Two lbs of water vapor in a piston-cylinder assembly expands at a constant pressure of 250 lb/in² from a saturated vapor state to avolume of 7.08 ft³.Determine the initial and final temperatures, in °F, and the work for the process, in Btu.

To solve this problem, we can use the ideal gas law and the definition of work for a…

Answered: Two lbs of water vapor in a…

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Several liquids are layered inside a tank with pressur- ized air at the top. If the air pressure is 3.2 kPa, calcu- late the pressure at the bottom of the tank if the lay- ers include 20 cm of SAE 10 oil, 10 cm of water, 15 cm of glycerin, and 18 cm of carbon tetrachloride.
A Carnot vapor refrigeration cycle operates between thermal reservoirs at 7°C and 28°C. The working fluid is saturated vapor at the end of the compression process and saturated liquid at the beginning of the expansion process. Determine the operating pressures in the condenser and evaporator, in bar, and the coefficient of performance for each of the following as the working fluid. (a) Refrigerant 134a (b) Refrigerant R22 (c) water (d) ammonia
A closed tank whose bottom is 18 inches in diameter is filled with three liquids: 4 inches of carbon tetracloride (SG=1.59), 2 inches of water and 12 inches of syrup (SG= 1.31). The aire chamber in the tank is pressurized at 1296 psf. A.) Determine the pressure at the interface of carbon tetrachloride and syrup. B.)Determine the difference in pressure between the interface of water and syrup and the interface of carbon tetrachloride and syrup. C.)Compute the hydrostatic pressure (in psf) acting at the bottom of the tank.
A 10 cm diameter solid cylinder of height 10 cm weighing 0.40 kg is immersed in a liquid (800 kg/cm^3) contained in a tall metal cylinder having a diameter of 13 cm. Before immersion, the liquid was 8 cm deep. At what level from the bottom will the solid cylinder float? W, = 0.40kg %3D 10cme tank New L.S. Original L.S F,
During a steady flow process, the pressure of the working substance drops from 200 to 20 psia, the speed increases from 200 to 800 ft/s the internal energy decreases 20 BTU/lb and the specific volume increases from 2 to 10 ft³/lb. No heat transferred. Determine the following: a)AKE in ft-lb;/Ibm b)APE in ft-lb/lbm c)AW: (flow work) ft-lb:/lbm d)AH in BTU e) Net work in hp for 15 lb/min of fluid (use mass flow rate for this item only)
Argon gas flows through a well-insulated nozzle at steady state. The temperature and velocity at the inlet are 570°R and 150 ft/s, respectively. At the exit, the temperature is 460°R and the pressure is 40 lb/in². The area of the exit is 0.0085 ft². Use the ideal gas model with k = 1.67, and neglect potential energy effects. Determine the velocity at the exit, in ft/s, and the mass flow rate, in lb/s.
An empty tin can is 50 cm high and 10 cm across the top. The tin can with an open-ended down is being pushed underwater 1 m below the water surface. Assuming that thermal equilibrium exists at all times and the atmospheric is 100 kPa. Determine the height of the water level inside the tin can in millimeters.
•Determine the unit weight of the liquid when it is at the level shown. (Express the answer in English unit) •Determine the weight of the liquid. (Express the answer in English unit) •Assuming no mixing of liquids occur, if glycerin (SG= 1.26) is poured into the tank: a.) it will sink to the bottom of the tank b.) it will float on the surface of the liquid c.) it will be suspended in the liquid * answer should be in 3 decimal places
An increase in pressure of a liquid from 7.5 MPa to 15 MPa results into 0.2 percent decrease in its volume. Determine the coefficient of compressibility of the liquid.
1) Air is compressed under Constant Entropy Process from 10 Psia, 3 ft³, 90°F to 50 Psia. Find the following: a) Final volume in ft³. b) Final temperature in °F. c) Work non-flow in BTU.
A cylinder glass tubing 2.8 cm. inside diameter and 90 cm long with one end closed is immersed vertically with the open end down into a tank of cleaning solvent (sp.gr. = 0.73) until only 5 cm. of its length remain above the liquid surface. If the barometric pressure is 1 kg/cm2 and neglecting vapor pressure, how high will the fluid rise in the tube? -2.8cm- Scm 90cm Clearing solvent X (S=0.73) Do not write the unit. You will only input the numerical answer in the space provided. Unit of the Correct Answer: cm Decimal Places required in the final answer: 2
0.05 kg of steam at 1.5 MPa is contained in a rigid vessel of volume of 0.0076 m^3. A. What is the temperature of the steam? B. If the vessel is cooled, at what temperature will the steam be just dry and saturated? C. Cooling is continued until the pressure in the vessel is 1.1 MPa, calculate the amount of vapor at this point. D. Calculate the amount of heat rejected between the initial and the final state. E. Draw the Ts diagram of the whole process.

SEE MORE QUESTIONS

Recommended textbooks for you

Structural Analysis

Civil Engineering

ISBN:

9781337630931

Author:

KASSIMALI, Aslam.

Publisher:

Cengage,

Structural Analysis (10th Edition)

Civil Engineering

ISBN:

9780134610672

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781337705028

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Structural Analysis

Civil Engineering

ISBN:

9781337630931

Author:

KASSIMALI, Aslam.

Publisher:

Cengage,

Structural Analysis (10th Edition)

Civil Engineering

ISBN:

9780134610672

Author:

Russell C. Hibbeler

Publisher:

PEARSON

Principles of Foundation Engineering (MindTap Cou…

Civil Engineering

ISBN:

9781337705028

Author:

Braja M. Das, Nagaratnam Sivakugan

Publisher:

Cengage Learning

Fundamentals of Structural Analysis

Civil Engineering

ISBN:

9780073398006

Author:

Kenneth M. Leet Emeritus, Chia-Ming Uang, Joel Lanning

Publisher:

McGraw-Hill Education

Sustainable Energy

Civil Engineering

ISBN:

9781337551663

Author:

DUNLAP, Richard A.

Publisher:

Cengage,

Traffic and Highway Engineering

Civil Engineering

ISBN:

9781305156241

Author:

Garber, Nicholas J.

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

Two lbs of water vapor in a piston-cylinder assembly expands at a constant pressure of 250 lb/in² from a saturated vapor state to a volume of 7.08 ft³. Determine the initial and final temperatures, in °F, and the work for the process, in Btu.