What is the maximum yield of dibenzalacetone that could be obtained (in grams) if 8.1 g of acetone was used as the starting material (assuming that acetone is the limiting reagent)? Molecular weight of acetone is 58.08 and density is 0.79 at room temperature; MW of dibenzalacetone is 234.30. Write your answer correct to two decimal places.

Q: What type of hybridization would be expected for the central atom X in each of the following Lewis…

A: We have been given three molecules and we have been asked to determine type of hybridization of…

Q: On earth, tin has 10 different stable isotopes. The heaviest, 124 Sn makes up 5.80% of naturally…

A: Isotopes are atoms of the same element that have same number of protons and different number of…

Q: The molar solubility of PbCl2 is 4.78⋅10−64.78⋅10-6 M.  Calculate the Ksp for PbCl2.

A:

Q: For the following reaction step, indicate which pattern of arrow pushing it represents. OH H proton…

A:

Q: If the ion product constant is 9 x 10-6 and solubility product constant is 4 x 10-2, a precipitate…

A:

Q: Name the following molecule unambiguously.

A:

Q: The structure shown has [Select] [Select] show [Select ] H. I H H [Select] H H H sp2 carbons and…

A: we have to determine the hybridization of carbons and the number of signals in 1-H NMR of the given…

Q: air bubble forms at the bottom of a lake where the total pressure is 2.45 atm. at this pressure the…

A: At constant temperature volume is inversely proportional to the pressure

Q: The energy that is required to break a chemical bond is usually a few eV. Should we be worried about…

A:

Q: Which of the following solutions have the highest boiling point? 0.40 mol AlCl3 in 1.5 kg water…

A: Colligative properties: The colligative properties are those properties of solutions that depend on…

Q: Draw the major products of the SN1 reaction shown below. Use a dash or wedge bond to indicate…

A: Sn1 mechanism:  It proceed through a carbocation intermediate. Follow first order kinetics. Rate of…

Q: Does less branching promote a faster reaction time in a SN2 type reaction?

A:

Q: 2. The pH of a 2.11 M solution of a weak base B is measured to be 11.77 Determine K of the base…

A:

Q: ct so d ▼ Hydrogen is used as a rocket fuel because it is very light and reacts explosively and…

A: Equilibrium constant K measures the extent to which the reaction has proceeded in the forward…

Q: Explain why graphite furnace atomisers provide enhanced sensitivity over flame atomisers in AAS…

A: Advantages of graphite furnace atomisers over atomic absorption spectroscopy

Q: Draw the product of the reaction shown below. Use wedge and dash bonds to indicate relative…

A:

Q: 1 2 3 Assign configuration, give IUPAC name HO Br HO 11 HO CI Assign configuration, Assign…

A: As per the student's request I am solving only question number-3.

Q: Draw the major product of the substitution reaction shown below. Ignore any inorganic byproducts.

A:

Q: I need help with this question. Can you help me to show the work like step by step

A: We have to write the acid form of the NH3. Introduction: We know that an acid is a proton (H+) donor…

Q: If the energy of a photon of light is 9.78x10-21 J, what type of light does this correspond to?…

A:

Q: Consider the reaction: Fe³+ (aq) + SCN-¯(aq) → FeSCN²+ (aq) A solution is made containing an initial…

A:

Q: Electrons are ejected by the photoelectric effect when the surface of the metal rubidium is…

A: a) According to photoelectric effect, hν = K.E + hνo…

Q: Review I Constants I Periodic Table Phosgene (carbonyl chloride), COClą, is an extremely toxic gas…

A:

Q: Does doubling the concentration of an alkylhalide and maintaining the alkoxide concentration double…

A: Given that, the alkoxide (RO-) reaction with alkyl halide (R'-X). We have to answers What happened…

Q: Determine the major product of the reaction below.

A: The multi step reaction of aromatic benzene is given and we have to find out the major product of…

Q: 6. For each of the following neutralization reactions, predict the products & balance the equation:…

A:

Q: Which would be a better choice of compound to add to the sidewalk to prevent ice, a 55 g/mol salt…

A: As a non- volatile solute is added to solvent, the freezing point of the solvent decreases. This is…

Q: 15. An imine would be produced in which of the following reactions?

