Why is an Ethernet LAN protocol address field needed? Can you say a beneficial circumstance Where might you either completely ignore the address field, or use a "special" address value in the address field?

Why is an Ethernet LAN protocol address field needed? Can you say a beneficial circumstance Where might you either completely ignore the address field, or use a "special" address value in the address field?

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter9: Computer Networks

Section: Chapter Questions

Problem 16VE

See similar textbooks

Related questions

Q: rue or false 4. TDM and FDM are two types of services provided by the Internet to its…

A: Answer 4: False because TDM and FDM is uses transmission singles. TDM=> Time Division…

Q: 8. An Ethernet MAC sublayer receives 1515 bytes of data from the upper layer. The data needs to be…

A: Answer : -- option A) 1500 bytes; 15 bytes

Q: Ethernet is a LAN so it is placed in the second layer of the OSI reference model.True or False.

A: the answer is given below:

Q: Consider a datagram network using 8-bit host addresses. Suppose a router uses longest prefix…

A: WE are given that the datagram network uses 8-bit addresses. The most significant bits (MSBs) of the…

Q: Suppose Ethernet physical addresses are chosen at random (using true random bits). (a) What is the…

A: * As far bartleby guidelines, I answer first-sub question (a) in the multiple sub questions in that…

Q: An Ethernet MAC sublayer receives 1510 bytes of data from the upper layer. Can the data be…

A: The MAC sublayer is the second sublayer of the data link layer (DLL) in the Open Standard…

Q: Suppose two hosts (Host-A and Host-B) are connected through a shared Ethernet bus of 1 Mbps. The…

A: Note: There are multiple questions are given in one question. According to the rule, you will get…

Q: 2) Logical Addressing: - Incorporate the following IPV4 private addressing scheme on the LANS - LAN…

A: ANSWER:-

Q: a. Buffering at router is required when datagrams arrive from fabric faster than the transmission…

A: The answer is

Q: Using the OSI layered model as a reference, explain the role of a switch and a router in a LAN…

A: What is OSI Model: The Open Systems Interconnection (OSI) model describes seven layers that computer…

Q: 6.4-3 Network- and Link-layer addressing: an end-to-end-scenario (1c). Consider the network shown…

Q: What does the term "connection status information" imply in the context of a virtual circuit…

A: A virtual circuit identification (VCI) is carried inside the header of packets that belong to this…

Q: Consider a datagram network using 8-bit host addresses. Suppose a router uses longest prefix…

A: For interface 0: Given that prefix is “1”. It the starting bit is “1” and remaining bits are “0” in…

Q: Why is an ARP query sent within a broadcast frame? Why is an ARP response sent within a frame with a…

A: The following is the explanation for sending an ARP request as a broadcast message:

Q: the correct architecture in which each host can simultaneously act as both a client and a server

A: the correct architecture in which each host can simultaneously act as both a client and a server,The…

Q: Design a classfull network addressing scheme that will supply the minimum number of hosts per…

A: From the Given problem description we see that the ip address : 172.16.0.0 Below are the steps we…

Q: What is the purpose of an Ethernet LAN protocol address? Can you think of anything positive?If the…

A: Introduction: What is the purpose of an Ethernet LAN protocol address? Can you think of anything…

Q: Because Ethernet is a local area network (LAN), it is classified as a layer 2 device in the OSI…

A: The following is the correct response:

Q: 26. In Ethernet addressing, if the least significant bit of the first byte is 0, the address is…

A: The problem is based on the basics of computer networks related to types of casting in the network.

Q: What problems have been detected in the router's layer 2 protocol? What ramifications does this find…

A: Launch: Protocol Issues at the Layer. The OSI Data Link layer generates frames from data bits while…

Q: Describe how the ARP protocol works to assist a host A in successfully sending a datagram to its…

A: NOTE :- Below i explain the answer in my own words by which you understand it well. A large…

Q: 1. Consider the following switched Ethernet network with redundant core switches. E S5 B- S1 S3 D-…

A: Spanning Tree Protocol(STP) It is a network protocol which builds a loop-free logical topology for…

Q: You are required, in your role as a network trainer for a big organization, to provide a…

A: To forward or filter Ethernet frames, the switch consults a source address table (SAT) before…

Q: Consider the figure below. The IP and MAC addresses are shown for nodes A, B, C and D, as well as…

A: Code:

Q: P6. Consider a datagram network using 8-bit host addresses. Suppose a router uses longest prefix…

A: The solution for the above given question is given below:

Q: In a broadcast Ethernet frame, state the destinatiog Media AccessControl (MAC) address?

A: Broadcast Ethernet frameThe Radio Frame includes an FF-FF-FF-FF-FF-FF-FF-FF hexadecimal MAC address,…

Q: A data link layer switch SW1 is connected with four hosts (H1, H2, H3, H4) as shown in figure below:…

A: Explanation: 1. ARP is used by network computers to determine the MAC address of the IP address…

Q: Ethernet frames must be at least 64 bytes long to ensure that the transmitter is still going in the…

A: Maintenance of minimum frame size of 64 bytes in fast Ethernet: The maximum wire length in Fast…

Q: Why do we require these two kinds of DNS addressing schemes?

