We mentioned that two types of networks, datagram and virtual-circuit, need a routing or switching table to find the output port from which the information belonging to a destination should be sent out, but a circuit-switched network has no need for such a table. Give the reason for this difference.

We mentioned that two types of networks, datagram and virtual-circuit, need a routing or switching table to find the output port from which the information belonging to a destination should be sent out, but a circuit-switched network has no need for such a table. Give the reason for this difference.

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter9: Computer Networks

Section: Chapter Questions

Problem 9VE

See similar textbooks

Similar questions

The minimum number of columns in a datagram network is two; the minimumnumber of columns in a virtual-circuit network is four. Can you explain thereason? Is the difference related to the type of addresses carried in the packetsof each network?
We mentioned that two types of networks, datagram and virtual-circuit, need a routing or switching table to find the output port from which the information belonging to a destination should be sent out, but a circuit-switched network has no need for such a table. Give the reason for this difference.
Implement a switching network that has two data inputs (A and B), two data outputs (C and D), and a control input (S). If S equals 1, the network is in pass-through mode, and C should equal A, and D should equal B. If S equals 0, the network is in crossing mode, and C should equal B, and D should equal A.
As another example, consider a circuit-switched network that connects computers in two remote offices of a private company. The offices are connected using a T-1 line leased from a communication service provider. There are two 4 × 8 (4 inputs and 8 outputs) switches in this network. For each switch, four output ports are folded into the input ports to allow communication between computers in the same office. Four other output ports allow communication between the two offices. Figure shows the situation
Is that so, or not? Consider a TCP connection where the most recent SampleRTT was 1 second. It is recommended that the TimeoutInterval be set to more than one second.
The minimum number of columns in a datagram network is two; the minimum number of columns in a virtual-circuit network is four. Can you explain the reason? Is the difference related to the type of addresses carried in the packets of each network?
A TCP connection is using a window size of 8,000 bytes and the previousacknowledgment number was 10,001. It receives a segment with acknowledgment number 12,001 and window size advertisement of 7,000 bytes. Draw a diagram to show the situation of the window before and after.
It is possible to describe an isochronous connection and a synchronous connection by comparing and contrasting these two kinds of connections.
Give an example of a synchronous connection and an example of an isochronous connection, and then describe the fundamental distinctions between the two connection types.
NAKs are handled in protocol 6's code for frame arrival.If the incoming frame is a NAK and another condition is satisfied, this section gets activated.Describe a situation in which this other condition is critical.
Information on the ALOHA protocol may be found here. Expound upon the merits it has.
Circuit-switched networks, unlike datagram and virtual-circuit networks, do not require a routing or switching table to determine the output port from which the information pertaining to a destination can be transferred. Let us know what's behind this discrepancy.