Two equal and opposite forces each of magnitude 40N are applied to the rim of a wheel makes 12 revolutions whie the torque is kept constant. Calculate the angle of revolution, the torque and the work done

Two equal and opposite forces each of magnitude 40N are applied to the rim of a wheel makes 12 revolutions whie the torque is kept constant. Calculate the angle of revolution, the torque and the work done

University Physics Volume 1

18th Edition

ISBN:9781938168277

Author:William Moebs, Samuel J. Ling, Jeff Sanny

Publisher:William Moebs, Samuel J. Ling, Jeff Sanny

Chapter10: Fixed-axis Rotation

Section: Chapter Questions

Problem 10.7CYU: Check Your Understanding The fan blades on a jet engine have a moment of inertia 30.0kgm2 . In 10s,...

See similar textbooks

Related questions

Q: A 30.0 kg wheel, essentially a thin hoop with radius 1.50 m, is rotating at 31.4 rad/s. It must be…

Q: A 2kg disk has a radius of 18cm and rotates with an angulas acceleration of 12 rad/s^2 about an axis…

A: (given) Mass (m) of a disk = 2 kg Radius (r) of a disk = 18 cm…

Q: A wheel initially has an angular velocity of 10.0rad / s but it is slowing at a rate of 5.6 rad / (s…

Q: A 9 kg solid cylinder has a radius 0.10m and thickness 5 cm. the axis of rotation is located at the…

Q: A wheel 25.0 cm in radius turning at 120 rpm increases its frequency to 660 rpm in 9.00 s. Find (a)…

Q: A hoop of radius 3.0 m with a mass of 150 kg. It rolls along a horizontal floor so that its center…

A: Given: The radius of the hoop is 3.0 m. The mass hoop is 150 kg. The speed of the center of mass is…

Q: A uniform rod rotates in a horizontal plane about a vertical axis through one end. The rod is 16.00…

A: Calculate the moment of inertia of the rod about its one end. MOI (I)=13×massm×lengthL2…

Q: The uniform solid Rotation axis block in Fig. and edge lengths a = 3.5 cm, b = 8.4 cm, and c has…

Q: Calculate the rotational inertia of a meter stick, with mass 0.432 kg, about an axis perpendicular…

Q: The wheel of the bicycle has a diameter of 8.7 cm and can travel a maximum speed of 2 m/s. Starting…

A: Distance traveled in one revolution = 2πr r = 8.7 cm = 8.7×10-2 m

Q: A hoop of radius 2 m weighs 100 kg. It rolls along a horizontal floor so that its centre of mass has…

A: Without the weights the meter stick will balance at 50 cm.

Q: Calculate the rotational inertia of a meter stick, with mass 0.351 kg, about an axis perpendicular…

A: Given mass m =0.351kg X=40.3cm calculate the rotational inertia of a meter stick

Q: As shown in the figure below, a bicycle wheel is at rest against a curb. If the wheel has a radius…

Q: The thin uniform rod haslength 2.0 m and can pivot about a horizontal,frictionless pin through one…

A: Initial potential energy of rod is, The kinetic energy at the horizontal position,

Q: How much of its kinetic energy is rotational energy? Express VOur answer usina two sianificant…

Q: For the given figure, the weight of the 9-ft bar is 5 lb. The moment of the tension in the cord…

Q: Two gerbils run in place with a linear speed of 0.55 m>s onan exercise wheel that is shaped like…

Q: Calculate the rotational inertia of a meter stick, with mass 0.312 kg, about an axis perpendicular…

Q: A 5 kg cylinder 0.5 m in diameter rolls down a plane 5 m long inclined 30° with the horizontal at…

A: Given Data Mass of the cylinder is m=5 kg Diameter of the cylinder is d=0.5 m So radius of the…

Q: When a torque does work on a rotating rigid body, what is the effect on kinetic energy?

A: When a rigid body is rotating abound a fixed axis with an angular velocity w, then a torque is…

Q: A flywheel of mass 500 kg and diameter 1m revolves about its axis. Its frequency of revolution is…

Q: A uniform solid ball rolls smoothly along a floor, then up a ramp inclined at 20.2 o. It momentarily…

A: Given data:Angle = 20.2oDistance rolled by the solid ball, d = 1.13

Q: A swivel chair consists of a seat mounted on a screw-threaded column in such a way that when the…

A: According to the data provided

Q: A wheel as shown below, has a thin 3.0 kg rim and four spokes, each of mass 1.2 kg. The aiameter of…

A: Kinetic energy of the wheel is sum of rotational and translational kinetic energies…

Q: A tall, cylindrical chimney falls over when its base is ruptured.Treat the chimney as a thin rod of…

Q: A 29.3 kg wheel, essentially a thin hoop with radius 1.93 m, is rotating at 204 rev/min. It must be…

A: According to the work-energy theorem, the work that must be done is equal to the change in…

Q: For the given figure, the weight of the 12-ft bar is 5 lb. The moment of the tension in the cord…

Q: A 60 cm long string tied the end of a ball of mass of 0.5Kg. pushed to the duan in a horizontal…