A: DNS Addressing Schemes: It is a central part of the internet that provides a way to match numbers…

Q: Under the classful IP addressing system, how many class C address blocks are available? How many…

A: Given:

Q: a) Consider the figures below. The IP and MAC addresses are shown for nodes A, B, C and D, as well…

A: IP: An Internet Protocol address is a numerical label assigned to each device connected to a…

Q: Computer science What problems can be found in the protocol for router layer 2? Why do the ICMP…

A: Introduction: What issues may be identified in the router layer 2 protocol?Why does an ICMP request…

Q: a. Buffering at router is required when datagrams arrive from fabric faster than the transmission…

A: The answer is

Q: Little's Law with multiple servers. Assume one application sends packets to a network switch at rate…

Q: In a WiFi frame, we have 4 addresses instead of just 2 addresses (source and destination MAC). Draw…

A: In a WiFi frame, we have 4 addresses instead of just 2 addresses (source and destination MAC). Draw…

Q: Consider a datagram network using 32-bit host addresses, i.e., IP addresses range from 0 to 255.…

A: Answer:-

Q: One of the followings can be used as block address for an 1024 host network a-network ID and host ID…

A: All the host within a network has same Network ID but different host ID. Sometimes bits from host…

Q: Design and implement an addressing scheme with a given network address: 172.32.0.0/18. Subnet the…

A: 172.32.0.0/18 /18 means number of subnet bits + network bits is 18. This means number of host bits…

Q: Determine the subnet mask required for the router-to-router link shown in the figure below, if only…

A: Subnet mask of a network is the number of bits in the network which are common to all the connected…

Q: Consider the Ethernet networks shown in the below exhibit to answer the following questions. Fao PCO…

A: Actually, network is a device which communicate with each other.

Q: Given that the data connection layer is capable of detecting mistakes between hops, why do you…

A: Because the data link layer can find some errors, we need a different way to check for them at the…

Q: If an ethernet frame arrives at a switch and the switch does not know how to route it to the given…

A: When the switch receives an ethernet frame and does not know how to router the frame to the correct…

Q: Consider the Ethernet networks shown in the below exhibit to answer the following questions. Fa0 PCO…

A: Actually, network is a device communicate with each other.

Concept explainers

Network transmission cabling

A network is a collection of devices connected by communication links. A device can be a computer or any instrument capable of sending and receiving data or information formed by other nodes toward the network. A channel that connects people or things is known as a network. It sends the data from one place to another. It is the basic concept of a computer, network, and data communications.

Question

100%

Why is an Ethernet LAN protocol address field needed? Can you say a beneficial circumstance Where might you either completely ignore the address field, or

use a "special" address value in the address field?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

What is the purpose of an Ethernet LAN protocol address? Can you think of anything positive?If the address box isn't important to you, you can remove it entirely.Should the address box be filled with a "special" address value?
What's the use of having an Ethernet LAN protocol address? Can you think of a positive situation? If the address box isn't important to you, you may choose to leave it out entirely. The address box should be filled with a "special" address value?
What three statements are true about network layer addressing? Network layer addressing uses a hierarchy. It uses addresses that are 48 bits in length. It is used by Ethernet switches to make forwarding decisions. It does not support broadcasts. It uses a method by which the network portion of an address can be identified. Network layer addressing identifies each host distinctly.
Computer Science What is the total number of addresses in IPv6 address scheme (give your answer in comma separated actual numeric value)? Give examples of IPv6 address types: a unicast address, a multicast address, a loopback address, and an unspecified address (e.g., when host does not have an address assigned).
As a network trainer for a large firm, you are needed to deliver a thorough explanation of the following topics: a. Can you explain the process that a switch follows to generate its MAC address table? (three stars are awarded) What occurs when a frame is received by the switch and the MAC addresses of the intended destination are located in the table?
Suppose a switch is built using a computer workstation and that it can forward packets at a rate of 500,000 packets per second, regardless (within limits) of size. Assume the workstation uses direct memory access (DMA) to move data in and out of its main memory, which has a bandwidth of 2 Gbps, and that the I/O bus has a bandwidth of 1 Gbps. At what packet size would the bus bandwidth become the limiting factor?
What is meant by collision free protocols ?
What is the purpose of ARP (Address Resolution Protocol) in the OSI model, and which layer does it operate in?
Find the interface identifier if the physical address in the EUI is FC-AB-00-FE-00-AA-FF-FE16 using the format defined for Ethernet addresses.
The term synchronization has many meanings in Computer Science. Within the networking field, the term is usually used to describe making asynchronous communication synchronous (A coordination of activities; running at the same rate) We see synchronization occurring in different layers, but we are mostly concerned with the physical layer and the data link layer (L1 and L2). a) In what ways is synchronization in these two layers similar? b) In what ways is synchronization in these two layers dissimilar?
Why is it essential for you to have a network address that is only accessible to you? Is it feasible that in the distant future, a datagram with an address that belongs to a private network can, at some point in time, become accessible on the public Internet as a whole? Explain.
Consider a TCP segment originating on a host running a Google Chrome Browser destined for the TU Dublin Webserver: (1) Separately identify how the port numbers are assigned for the client and server applications and, identify the range from which these port numbers are allocated. (ii) Identify the byte order used to represent these addresses within the segment header. (iii) If a port number contained in the segment header is passed to the Application layer, identify the function used to convert it to the correct byte order within the application.