To Find Currents

Q: If Vs = 50V, what is the value of VCA?

A:

Q: A d.c. shunt generator has shunt field winding resistance of 100 . It i supplying a load of 5 kW at…

A: The given points are:

Q: 21.) Compute the current I using the node voltage method. 45<0°V 6 Ω [j2 Ω 3 Ω www ΖΩ -j2.Ω '50<80°…

A:

Q: Assuming an ideal diode (vf=0.7), find the value of V for the circuit if the resistance (R) is 2 k.…

A:

Q: what is the difference between PTC and PT1000 temperature sensor?

A: PTC (Positive Temperature Coefficient) and PT1000 temperature sensors are two different types of…

Q: Q1 B): For the eireuit given below if, Se(t)= [5 cos wet + 8 cos w tsin w, (t)] and fe= cos w t find…

A: The given circuit isWhere fc=cos(wct);

Q: For the circuit shown in Figure 8.41, determine the resonant frequency, system Q and bandwidth. If…

A:

Q: question said round to two decimal places, implying that it is not a whole number. are u sure this…

A:

Q: Explain Full Wave center tapped rectifier with proper diagram and input-output waveform.

A: A full wave center tapped rectifier is an electrical circuit. It is used to convert AC to DC. It…

Q: Example 16.12. The load current in the transmitting antenna of an unmodulated AM transmitter s 8A.…

A:

Q: How can this be represented on Tinkercad?

A: The given circuit isWe need to represent the above circuit on Tinkercard.

Q: Q1/B: For the circuit shown below, determine the transfer function H(s) = Vo(s)/1, (s) 410 1/20 V(1)…

A: The circuit diagram,

Q: Develop a structural model for an 8-bit serial-in/parallel-out shift register, assuming you have…

A: According to the question, we need to design a structural model for 8-bit serial-in/parallel-out…

Q: 5. Find the capacitor voltage in the network shown in figure. If the switch closes at t-0. Assume…

A: In this question, we need to determine the voltage across the capacitor. Also need the rise time,…

Q: When a generator is being driven at 1,200 rpm, the generated emf is 125 volts. Determine the…

A: The generated electromotive force (emf) in a generator is given by:Given values:

Q: Determine (a) the peak frequency deviation, (b) minimum bandwidth, and (c) baud for a binary FSK…

A:

Q: Q3. In a common base connection, current amplification factor is 0.9. If the emitter current is 1mA,…

A: It is given that:

Q: A source vs =10V is fed to a voltage divider implemented with Ra= 120 kilo ohms and Rb= 30 kilo ohms…

A: According to the question, we need to design a circuit for the given data.source voltage vs =10V;…

Q: 13. If three 10 uF capacitors are connected in parallel, the net is cararitance

A: Given information is shown below:

Q: Question 3 A very thin (negligible mass) wire is connected in series with a battery of 50 V and a…

A:

Q: b) a) For the circuit shown in figure 3, use nodal analysis to obtain a complete set of circuit…

A: "Since you have posted a question with multiple questions, we will provide the solution only to the…

Q: A room temperature small-signal silicon diode has a measured forward voltage drop of 0.61 V at 1.0…

A:

Q: What is the formula for EMV? Explain in detail

A:

Q: Question 2: Calculate the total resistance RT and the total current Ir in the following circuit.…

A:

Q: To sketch the characteristic curve of the diode you need to vary voltages on diode and measure…

A: According to the question, for the given diode circuit as shown below,We need to plot VI…

Q: :A 400 V, 50 Hz, three-phase induction motor takes a starting current of 75 A and develops a…

A: Current through the winding is proportional to the voltage across the phase winding. Torque is…

Q: Consider the closed-loop system with the transfer function G We want to get with the dominant poles…

A:

Q: Three periods of a signal are shown below. Calculate the Fourier series coefficients of the signal…

A: The given periodic signal isWe need to find the Fourier series coefficients of the signal using…

Q: cuit in 3.54 Write the node-voltage equations of the circuit in Fig. 3.96 by inspection. V1 GA www…

A:

Q: Is the system with the following transfer function BIBO stable? Explain how you know. (s + 2) (s² +…

A: The transfer function,,

Q: Make a list of all electrical appliances at home Do a research on each appliances and record the…

A: Most used electrical appliances:Ceiling FanLEDair conditionerIron BoxGeyserRefrigeratorTelevision

Q: Vi (a) + ↑ R₁ R₁ (b) Figure P1.27 www βί Bi www R₂ R₂ Uth Rth Uth Rih F 1.28. (a) Find the Thévenin…

A:

Q: Current shown in the circuit???

A: Given circuit is shown below:

Q: Find IC, VPTAT, VBE and VBG for the band gap reference in Fig. 16.29 if R = 36 kΩ, R1 = 1 kΩ and R2…

A: The given circuit diagram is,To find for the band gap reference in the given figure.If .Assume .To…

Q: In a 10-trunk circuit, there are 180 calls in one hour. The average holding time per call is 2…

A: According to the question,In a 10-trunk circuit, there are 180 calls in one hour.The average…

Q: The switch in the circuit below has been open for a long time. At t=0 the switch closes…

A:

Q: 1-Why digital control? 2- What is ADC ? Draw the electronic circuit. 3- Explain the effect of…

A: According to the question, we need to explain1-Why digital control?2- What is ADC,?3- Explain the…

Q: Determine the branch circuit I1=12.4mA.     Please type answer note write by hend.

A: The circuit diagram,The current,

Q: For the MOSFET bias circuit shown, what value of Rd in kilohms is needed to allow the maximum…

A:

Q: An Armature runs at 250 r.p.m. and generates an e.m.f. at 50 Hz. There are 216 slots each…

A: The information provided in question are:

Q: a) Write a VHDL code for the circuit of figure below. Notice that it is purely combinational, so a…

A: According to the question, for the given logic circuit is shown below.(a) We need to write VHDL…

Q: Determine the Laplace transform of the following signals. x(t) = 8(t) x(t) = 8(t-1) x(t) = u(t) x(t)…

A:

Q: An increase in temperature can decrease the magnetic field of a permanent magnet. The material =ed…

A: Based on the information provided, we know that the temperature increase of 50°C (from 20°C to 70°C)…

Q: Example:- Design 32KX8 ROM by using 74LS138 decoder and the address store from 30000H, if this…

A: According to the question, we need to design 32 k x 8 ROM by using 74LS138 decoder.

Q: Ex.4: A 500 V DC shunt motor runs at 1900 RPM taking an armature current of 150 A. The armature…

A:

Q: 4-) Aşağıdaki devrede çevre akımları yöntemini kullanarak is, is ve le akım değerlerini ve 450'lak…

A: using the ambient currents method calculation of current ib and internal current values.from the…

Q: A part of a 50 Hz power transmission and distribution system is represented by Figure Q3a. The…

A:

Q: Calculate the mesh current i1. Please enter your answer to 3 significant figures (ie 0.123). V1 =…

A:

Q: .13 In Figure 3.4, Vcc= 200 V, Rc = 20 2, RB = 5 2, B = 30, and VBE = 0.6 V when the switch is on.…

A:

Q: If the current is 12 mA, what is the value of VEB?

A: In this question, we need to determine the voltage VEB . We know, Voltage across the resistance R,…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.