Three reservoirs A, B and C are connected by a pipe system as shown in the following figure. The length and diameter of pipe 1, 2 and 3 are 2000m, 1000m, 500m and 30cm, 25cm, 20cm respectively. Find the discharge into or from the reservoir B and C if the rate of flow from reservoir A is 50 lit/s. Find the height of water level in the reservoir C. Take coefficient of friction = 0.005  for all three pipes.

Q: In the illustration: A 1 C All friction factor f = 0.02 All pipe lengths L = 250m Diameter of Pipe A…

A: A reservoir is a man-made lake formed by the building a dam in a river valley. The most important…

Q: Three reservoirs A, B and C are connected as shown in Figure below. The water elevations in…

A: Considering Major loss:- H=FLv2d2g=FLθ2d2g*(π4*d2)2 H=rθ2 θ=HR where, r=8fLπ2gD2

Q: Apply Hazen William’s Equation to the pumped system shown in the following figure, having a pumping…

A: Data Given: Pumping head = 77 mwc Q = 4000 m3/hr Pressure = 50 mwc L = 1200 m Hazen William’s…

Q: A cylindrical tank of diameter 3m and height of 8m is filled halfway with water. A small hole (ID =…

A:

Q: 01: A pipeline joining a lake and a reservoir whose water levels differ by 91.4 m has a diameter of…

A: As math type not available, providing hand written solution, and according to our policy providing…

Q: 2. A 6 in. pipe, as shown in the figure, takes water from a reservoir and terminates in a nozzle…

A: Apply the Bernoulli's equation from 1 to 2 as follows: △Z=V2/2g+(0.08)V2/2g+hL…

Q: Water flow in a pipe of diameter 600mm having a length of 2200 m at a velocity of 2m/s. At the end…

A:

Q: Water is flowing in AF pipe (Figure 1) at a velocity of 2 m/s and a pressure of 102400 Pa, the pipe…

A:

Q: A 50 mm diameter siphon draws oil (S.G. = 0.82) from a reservoir. If the head loss from point 1 to…

A:

Q: The system shown below consists of 1000 m long and 50 mm diameter cast iron pipes. With a volume…

A: The given figure is shown below:

Q: A pipe system, connecting two reservoirs whose difference in water surface elevation is h= 28 m,…

A:

Q: T530 m-150 me. C » 130 C ;=120 I830 m-300 mm, C, » 130 250 mm__ El. 0.0 1220 m-250 mm C C; = 120

A: The given information is  The pressure head at A is 3.05 m  The pressure head at B is 89.9m The…

Q: Consider the flow of water in a 10-m wide channel at a rate of 70 m3 /s and a flow depth of 0.5 m.…

A: Using formula

Q: A pump draws water from reservoir A and lifts it to reservoir B as shown in Figure below. The loss…

A: Output power through the pump will be calculated by applying the energy equation between point A and…

Q: 9. The depth of flow of water at a section of a rectangular channel of width 2 m is 0.3 m. The…

A: Given data, Width of rectangular channel b = 2 m Depth of channel y = 0.3 m Discharge through the…

Q: Figure 8-24 shows a pump drawing water from a reservoir and discharging it into the air at point B.…

A: Pressure at point A, pA=10 in Hg (vacuum) Pressure at point B, pB=0 (discharging into atmosphere)…

Q: A tank with a horizontal sectional area constant at 10m2 and 4m high contains water to a depth of…

A: The orifice is the small opening in the tank in which it remove the water from the tank, some of the…

Q: 2. It is known that an irrigation channel has a rectangle with width (b) = 4.5 m, height (h) = 5 m,…

A:

Q: Apply Hazen William's Equation to the pumped system shown in the following figure, having a pumping…

A:

Q: The figure shows two reservoirs connected by a pipe. The discharge rate in the pipe is known to be…

A: The given data is: Q=SN/100=0.21 m3/s λ=SN/1000=0.021 L=SN*100=2100 m

Q: 10. Determine the flow in each pipe in the figure shown and the elevation of reservoir C if the…

A: Four reservoirs are connected with the pipe system given above in figure, Where, inflow to reservoir…

Q: b. Three reservoirs A, B and are connected by a pipe system as show in the following figure. The…

A: D1=30cm D2=20cm D3=10cm L1=2000m L2=1000m L3=500m

Q: Compute for the flow rate in cubic meter per second of oil with p = 950 kg/m³ and v = 0.00002 m?/s,…

A:

Q: Determine the time it would take to lower the level of water from 3 m to 2 m in a reservoir of area…