A: Given : name of compounds.  Tip : imine formation formed when aldehyde or ketone react with primary…

Q: What is the molar solubility (in mol/L) of AgCl (Ksp = 4.37⋅10−16) in a 0.49 M AgNO3 solution

A:

Q: STARTING AMOUNT ADD FACTOR x( ) 0.700 g/mL Convert the concentration of 0.700 M Na₂SO to g/mL 6.022…

A: Given, Concentration of Na2SO4 = 0.700 M = 0.700 mol/L Concentration of Na2SO4 = ?  g/mL Note:…

Q: H₂C. H₂C Draw the molecule on the canvas by choosing buttons from the Tools (for bonds and charges),…

A: We have to draw the given molecule.

Q: 5. Show the major product(s) of the following reactions. H MeO. Bof MeO H CN 150° C CN COME SI- +…

A: The given reactions are Diels-alder reaction.

Q: With the aid of a suitable schematic diagram, discuss the underlying working principles of the flame…

A: Flame atomic absorption spectroscopy:  It works on the principle where ground state metals absorb…

Q: 5. A 0.709 g sample of H2C2042H2O is dissolved in water and titrated to a phenolphthalein endpoint…

A:

Q: In a titration of a mixture of H3PO4 and HCl, 10.00 mL of 0.1M NaOH solution was used to reach the…

A: Answer: Since, the mixture contains HCl and H3PO4 in which HCl is a strong acid and H3PO4 is a weak…

Q: Which of the following is the most likely structure of the following cation after rearrangement? | B…

A:

Q: For every mole of Al(OH)3 that dissolves, 1 mole of A1+ ion and 1 mole of OH ion are produced…

A:

Q: in this reaction 2Li(s) + Se(s) -> Li2Se(s) which ones are oxidized and reduced

A: The addition of electrons or decreases in the oxidation state is known as a reduction reaction and…

Q: Try Again Your answer is wrong. In addition to checking your math, check that you used the right…

A:

Q: A solution containing equal concentrations of a hypothetical substance, HX3 (Ka=9.5×10^-8) and it's…

A: According to Henderson Hasselbalch equation ,we have pH = pKa + log[conjugate salt ]/[Hypothetical…

Q: Content → C X Aktiv Chemistry app.101edu.co X QSN2/SN1 Reactions Fl: X Draw the major product of the…

A: Organic reactions are those in which organic reactant react to form organic products. In the given…

Q: 1. Two types of isomerism are possible for the six-coordinate complex Cr(NO2)3.6H2O. Identify all…

A:

Q: Why is nitrous oxide / acetylene flame used in certain analysis instead of air / acetylene flame?

A: In certain  analysis Nitrous Oxide/ acetylene flame are used instead of air/acetylene flame.…

Q: The Buffer-pair equation allows us to O Calculate the pka of an acid from the pH of a solution of an…

A:

Q: Draw the major product of this reaction. Ignore inorganic byproducts. 1.9-BBN, THE 2. H2O2, NaOH

A:

Q: What is the pH of a 2.05 M solution of NH4CI (Kp of NH3= 1.8 x 10-5)? Your Answer: Answer

A:

Q: ily has a mixture of 4 compounds that they want to separate. All 4 compounds appear as white solid…

A: We are given 4 different compounds (all white powders) to separate.  Since compounds#1 and 4 have…

Q: How do I balance the equations:  C3H5(NO3)3 ----> CO2+  H2O+ N2+ O2  HCN+ O2 ---> N2+ CO2+ H2O

A: We have to balanced the given equation which are (1)  C3H5(NO3)  => CO2 + H2O + N2 + O2 (2) HCN +…

Q: Draw all likely alkene products in the following reactions and circle the product you expect to…

A: Where there is small base elimination leads to formation of greater substituted alkene. In the case…

Q: A 10 ppm solution of lead produces an absorption signal of 12%; what is the atomic absorption…

A:

Alkanes and Cycloalkanes

Alkanes are saturated organic compounds which are made up of C and H atoms. Alkanes have the general formula of CnH2n+2. Alkane contains sp3 hybridized carbon atoms with four sigmas (σ) bonds & every hydrogen atom is connected with one of the carbon atoms. The size of the alkane could be determined by the number of carbon atoms located in it.