The system in the figure is in equilibrium. A concrete block of mass 243 kg hangs from the end of the uniform strut of mass 318 kg For angles o- 29.6° and e-66.5", find (a) the tension Tin the cable and the (b) horizontal and (c) vertical components of the force on the strut from the hinge. Sert -Hinge

The system in the figure is in equilibrium. A concrete block of mass 243 kg hangs from the end of the uniform strut of mass 318 kg For angles o- 29.6° and e-66.5", find (a) the tension Tin the cable and the (b) horizontal and (c) vertical components of the force on the strut from the hinge. Sert -Hinge

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter4: Coplanar Equilibrium Analysis

Section: Chapter Questions

Problem 4.125P: The figure shows a three-pin arch. Determine the horizontal component of the pin reaction at A...

See similar textbooks

Similar questions

The figure shows a three-pin arch. Determine the horizontal component of the pin reaction at A caused by the applied force P.
4.00 kg block is attachedto a vertical rod by meansof two strings. When the systemrotates about the axis of the rod,the strings are extended as shownin Fig. and the tensionin the upper string is 80.0 N. (a)What is the tension in the lowercord? (b) How many revolutionsper minute does the system make?(c) Find the number of revolutionsper minute at which the lowercord just goes slack. (d) Explainwhat happens if the number ofrevolutions per minute is less thanthat in part (c).
4. The mobile shown in the figure below hangs at equilibrium. It consists of objects held by vertical strings. Object 3 weighs 1.40 N, while each of the identical uniform horizontal bars wieghs 0.50 N. Find (a) the weights of objects 1 and 2, and (b) the tension in the upper string. ononoo mi nddliops q uode dsi upiol 1ol no COF nia)(M bns H boz/3 L3 boriupor L/2 L/2 noe1og 0008 adgis 1eris 2 d bns Inol noowiod eib pob so1ot dbum woltalosano
Q1/ In the equilibrium position shown in figure below, the uniform bar (AB) has a mass of (50 kg) and supports load (200 kg) at (A). Determine the tension (T) in the cable and reaction force at (B)? 2.5m 2.5n A 200 kg T= 7646 N, FBx= 2000 N, and FBy = 3299 N T= 6511 N, FBx = 3823 N, and FBy = 8992 N T = 7646 N, FBx = 3823 N, and FBy = 4169 N Non of the above
Example -2: Determine the tension in cables BA and BC necessary to support the 60-kg cylinder. w=mg TA Tc 45° fy co THD 60 (9.81) N TBD = 60 (9.81) N 60 (9.81) N (b)
A rear suspension system for a front wheel-drive vehicle is shown here. Spring EF is offset behind member CD. The normal force due to contact between 2 wheel and the road is 4200 N. Assume the weight of the wheel and suspension system components is negligible. (a) Determine the magnitude of the force in member CD. Is the member in tension or compression? (b) Determine the support reactions at A. (c) Determine the unstretched length of the spring EF given a spring constant of 150 kN/m. 60 mm 1130 mm 60 mm 245 mm D 220 mm F 260 mm E B 165 mm 90 mm F = 4200 N
A 400 N gas sign hangs from the end of a uniform strut BC. The strut is 4 m long and weighs 600 N. The strut is supported by a hinge at the wall at C and by a cable whose other end is tied to the wall at point A 3.0 m above the left end of the strut. Find the tension in the supporting cable and the force of the hinge on the strut. 5.0 m 3.0 m 4.0 m B GAS TAB= 1333 N TAB= 1167 N TAB= 400 N TAB= 1000 N leave the question 4 Other: Q 4 4 points Rc= 980 N O Rc= 360 N Rc= 890 N Rc= 1085 N O O O O O O O
The light boom AB is attached to a vertical wall by a ball and socket joint at A and supported by two cables at B.A force P is applied at B where P= 20i - 14j kN.Note that the reaction force at A acts along the boom because it is a two-force member. Calculate the magnitude of the reaction force at A in kN. of stion 2m 4 m. 6 m Answer: 5 Calculate the magnitude of the tension in cable BD in kN. of Answer:
The cylinder C in the figure below weighs 1000lbs. Determine the tension in the cable , and the reactions A and F
20 kg 75 kg 30° 60° Two cylinders having 75 kg and 20 kg mass are konnected with a cable and held in equilibrium on smooth surfaces as shown in the figure. Determine the contact forces between the cylinders and the surfaces, the tension in the cable and the angle 0.
For the plane truss shown, diagonal members BG, CF, CH, and DG are cables which can brace the truss in tension only. Given: P, = 1 kN, P2 = 3 kN, P3 = 3 kN, P4 = 1.5 kN, a = 3 m, b = 2.25 m, and h = 3 m. What is the force (kN) in member BF? h b DI a a P,V P2 P3V cable cable cable cable
2. Auniform bar 3.00 m long is held by ropes at the ends making angle 60.0° and 30.0°, respectively, with the horizontal. A weight of 200 N is hung 0.500 m from the left end where the 60.0° rope is attached. Find the tension in the ropes (T1 & T2) and the weight (W) of the bar. (Hint: Formulate three equations for the three unknowns, 2 equations for the 1st condition and 1 equation for the 2nd condition.) 3.00m T2 7 0.500m 60.0 B 200 N