A: Given: Initial height, H1 = 3 m Final height, H2 = 2 m Area of reservoir, A = 80 m x 80 m Length of…

Q: Problem 3. A cylindrical water storage 12m in diameter and 8m high, is filled through a 100mm pipe…

A:

Q: Q2/B /Water is transported from a reservoir at higher elevation to another reservoir through a…

A:

Q: Water Tower Hydraulics Pump B. Figure 1 Water Supply and Distribution System Q2. [10 Marks]…

A: Calculate the pressure of reservoir: P=ρgH   =1000×9.81×10   =98100N/m2   (At bottom)

Q: 3. Calculate the volume flow rate of water at 5°C through the shown. system 35-mm diameter Flow 3.65…

A: P1=565kPa P2=0 (atmospheric) Z1=0m Z2=3.65m

Q: Reservoirs A, B, and C are connected as shown in Figure 2.28. The water elevations in reservoirs A,…

A: Given data Reservoirs A, B, C are connected, which means the flow is from A to B, and B to C…

Q: Question: A duct of diameter 0.8 m carries gas (p = 1.3 kg/m³). At one point, the duct diameter…

A:

Q: El 2 m Liquid A (s.g = 0.72) Figure 1 %3D El 0.3 m Liquid B (s.g 2.36) El %3D .0m

A:

Q: 1. A pipe system, connecting two reservoirs whose difference in water surface elevation is 13…

A: Given:-  A pipe system, connecting two reservoirs whose difference in water surface elevation is 13…

Q: In the figure, reservoir A is the source of water supply and is at Elev. 150 m, B is the junction at…

A: Given data :  Length AB = 15000m Length BC = 9200m Length BD = 6100m Consumption = 150 liters per…

Q: In the figure shown, Zp = 4 m, length of pipe from the reservoir to the pump is 120 m, from the pump…

A: Given,  f = 0.02 LAB = 120 m LCD = 1000 m

Q: Consider the figure below. The pump supplies water from reservoir A to reservoir B through the 500mm…

A: Options given for subpart a and b are not correct. If we take hf1 = 80 then the answers are…

Q: A circular conical reservoir, vertex down, has depth 20 ft and radius of the top 10 ft. Water is…

A:

Q: Reservoir A has an elevation of 100 m. A pipe is connected from Reservoir A to Reservoir B. It has a…

A: Given Data: Elevation of reservoir A=100 m length of pipe=1000 m Diameter of a pipe= 600 mm…

Q: A supply of water to reservoir C is drawn from two open reservoirs A and B by pipe network shown in…

A: To Determine  The rate of flow from reservoir A in (m3/s), Q Correction in question  Pipe AB given…

Q: Consider the figure below. The pump supplies water from reservoir A to reservoir B through the 500mm…

A: The answers given for subpart (a) and (b) are not correct.

Q: P3: A preliminary design of a reservoir is shown in Figure. Draw the flow-net. Calculate the flow…

A: Flow net is a grid obtained by drawing flow and equipotential lines. It represents the steady-state…

Q: Determine the water power, pump power and motor load for a pump system designed to deliver 2.07…

A: Water power : It is the power of water where kinetic energy of water is converted in form of…

Q: 01(a) There are two reservoirs, A and B, with the water surface elevation in A 10 m higher than that…

A: Given- Height difference=10 mLength of pipes=100 mdiameter d1=30 cmdiameter d2=25 cm

Q: A pump draws 24 liters per second of water from reservoir C and lifts it to reservoir D as shown in…

A:

Q: A water tank has a shape of an inverted circular cone with base radius 2 m and height 4 m. If water…

A: Given: The base radius of the tank is 2 m. The height of the tank is 4 m. The flow rate of water is…

Q: Water flows through a given pipe network. For said pipe network, a pipe 977m long branches out into…

A: f = 0.02 Length of 3rd pipe (L) = 885m Diameter of 3rd pipe = 0.3m Pressure drop between A and B =…

Q: Water (p =1000 kg/m , p=1.59×103 kg /m.s) is flowing with the velocity of 0.25 m/s through a smooth…

A: i. The diameter of pipe is 1 cm = 0.01 m initially and then changed to 1 m. So it is the case of…

Q: Flow takes place between three reservoirs, as shown in Figure 1. The volume flow rate out of…

A:

Q: A 1,200-mm diameter transmission pipe carries 126 1/s from an elevated storage tank open to…

A: Given  diameter of pipe = 1200 mm  Water surface elevation of reservoir = 540m  pipe length under…

Q: A pipeline, 50 cm diameter and 4,500 m long, connects two reservoirs whom constant difference of…

A:

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.