Explain the main difference between an analogue and a digital type of measuring instrument?

Q: If a full-wave bridge circuit is used with a transformer whose secondary provides 50 V rms, the PIV ...

A:

Q: 4.5-4. Find the z-transform of the following functions. " -0.37s 6ɛ (а) Е(s) (b) E(s) (s + 1)(s + 2)...

A: As per our guidelines we are supposed to answer only first question. Kindly repost the other questio...

Q: Answers for d.) e.) f.) and g.) please

A:

Q: Construct a 5 to 32-line decoder with four 3 to 8 decoders, with enable and 2 to 4-line decoder with...

A: Given  5  to 32 line decoder with four 3 to 8 decoders with enable and 2 to 4 line decoder 

Q: Please help me answer this problem. Choose the correct answer from the given choices. Put whether yo...

A:

Q: 13.80 When an input voltage of 30u(1) V is applied to a circuit, the response is known to be (50e-80...

A:

Q: Due to availability of NAND gate ICs only, design a digital logic circuit for the following function...

A:

Q: 2200 volts, 60 Hz is impressed on a certain transformer, the core loss is 240 Watts

A: Given data: 2200V, 60Hz on Transformer Core loss PI=240 W Relation between core loss and frequency ...

Q: What is the status of the diode with respect to the source voltage, what is the total current in the...

A: For Si diode, diode can be represented as voltage source of 0.7 V as shown in figure. We have to fi...

Q: Solve the following question: What is the transfer function for a third order low pass Chebyshev fil...

A: Chebyshev filters are used to separate the frequencies of two bands. They cannot equal the performan...

Q: 35. For the circuit shown, use superposition to find the power being dissipated in R3. * R, R, 10 Q ...

A: According to guidelines we are allowed to do only first question. Post again for remaining one as a ...

Q: Find the electric field at P( 6,-3, -4) due to  Q1 = -30uC at (2,3, -6) Group of answer choices a...

A:

Q: Q3)For the circuit shown below determine the value of current (I) through the resistance R=20 .if cu...

A:

Q: 50 20 O 4A 50

A:

Q: Using a constant 4.5 V source, three bulbs, wires, and a double throw switch design a circuit that w...

A:

Q: If a full-wave bridge circuit is used with a transformer whose secondary provides 50 V rms, the PIV ...

A: PIV is the maximum reverse voltage that will be acting on the diode when in operation PIV for full w...

Q: Q: Determine Avs, Ai, Zj and Zo if hie=1k2 and h-100 Vcc for the two transistors. 8k 31000 10k T2 Vs...

A: GIVEN: transistor which have            hfc=100hie=1KΩ FIND: Value of              AvsAiZiZ0

Q: 4.15 For the circuit in Fig. 4.83, use superposition to find i. Calculate the power delivered to the...

A: By using superposition we have to find the value of current and power across 3 ohm resistor 

Q: A balanced, three phase circuit is characterized as follows: i. Y-A connected i. Source in the c-pha...

A:

Q: phase from a 3-phase, 400 volts balanced supply system. The line current is 20 A and power taken by ...

A:

Q: Find the even value of signal x(t) = 1t2 + -3t + -9 evaluated at t=-3.3 seconds. Question 2 Find the...

A:

Q: 34. Circuit schematics determines the corresponding circuit's function. (a) True (b) False

A: We can be able to determine the circuits function by observing  the schematic of that circuit.  Ther...

Q: square surface area with side length of 4cm is in the XY plane at z=0, Find the magnitude of the mag...

A:

Q: peak /cie, instantaneous voltage v at the following angles: (a) 30° , (b) 120° , (c) 220° , (d) 210°...

A:

Q: Vour

A:

Q: A three stage amplifier has the following gains and noise factor for each stage: 1st stage Gain=10 d...

A: The solution is given below

Q: A digital communication link carries binary-coded words representing samples of an input signal, ...

A: We are authorized to answer three sub-parts at a time, since you have not mentioned which part you a...

Q: In free fall motion, the velocity versus time graph is a straight line sloping upward. (A) True B) F...

A: 1. In free fall motion, the velocity versus time graph is a straight line sloping upward  True of Fa...

Q: 20 2V 2AO Vi R = 42 402 Network A Network B

A: Thevenin equivalent circuit can be found by calculating Vth and Rth. Norton equivalent circuit can b...

Q: values: V. 2sin(100t) V, RI = 1 kQ, R2 =1 kQ, C = 1 pF %3D RI R2 Vs (A Figure Problem 2

A: Since the voltage source (Vs)  and R2 are both in parallel , the voltage across  R2 ( V -R2)  is sam...

Q: Define the following terms Density Physics Mass Power Law of Conservation of Energy.

A:

Q: Two wires of the same length and cross-section, one made of copper and the other made of aluminum, a...

A:

Q: Number of Appliances Appliance Daily Use Total Watts Total Cost Per (Monthly in kWH) Appliance Uses ...

A:

Q: Design a PLC program that will correctly execute the following industrial control process: A part is...

A: We need to draw and explain the PLC diagram for the given operation. The given operation and conditi...

Q: three stage amplifier has the following gains and noise factor for each stage: 1st stage Gain=10 dB ...

A:

Q: t’s amazing! Zainab exclaimed and asked: How is it possible for a person to speak at a radio station...

A: The general block diagram of FM transmitter is shown below,

Q: 30. If output voltage measurement V, = VA - Vgof the Wheatstone bridge circuit is equal to -0.365 mV...

A:

Q: if a modulated wave with an average voltage of 20 Vp changes in amplitude ±5, determine the followin...

A:

Q: Use a 16-to-1 multiplexer (mux) with active low enable to implement the function. Do not use any oth...

A:

Q: single-phase 50-kVA, 2400/240-volt, 60-Hz distribution transformer is used as a step-down transforme...

A:

Q: 1ssignment: Given: 6 = 100 si { 200N Find: a) Ays= Vo Vs Vo io E b) Ais= io is c) ac vollage @ each ...

A: Resistance is a degree of the insurance from stream in an electrical circuit.A capacitor is a device...

Q: A mA DC ammeter has an internal structure shown in Figure Q2(a) below. Given that the PMMC has an in...

A:

Q: Two units are connected in parallel , are energized by an AC source. If the components are 10 and 14...

A:

Q: The phase voltages across a certain load are given as: Va = 176 – j132 volts Vb = -128 - j96 volts...

A:

Q: contain energy at a single frequency and are represented by sine waves, whereas contain energy at mu...

A: Generally in the modulation techniques   Carrier Signal contain energy at a single frequency and are...

Q: L ll R2 ww ei R1 For the given electrical circuit write down equations of motionį ww

A:

Q: Why op-amp integrator output is linear?

A: The solution is given below 

Q: 202 122 402 402 I 10A

A:

Q: 4. Consider the two sinusoidal signals x1(t) = 3cos(@t + n/2) and x 2(1) = (3+j2)cos(@t). Let P(1) b...

A:

Q: diode in a clamper circuit

A: Diodes- When forward biased it is closed circuited and when reverse biased it is open circuited, ide...

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.