Two boilers are operating steadily on 91,000 kg of coal contained in a bunker. One boiler is producing 1,591 kg of steam per hour at 1.2 factor of evaporator and an efficiency of 65% and another boiler produced 1,364 kg of steam per hour at 1.15 factor of evaporation and an efficiency of 60%. How many hours will the coal in the bunker run the boilers if the heating value of coal is 7,590 kCal/kg? 230.8 O 118.2 94.54 O 184.6 O 147.7

Two boilers are operating steadily on 91,000 kg of coal contained in a bunker. One boiler is producing 1,591 kg of steam per hour at 1.2 factor of evaporator and an efficiency of 65% and another boiler produced 1,364 kg of steam per hour at 1.15 factor of evaporation and an efficiency of 60%. How many hours will the coal in the bunker run the boilers if the heating value of coal is 7,590 kCal/kg? 230.8 O 118.2 94.54 O 184.6 O 147.7

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

can you please solve this for me (the fraction of steam extracted from theturbine for the open feedwater heater)
A refrigeration system using R-22 has a capacity of 320 kW of refrigeration. The evaporating temperature is -10C and the condensing temperature is 40C.Calculate the fraction of vapor in the mixture before the evaporator.
An ammonia simple vapor operates between evaporator and condenser temperature of -20°C and 35°C respectively. The system used producing 5000kg of ice in 20hrs. A 100x200mm compressor with a compression efficiency of 80% and electric input to the motor driving the compressor is 14kW. Motor efficiency is 90%. Determine: (a) Qe (b) Work indicated (c) Brake work (d) Mechanical efficiency
A refrigeration system is to be used to cool 45,000kg water for 32 Celsius to 19 Celsius in 5 hours. The refrigerant is R-134A and the operating condition are evaporating pressure 810 kPa and 1800 kPa liquefication pressure. Determine COP, quantity of cooling water in the condenser for an increase in temperature of 7 Celsius compressor power, volume of flow rate entering the compressor. With schematic diagram. Using this table https://www.docdroid.net/VkxK8WH/refrigerant-134a-pdf
A refrigeration system using R22 is to have a refrigerating capacity of 60 kW. The evaporating temperature is -5degC and condensing temperature of 35 deg-C. Determine the volume flow rate of the refrigerant at the inlet to the compressor, the power required by the compressor, and the fraction of vapor in the mixture at the entrance to the evaporator. Use the spreadsheet to solve this problem.
A plant using R134a refrigerant has a cooling capacity of 352 kW of refrigeration. It evaporates at 0 Cand condenses at 35 C, with the 5 of superheat at the evaporator outlet and 5 K of sub-cooling at the condenser outlet. Assuming isentropic compression and ignoring pressure drops in the piping, the evaporator and condenser, determi the following; a) The refrigeration effect b) The mass flow rate of refrigerant ) The compressor power d) The rate of heatrejection at the condenser e) The COP 0 The corresponding Carnot COP g) The percentage Carnot-efficiency
I need the workings ASP the answers are there questionn 4 4. A boiler produces 6 tonnes/hour of steam at a pressure of 1.8 MPa and a temperature of 250ºC.Feedwater enters at a temperature of 39ºC. At exit from the economizer part of the boiler thetemperature is 72ºC. At exit from the evaporator part of the boiler the steam is 90 % dry.Energy is supplied by 650 kg of coal per hour, which has a calorific value of36 MJ/kg. The A/F ratio is 25 : 1. The temperature of the flue gas at entry to the economizerpart of the boiler is 430ºC. The average specific heat at constant pressure of the flue gas inthe economizer is 1045 J/kg.K.4.1 Calculate the efficiency of the boiler. [70.5 %] this one is the answer 4.2 Draw up an energy balance, on a kJ/kg coal basis, with percentages of the total energysupplied. [economizer 3.6 %, evaporator 59 %, superheater 8 %,other 29.4 %]
As shown in the figure, the stable operating air conditionerWhile the environment is 32oC, it keeps the indoor environment at 21oC. Roofand the rate of heat transfer from the walls to the houseSince it is 31,650 kJ / h, the compressor of the air conditionerIs 2.2 kW power input sufficient? If it is enough,Calculate COP, if not enough, theoreticallyFind the minimum power required in kW.
Determine the pressure and temperature at the end of the heat addition process Determine the net-work output, the thermal efficiency, and the mean effective pressure forthe cycle.
A refrigeration system using R22 is to have a refrigerating capacity of 60 kW. The evaporating temperature is -50C and condensing temperature of 350C. Determine the fraction of vapor in the mixture at the entrance to the evaporator.
An ammonia system with a 158-kW evaporator operating at -1°C and a 35-kW evaporator operatingat -40°C uses flash gas removal and intercooling. The condensing temperature is 32°C. Thearrangement is as shown. How many kilograms per minute of ammonia are compressed by the high-pressure compressor?
A manufacturer conducted an experiment for an evaporator capacity 500 kW cooling and designed for high COP of 2 when using lithium bromide plus water in an absorption refrigeration system. The evaporator operates 20 C, condenser 40 C & absorber 45 C supplying 1.4 kg/s of water plus lithium bromide solution to the generator. For a condenser size of 650 kW, determine:Ethalphy of the refrigerant entering the Evaporator in kJ/kg Answer in two decimal places