A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight meter. (1) The capacitance in µF/km without effect of ground? (2) The capacitance in µF/km with effect of ground?

A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight meter. (1) The capacitance in µF/km without effect of ground? (2) The capacitance in µF/km with effect of ground?

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter4: Transmission Line Parameters

Section: Chapter Questions

Problem 4.4P: One thousand circular mils or 1 kcmil is sometimes designated by the abbreviation MCM75C. Data for...

See similar textbooks

Similar questions

Does r=e14r=0.788r, which comes in calculation of inductance, play a role in capacitance computations? Yes No
One thousand circular mils or 1 kcmil is sometimes designated by the abbreviation MCM75C. Data for commercial bare-aluminum electrical conductors lists a 60 Hz resistance of 0.0080 ohm per kilometer at for a 793-MCM AAC conductor. Determine the cross-sectional conducting area of this conductor in square meters. Find the 60 Hz resistance of this conductor in ohms per kilometer at 50C.
Find the inductive reactance per mile of a single-phase overhead transmission line operating at 60 Hz given the conductors to be Partridge and the spacing between centers to be 30 ft.
In terms of line-to-line capacitance, the line-to-neutral capacitance of a single-phase transmission line is Same Twice One-half
2.5 A 3-phase single circuit bundled conductor line with two sub-conductors per phase has horizontal spacing with 6.1 m between the centre lines of adjacent phases. The distance between the sub- conductors of each phase is 30.5 cm and each sub-conductor has a diameter of 2.54 cm. Find the inductance per phase per km. [0.988 mH]
The conductors of a 10 km long, single phase, two wire line are seperated by a distance of 1.5 m. The diameter of each conductor is 1 cm. If the conductors are of copper, the inductance of the circuit is ??
Three Conductors of a 3-phase line are arranged at the corners of a triangle of sides A=2 m, B=2 m, and C=4 m. The diameter of each line conductor is 1.45 cm. a) Calculate the Capacitance per phase per km (C1) in nanofarad for this arrangement. b) Calculate capacitance per phase per km(C2) in nanofarad if the conductor if the spacing is doubled. c) Calculate the Ratio of C2 with respect to С1. a) b) c)
Three Conductors of a 3-phase line are arranged at the corners of a triangle of sides A=2 m, B=3 m, and C=4 m. The diameter of each line conductor is 1.35 cm. a) Calculate the Capacitance per phase per km (C1) in nanofarad for this arrangement. b) Calculate capacitance per phase per km(C2) in nanofarad if the conductor if the spacing is doubled. c) Calculate the Ratio of C2 with respect to C1.
Assume that a single-conductor belted cable has a conductor diameterof 0.681 in., inside diameter of sheath of 1.7025 in., and a length of8000 ft. The cable is to be operated at 12.47 kV. The dielectricconstant is 4.5, and the power factor of the dielectric at a ratedfrequency and temperature is 0.05. Calculate the following:(a) Capacitance of cable.(b) Charging current.(c) Dielectric loss of cable.(d) Equivalent resistance of insulation.
Calculate the capacitance per km per phase for a 3 phase, 50Hz, double circuit line shown in figure below. Each conductor has a diameter of 25mm and subconductor spacing 0,3m. the line is completely transposed. 0.3m 6 m 6m
A single-phase transmission line consisting of two conductors, the radius of each conductor is 0.4 cm, the distance between the conductors is three and half meters and the height above ground is eight 1-The capacitance in uF/km without effect of ground is 2-The capacitance in pF/km with effect of ground is
A three phase, 11 KV, underground cable system, consider a single core of conductor radius 0.5 cm diameter and lead sheath of 1.25 cm. The core and lead sheath have been separated by two intersheaths with radius 0.75 cm and 1 cm. Draw the cable core, dielectric and intersheath layers showing the thickness of each layer, then determine the voltages on the both intersheaths. Suppose the maximum stress on the layers are the same.