Q: A cylinder of mass M, of radius R, and of length L such that, L = 6R is hinged at point A in…

Q: A Father spinning a child on a merry-go round , he exerts a Force of 140 N, at a distance of 1.4 m.…

A: 307.72N

Q: A uniform solid sphere of mass 2.5 kg and radius 0,2 m rolls without slipping along a ramp 5.0 m…

Q: A merry-go-round wih a radius of 2.2m rotates 10.0 times every 5.00s. The merry go round has a mass…

A: Given: The radius (r) of the merry-go-round is 2.2 m. The mass (m) of the merry-go-round is 100 Kg.…

Q: A solid, uniform disk of radius 0.250 m and mass 55.0 kg rollsdown a ramp of length 4.50 m that…

A: Given data:Mass of the disk. M = 55.0 kgRadius of the disc, R = 0.250 mLength of the ramp, L = 4.50…

Q: A cord is wrapped around the rim of a wheel 0.225 m in radius, and a steady pull of 41.5 N is…

A: Radius of wheel (R) = 0.225 m Applied force (F) = 41.5 N Moment of inertia = 5.5 kg. m2

Q: A 5 kg cylinder 0.5 m in diameter rolls down a plane 5 m long inclined 30° with the horizontal at…

Q: A solid cylinder of mass 4 kg and radius 2 m rotates with constant angular velocity of 5 rad/s about…

A: Rotational kinetic energy is given by the formula: K.E=12Iω2,where I is moment of inertia of…

Q: The following figure shows the cross section of a cylinder of radius 5.5 m rotating about its axis…

Q: A uniform solid ball rolls smoothly along a floor, then up a ramp inclined at 15.0 . It momentarily…

A: According to the principle of conservation of energy, the kinetic energy of the ball while rolling…

Q: A coin rolls on a horizontal plane. What fraction of its total kinetc energy is rotational?

Q: olid cylinder of mass me = 5.5 kg and radius r = 0.4 m, then to a spring of spring constant k = 135…

A: GivenFyb=F=31 Mmb=7 kgmc=5.5 kgr=0.4 mk=135 N/mμs=0.61μk=0.33

Q: o bod.ods of halqcs A constant torque of 500 N•m is applied to a small windmill on a miniature golf…

A: Recall P=FV for translational velocity P=τω for rotational velocity

Q: Calculate the rotational inertia of a wheel that has a kinetic energy of 18.5 kJ when rotating at…

Q: 10.29 A 4.0-kg wheel of 20 cm radius of gyration is rotating at 360 rpm. The retarding frictional…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The blades of a wind turbine are 30 m in length and rotate at a maximum rotation rate of 20 rev/min. (a) If the blades are 6000 kg each and the rotor assembly has three blades, calculate the angular momentum of the turbine at this rotation rate. (b) What Is the torque require to rotate the blades up to the maximum rotation rate in 5 minutes?
Check Your Understanding A constant torque of 500kNm is applied to a wind turbine to keep it rotating at 6 rad/s. What is the power required to keep the turbine rotating?
A solid cylinder of radius 10.0 cm rolls down an incline with slipping. The angle of the incline is 30 . The coefficient of kinetic friction on the surface is 0.400. What is the angular acceleration of the solid cylinder? What is the linear acceleration?
A body moving in a circle with a constant seed is in rotational equilibrium.
A block of mass 3 kg slides down an inclined plane at an angle of 45 with a massless tether attached to a pulley with mass 1 kg and radius 0.5 m at the top of the incline (see the following figure). The pulley can be approximated as a disk. The coefficient of kinetic friction on the plane is 0.4. What is the acceleration of the block?
A grindstone with a mass of 50 kg and radius 0.8 m maintains a constant rotation rate of 4.0 rev/s by a motor while a knife is pressed against the edge with a force of 5.0 N. The coefficient of kinetic friction between the grindstone and the blade is 0.8. What is the power provided by the motor to keep the grindstone at the constant rotation rate?
A potter’s disk spins from rest up to 10 rev/s in 15 s. The disk has a mass 3.0 kg and radius 30.0 cm. What is the angular momentum of the disk at t=5s , t=10s ?
A solid cylinder rolls up an incline at an angle of 20 . If it starts at the bottom with a speed of 10 m/s how far up the incline does it travel?
Check Your Understanding The fan blades on a jet engine have a moment of inertia 30.0kgm2 . In 10s, they rotate counterclockwise from rest up to a rotation rate of 20 rev/s. (a) What torque must be applied to the blades to achieve this angular acceleration? (b) What is the torque required to bring the fan blades rotating at 20 rev/s to a rest in 20s?
A boy rides his bicycle 2.00 km. The wheels have radius 30.0 cm. What is the total angle the tires rotate through during his trip?
An athlete in a gym applies a constant force of 50 N to the pedals of a bicycle to keep the rotation rate of the wheel at 10 rev/s. The length of the pedal arms is 30 cm. What is the power delivered to the bicycle by the athlete?
What is the torque abot the origin of the force if it is applied at the point whose position is: