PRIN.OF HIGHWAY ENGINEERING&TRAFFIC ANA.
7th Edition
ISBN: 9781119610526
Author: Mannering
Publisher: WILEY
expand_more
expand_more
format_list_bulleted
Question
Chapter 2, Problem 34P
To determine
The maximumaccelerationfrom rest of the car on the test track
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
A rear-wheel-drive 2800-lb drag race car has a 170-inch wheelbase and a center of gravity 20 inches above the pavement and 140 inches
behind the front axle. The owners wish to achieve an initial acceleration from rest of 22 ft/s 2 on a level paved surface. What is the minimum
coefficient of road adhesion (in %) needed to achieve this acceleration? (Assume y m = 1.00.)
A level test track has a coefficient of road adhesion of 0.80, and a car being tested has a coefficient of rolling friction that is approximated as 0.018 for all speeds. The vehicle is tested unloaded and achieves the theoretical minimum stop in 180 ft (from brake application). The initial speed was 60 mi/h. Ignoring aerodynamic resistance, what is the unloaded braking efficiency?
A car is traveling at 70 mi/h on a level section of road with good, wet pavement. Its antilock braking system (ABS) only starts to work after the brakes have been locked for 100 ft. If the driver holds the brake pedal down completely, immediately locking the wheels, and keeps the pedal down during the entire process, how many feet will it take the car to stop from the point of initial brake application? (The braking efficiency is 80% with the ABS not working and 100 % with the ABS working. Use theoretical stopping distance and ignore air resistance. Let frl = 0.02 when the brakes are locked, but complete the frl once the ABS becomes active.)
Chapter 2 Solutions
PRIN.OF HIGHWAY ENGINEERING&TRAFFIC ANA.
Ch. 2 - Prob. 1PCh. 2 - Prob. 2PCh. 2 - Prob. 3PCh. 2 - Prob. 4PCh. 2 - Prob. 5PCh. 2 - Prob. 6PCh. 2 - Prob. 7PCh. 2 - Prob. 8PCh. 2 - Prob. 9PCh. 2 - Prob. 10P
Ch. 2 - Prob. 11PCh. 2 - Prob. 12PCh. 2 - Prob. 13PCh. 2 - Prob. 14PCh. 2 - Prob. 15PCh. 2 - Prob. 16PCh. 2 - Prob. 17PCh. 2 - Prob. 18PCh. 2 - Prob. 19PCh. 2 - Prob. 20PCh. 2 - Prob. 21PCh. 2 - Prob. 22PCh. 2 - Prob. 23PCh. 2 - Prob. 24PCh. 2 - Prob. 25PCh. 2 - Prob. 26PCh. 2 - Prob. 27PCh. 2 - Prob. 28PCh. 2 - Prob. 29PCh. 2 - Prob. 30PCh. 2 - Prob. 31PCh. 2 - Prob. 32PCh. 2 - Prob. 33PCh. 2 - Prob. 34PCh. 2 - Prob. 35PCh. 2 - Prob. 36PCh. 2 - Prob. 37PCh. 2 - Prob. 38PCh. 2 - Prob. 39PCh. 2 - Prob. 40P
Knowledge Booster
Similar questions
- Question-- A vehicle is moving on a road of grade +4% at a speed of 20 m/s. Consider the coefficient of rolling friction as 0.46 and acceleration due to gravity as 10 m/s². On applying brakes to reach a speed of 10 m/s, find the required braking distance along the horizontal.arrow_forwardA car is traveling at 76 mi/hr down a 3% grade on poor, wet pavement. The car's braking efficiency is 90%. The brakes were applied 320 ft before impacting an object. The car had an antilock braking system, but the system failed 200ft after the brakes had been applied (wheels locked). What speed was the car traveling at just before it impacted the object? (Assume theoretical stopping distance, ignore air resistance, and let Frl=0.015)arrow_forwardDuring a braking test, a car is brought to rest beginning from an initial speed of 54 mi/hr in a distance of 143 ft. With the same constant deceleration, what would be the stopping distance s from an initial speed of 83 mi/hr? Answer:s = i ftarrow_forward
- A 11120 N car is designed with a 310 cm wheelbase. The center of gravity is located 60 cm above the pavement and 105 cm behind the front axle. If the coefficient of road adhesion is 0.6, what is the maximum tractive effort that can be developed if the car is (a) front-wheel drive and (b) rear-wheel drive?arrow_forwardCompute the braking distance of a car traveling at 50 kph in a horizontal surface and then brought to rest after the application of the brakes if the average skid resistance is 0.55arrow_forwardO-A vehicle is moving on a road of grade +4% at a speed of 20 m/s. Consider the coefficient of rolling friction as 0.46 and acceleration due to gravity as 10 m/s2. On applying brakes to reach a speed of 10 m/s, Find the required braking distance (in m, round off to nearest integer) along the horizontal.arrow_forward
- A 2000-kg airplane lands on a runway with 9% grade with a touchdown speed of 130km/h, where the brakes are applied causing a constant braking force of 12KN to be exerted on the airplane. Neglecting air resistance, determine the distance traveled by the airplane before it stops.arrow_forwardA car is driving at 75 mph down a 4.0 % grade on poor, wet pavement. The car's braking efficiency is 90%. The driver saw an object which is 480 ft away and applied the brake, and his reaction time was 1.0 second. The car's antilock braking system (ABS) works. Just after seeing the object, which of the following is closest to the distance (in ft) traveled before applying the brake? (Assume theoretical stopping distance ignore air resistance and let yb= 1.04 and fr = 0.015). 153 ft B) 127 ft 135 ftarrow_forwarda 2500-lb car designed with a 120-inch wheelbase. the center of gravity is located 22 inches above the pavement and 40 inches the front axle. if the coefficient of road adhesion is 0.6, how far back from the front axle would the center of gravity have to be to ensure that the maximum tractive effort developed for front- and rear- wheel-drive option is equal?arrow_forward
- The brakes of a car are applied, causing it to slow down at a rate of 10 ft/s. Knowing that the car stops in 300 ft, determine (a) how fast the car was traveling immediately before the brakes were applied, (b) the time required for the car to stop.arrow_forwardA car is traveling at 60 mi/h on good, wet pavement. It has a wheelbase of 110 inches with the center of gravity 50 inches behind the front axle and at a height of 24 inches above the pavement surface. Determine the percentage of braking force that the braking system should allocate to the rear axle.arrow_forwardQ-A vehicle is moving on a road of grade +4% at a speed of 20 m/s. Consider the coefficient of rolling friction as 0.46 and acceleration due to gravity as 10 m/s2. On applying brakes to reach a speed of 10 m/s, find the required braking distance along the horizontal.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Traffic and Highway EngineeringCivil EngineeringISBN:9781305156241Author:Garber, Nicholas J.Publisher:Cengage Learning
Traffic and Highway Engineering
Civil Engineering
ISBN:9781305156241
Author:Garber, Nicholas J.
Publisher:Cengage Learning