Which of the following is a differential equation that correctly describes Newton's second law for a simple harmonic oscillator of mass m and restoring force constant k? kx = m. d²x dt² B −kx d²x = m dt2 -kv dv = mat kx = m dx dt E mg-kv: dv = mat

Which of the following is a differential equation that correctly describes Newton's second law for a simple harmonic oscillator of mass m and restoring force constant k? kx = m. d²x dt² B −kx d²x = m dt2 -kv dv = mat kx = m dx dt E mg-kv: dv = mat

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter16: Oscillatory Motion And Waves

Section: Chapter Questions

Problem 39PE: At what positions is the speed of a simple harmonic oscillator halt its maximum? That is, what...

See similar textbooks

Similar questions

Two masses m1 = 100 g and m2 = 200 g slide freely in a horizontal frictionless track and are connected by a spring whose force constant is k = 0.5 N/m. Find the frequency of oscillatory motion for this system.
A small object is attached to the end of a string to form a simple pendulum. The period of its harmonic motion is measured for small angular displacements and three lengths. For lengths of 1.000 m, 0.750 m, and 0.500 m, total time intervals for 50 oscillations of 99.8 s, 86.6 s, and 71.1s are measured with a stopwatch. (a) Determine the period of motion for each length. (b) Determine the mean value of g obtained from these three independent measurements and compare it with the accepted value. (c) Plot T2 versus L and obtain a value for g from the slope of your best-fit straight-line graph. (d) Compare the value found in part (c) with that obtained in part (b).
An object of mass m on a spring of stiffness k oscillates with an amplitude A about its equilibrium position. Suppose that m = 300 g, k = 10 N/m, and A = 10 cm. (a) Find the total energy. (b) Find the mechanical frequency of vibration of the mass. (c) Calculate the change in amplitude when the system loses one quantum of energy.
In an engine, a piston oscillates with simple harmonic motion so that its position varies according to the expression x=5.00cos(2t+6) where x is in centimeters and t is in seconds. At t = 0, find (a) the position of the piston, (b) its velocity, and (c) its acceleration. Find (d) the period and (e) the amplitude of the motion.
A block with mass m = 0.1 kg oscillates with amplitude .A = 0.1 in at the end of a spring with force constant k = 10 N/m on a frictionless, horizontal surface. Rank the periods of the following situations from greatest to smallest. If any periods are equal, show their equality in your tanking, (a) The system is as described above, (b) The system is as described in situation (a) except the amplitude is 0.2 m. (c) The situation is as described in situation (a) except the mass is 0.2 kg. (d) The situation is as described in situation (a) except the spring has force constant 20 N/m. (e) A small resistive force makes the motion underdamped.
An object of mass m is hung from a spring and set into oscillation. The period of the oscillation is measured and recorded as T. The object of mass m is removed and replaced with an object of mass 2m. When this object is set into oscillation, what is the period of the motion? (a) 2T (b) 2T (c) T (d) T/2 (e) T/2
A 2.00-kg block lies at rest on a frictionless table. A spring, with a spring constant of 100 N/m is attached to the wall and to the block. A second block of 0.50 kg is placed on top of the first block. The 2.00-kg block is gently pulled to a position x=+A and released from rest. There is a coefficient of friction of 0.45 between the two blocks. (a) What is the period of the oscillations? (b) What is the largest amplitude of motion that will allow the blocks to oscillate without the 0.50-kg block sliding off?
Reproduce Figures 3-10b and c for the same values given in Example 3.2, but instead let = 0.1 s1 and = rad. How many times does the system cross the x = 0 line before the amplitude finally falls below 102 of its maximum value? Which plot, b or c, is more useful for determining this number? Explain.
An automobile with a mass of 1000 kg, including passengers, settles 1.0 cm closer to the road for every additional 100 kg of passengers. It is driven with a constant horizontal component of speed 20 km/h over a washboard road with sinusoidal bumps. The amplitude and wavelength of the sine curve are 5.0 cm and 20 cm, respectively. The distance between the front and back wheels is 2.4 m. Find the amplitude of oscillation of the automobile, assuming it moves vertically as an undamped driven harmonic oscillator. Neglect the mass of the wheels and springs and assume that the wheels are always in contact with the road.
Determine the period of oscillation of a simple pendulum of length L suspended from the ceiling of a car that rolls down an inclined plane of angle (Fig. P16.73). Dissipative forces between the car and the plane are negligible.
If the amplitude of a damped oscillator decreases to 1/e of its initial value after n periods, show that the frequency of the oscillator must be approximately [1 − (8π2n2)−1] times the frequency of the corresponding undamped oscillator.
A spring of negligible mass stretches 3.00 cm from its relaxed length when a force of 7.50 N is applied. A 0.500-kg particle rests on a frictionless horizontal surface and is attached to the free end of the spring. The particle is displaced from the origin to x = 5.00 cm and released from rest at t = 0. (a) What is the force constant of the spring? (b) What are the angular frequency , the frequency, and the period of the motion? (c) What is the total energy of the system? (d) What is the amplitude of the motion? (c) What are the maximum velocity and the maximum acceleration of the particle? (f) Determine the displacement x of the particle from the equilibrium position at t = 0.500 s. (g) Determine the velocity and acceleration of the particle when t = 0.500 s.