Why is there a need to add concentrated H2SO4 to the centrifugate and evaporating almost to dryness before the addition of methyl alcohol in confirming the presence of BO3-3?
Q: Explain the role of trisodium citrate, Na3C6H5O7 as a component of the Benedict’s reagent for the…
A: A question based on redox reactions in qualitative analysis of organic sample, which is to be…
Q: o-Nitroaniline is more soluble in ethanol than p-nitroaniline. Propose a flow scheme by which a pure…
A: Please have a look at the answer attached here:
Q: Washing the recrystallized product with warm ethanol instead of cold water Opting to filter the…
A: Modifications Yield Explanation Washing the recrystallized product with warm ethanol instead of…
Q: Assuming partition between equal volumes of organic and aqueous phase, what percentage of each of…
A: Introduction- Solvent extraction is a process where 2 immiscible solvents are separated along with…
Q: Why is it necessary to remove the stopp the stopcock? The pka of p-nitrophenol and 2,5-dinitro- any,…
A: Solvent extraction is done using a separatory funnel. In the process, the analyte that is dissolved…
Q: The melting point of Borneo is 206-209oC and 212-214oC for isoborneol. What could we predict for the…
A: During the reduction of Camphor using NaBH4 as a reducing agent leads to formation of two products,…
Q: Calculate the theoretical yield of 2,3-dibromo-3-phenylpropanoic acid starting with 2.56g of…
A: Theoretical yield of the reaction provides the information about the quantity of product formed by…
Q: What information can GC provide? **Select ALL answers that apply** a. boiling point b. Rf c. ratio…
A: GC is referred to as gas chromatography and is an analytical technique which is used to separate…
Q: What is the effect of weighing a recrystallized organic solid which is not completely dried to the…
A: Percentage yield is calculated by dividing actual yield to theoretical yield and multiplying it by…
Q: When dissolved in 6M HNO3, the distribution ratio of UO22+ and La3+ into tri-n-butyl phosphate are…
A: The percentage of UO22+ and La3+left in the aqueous phase is needed to be calculated if equal volume…
Q: The melting point for purified 9-fluroenone product is 62-75. What does that say about the purity of…
A: The melting point is a characteristic physical property of a solid. The temperature at which a solid…
Q: Diethylacetal can be detected by gas chromatography. How does this impurity arise in fermentation?
A: The fermentation product of sugar is ethanol.
Q: Explain what will happen to the (i) yield and (ii) purity, of aspirin if the following steps were…
A: Modification in Step Yield Explanation Opting to filter the recrystallized product using only…
Q: Why there is a need to soak crucible with 10% nitric acid for the preparation of dry ashing? Why…
A: In dry ashing, minerals are subjected to convert it into oxides, sulfates, phosphates, chloride and…
Q: Why is it possible to separate nonanthocyaninic flavonoids from anthocyanins by the extraction with…
A:
Q: What are the densitites and boiling points of the two liquid components of this distillation? What…
A: Since you have asked multiple questions, we will solve the first question for you. Thank you.
Q: Calculate the weight of nitrobenzene that codistills (bp 99°C) with each gram of water during a…
A: When two mutually immisicible liquids are mixed to give a heterogeneous mixture, each exerts its own…
Q: What type of deviation is shown by a mixture of ethanol and acetone? What type of azeotrope is…
A: Azeotrope is a mixture of two liquids having the same composition and have constant boiling points.…
Q: The most suitable method of separation of 1:1 mixture of ortho and para-nitrophenols is (a)…
A: 1. (c): The o- and p-nitrophenols are separated by steam distillation since o-isomer is steam…
Q: Write a cleare scientific prosedure of preparing p-creaol from phenol in laboratory, what is the…
A: A chemical reaction is a mechanism that converts one or more substances, known as reactants, into…
Q: Given that Grignard reaction used 1.4555 g of phenyl bromide 10 g of carbon dioxide , 0.5734 g of…
A: Answer Theoretical yield = 1.1321 g Percent yield = 50.61 % Given: Mass of Phenyl bromide…
Q: What would happen to the your Kc values if you used an absorptivity constant of 6000 M-1, when the…
A:
Q: A 0.100 gram sample of phthalic acid was dissolved in 100 mL of water. When 25 of diethyl ether was…
A: Given data:
Q: 1. Which is a false statement regarding solid-phase synthesis?
A: A solid phase synthesis is a heterogeneous reaction technique in which a reagent reacts with the…
Q: nsider a ternary (three-component) system of amphiphile, hydrocarbon, and water. What structure do…
A:
Q: Isopropanol is a good extraction solvent for plant pigments as it breaks down cell walls and is…
A: Spinach leaves has few more pigments other than chlorophyll-a, that are carotenes, chlorophyll-b and…
Q: Why does β-naphthol dissolve in a basic medium?
A: Ionic compounds are easily solvated by water molecules due to ion-dipole interaction and thus they…
Q: Describe the difference between an oil-in-water and a water-in-oil emulsion, and explain the use of…
A: An emulsion is formed by combining two liquids which don't mix in to each other.
Q: Give and observation and inference when the compound hexane is subjected into test for Br2 in CCl4
A: Br2 in CCl4 is used for bromination of unsaturated hydrocarbons (alkenes and alkynes)
Q: Why is it more difficult to recrystallize benzil when using hexane as a solvent instead of ethanol?
