The time that the perfume needs to flow from one end of a room to the other end of the room.

Question

Want to see the full answer?

Answer 1

Question

Chapter 1.7, Problem 68P

To determine

The time that the perfume needs to flow from one end of a room to the other end of the room.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Let us consider a bacterial cell that depends on chemical reactions using oxygen to produce energy. The cell needs to obtain molecular oxygen from the extra-cellular medium by diffusion through the cell membrane. We model the cell as a water-filled sphere of radius 1 µm. This means that we neglect the presence of the internal structures of the cell: nucleus, nutrients, etc. The oxygen diffusion coefficient (O2) in water at 25°C is 1.0x10-5 cm².s'. Figure 1: Transmission electron microscope Reminder: The distance travelled by diffusion can be picture of a bacterium. [from Wikipedia: written as L(t) = V6Dt, where D is the diffusion coefficient and t the diffusion time. "Transmission Electron Microscopy"| 2. Diffusion as a function of time People have measured the distance travelled by the oxygen molecule in water as a function of time. The results are given in the table below. 0.1 t(s) L (x10-“m) log1o(t) log10(L) 0.001 0.005 0.01 0.05 2.45 5.4 7.7 17.3 25.5 Draw the plot of L as a…

A very thin layer of oil floats on top of water. A drop of dye is placed at the center of the oil. The dye diffuses through the oil in all directions equally with a diffusion constant D0. Since the layer of oil is thin, we can assume the diffusion is two-dimensional. After a time T0 has passed, the dye has diffused a distance of 5 mm. If the dye had a diffusion constant of D0/3 what distance would the dye have diffused after a time T0/4? Give your answer in units of mm. (Round your answer to two decimal places.)

A patient uses an oxygen tank to breathe. At the beginning of your shift, the gauge on the tank shows the internal gas pressure to be 250 psi. At the end of your shift you check the tank again and find the pressure to be 25 psi (psi stands for pounds per square inch; it is another unit of pressure). The number of molecules is directly proportional to the pressure of the system. What proportion of the gas molecules was used?