kilometers away (s = 10), the radar detects that the distance s is changing at a rate of 410 kilometers per hour. What is the speed of the airplane? (Round your answer to two decimal places.) km/h 5 km Not drawn to scale Submit Answer P Type here to search 1:16 PM 29°C 11-Oct-21 esc 17 no2 12/A prt sc delete 96 21 4. 6. 7. 8. 9. backspace fab Y. P. enter caps lock K shift O B shift fn POU ex ctrl fn alt alt crl pgda harman kardor 3.