A: Recrystallization is a process of purifying compounds by dissolving the crude sample of the given…
Q: What was the composition of the distillate in Fraction B which was collected in the middle of the…
A: Question 9) at middle of the distillation. we have 50 % of both ethanol and 1-butanol. both are…
Q: Suppose you have an organic sample X that is somewhat soluble in water, even though it issomewhat…
A:
Q: The distribution coefficients fora compound are as follows: Kcyclohexane/water = 1.5 Kpentane/water…
A: Selection of proper solvent system for solvent extraction based on distribution coefficient.
Q: In the monograph for acyclovir from the British Pharmacopeia, find a limit test and an identity test…
A: you have developed a method which is an improvement on the current BP procedure and want to propose…
Q: Why was n-octanol chosen as a surrogate for natural organic phases? Why not another solvent such as…
A: A question based on introduction to organic chemistry that is to be accomplished.
Q: (i) Name any fraction, which is obtained higher up the distillation column than gas oil, and give…
A: The answer is attached-:
Q: What is the chemical reaction when completing extraction experiment and using 100mg Benzoic Acid,…
A: The mixture of the Benzoic acid in 2ml of water and Dichloromethane, the benzoic acid organic it is…
Q: referring to the NIST website, would you recommend simple fraction distillation to separate a…
A: The distillation process is one type of analytical technique in which more than one liquid mixture…
Q: What is the dominant intermolecular force that governs the solubility of 9-fluorenone in methylene…
A: Like dissolves like principal said that polar compounds including ionic compound should be more…
Q: 4. In a distillation of a mixture of acetone (bp. 56°C and dichloromethane bp. 40°C), a fraction…
A: The boiling point of acetone and dichloromethane is 56 oC and 40 oC respectively. The change in…
Q: Why is it required to add drying agent like sodium sulphate to the organic layer which may contain…
A: In an organic solution, there are often traces of water present because water is slightly soluble in…
Q: Liquid-liquid extraction is used here to purify the mixture obtained at the end of the reaction. For…
A: Liquid Liquid extraction is a technique of separating components of mixture using two immiscible…
Q: 3) Explain in a few short sentences how IMFS, acid/base reactions, equilibrium, and thermodynamics…
A: Ibuprofen is non steroidal anti-inflammatory drug. It is also used as an important antipyretic and…
Q: 2) determine the identity of an unknown solid. Briefly explain why the experimental technique of…
A: The Temperature at which the solid state compound transform into liquid state without changing its…
Q: Why does scratching the inside of the flask with a glass stirring rod initiate crystallization?
A: The process by which solidification of molecules or atoms into a highly structured form called…
Q: The purification of propane gas does not show any reaction when it is added to permanganate
A: The reason why the purification of propane gas does not show any reaction when it is added to…
Q: Which combination cannot be used as mobile phase in RPLC? A. Acetonitrile-cyclopentane B.…
A: Which combination cannot be used as mobile phase in RPLC? answer is given below with explanation.
Q: Arrange the following compounds in order of decreasing ease of elution from a column of silica gel
A: Silica gel acts as a stationary phase in silica gel chromatography column and it retains the polar…
Why is there a need to add concentrated H2SO4 to the centrifugate and evaporating almost to dryness before the addition of methyl alcohol in confirming the presence of BO3-3?
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 1 images
- 5. Give the definition of the inductive effect. What is the reason for its appearance in the molecule? Show the effect of the inductive effect in molecules: bromoethane CH3CH3B1; ethanol CH3CH2OH; fluoroethane CH3CH2F.When you are extracting an aqueous solution with an organic solvent, you are uncertain of which layer in the separatory funnel is aqueous, how would you quickly sort out the issue.Heptanet-4-hione LA predicted solubility (with a reason) in the following representative solvents/solvent systems H20, Dilute HCI, Dilute NazCO3, Dilute NaOH, ELOH; acetone; CHCIB; Hexane.
- You were given a mixture of two miscible solvent A and B that you are tasked to separate. You know that solvent A has a boiling point of 49 oC while solvent B has a boiling point of 174 oC. Which of the listed method would overall be the most efficient? Fractional distillation Recrystallization Solid-liquid extraction Liquid-liquid extraction Simple distillation Acid-Base extraction(a) What is the molarity of the NaOH? (b) Based on the propagation-of-error formula, what is the standard devlation of the molarity?4. (4a) + NaHCO, - H2O + (4b)_ 5. CH;COOH + CH;CH2OCOCH3 + H2O -COCH3 6. (6a) (6b) - + H2O
- (DV 20 ml. of an aqueous solution of 2 mmol butyric acid is shaken with 10 mL ether. After the layers are separated, it was found that 0.5 mmol of butyric acid remains in the aqueous layer. Calculate "D" and "%E".What is the dominant intermolecular force that governs the solubility of 9-fluorenone in methylene chloride?Describe the difference between protic and aprotic solvents. Provide an example of each to support your answer.
- 1. Describe the preparation of 500mL of 0.500M KMNO4 from the solid reagent. 2.Describe the preparation of 500mL of 4.75% (W/V) aqueous ethanol (C2H5OH, 46.1g/mol).3. To determine ethanol content in beer using Gas Chromatography (GC) - Flame Ionization Detection (FID), which of the following is the suitable internal standard? (A) Acetone (B) n-propanol (C) Propane (D) WaterA. For each pair of compounds, fill in the appropriate information needed to distinguish them. Compound that will Positive Differentiating Chemical test sign/s of reaction Compound A Compound B react (А/B) COH Dissolution and (1) rapid bubbling (effervescence) (2) ОН OH NH2 H2N. HO. (3) (4) B Formation of O¯ Na O Na (5) white (6) precipitate Br (7) (8) (9)