Physics for Scientists and Engineers: Foundations and Connections
1st Edition
ISBN: 9781133939146
Author: Katz, Debora M.
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Concept explainers
Textbook Question
Chapter 28, Problem 44PQ
A Two wires with different resistivities, ρ1 and ρ2, are supposed to have the same resistance. If the radii of the wires are r1 and r2, find a function for the length of the second wire in terms of the length of the first wire.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
A two wires, one of Copper and the other of Nickel, if the resistance of the first is (12.7 Q), and
the second is (11.6 Q) at room temperature, at what temperature are their resistances equal?
Note that the temperature coefficient of resistivity of Copper is (0.0039 C-1), and for Nickel it is
equal to (0.006 c-1).
A
x=0
A
AV
A potential difference of AV = 30 (V) is applied to the
ends of a straight wire with cross section A length of
L = 2 (m). The resistivity of the wire varies with
p(x) = (1+x) (nm). Here x is the distance measured
from one end of the wire in meters.
B
What is the magnitude of the electric field at the midpoint
(x = L/2) of the wire, in (V/m)?
n
D
10
9.0
30
p(x)
15
x=L
20
X
A conductor has a circular cross-sectional area A, length L, and
L
resistivity p, as shown.
A
Suppose you want to double the resistance of the conductor. Would the
following changes achieve this goal?
i)
Yes
No
Replace the conductor with one made from a material
with half the resistivity, keeping everything else the
same:
ii)
Replace the conductor with one made from a material
with half the conductivity, keeping everything else
the same:
Yes
No
Double the length of the conductor, keeping
everything else the same:
iii)
Yes
No
Double the radius of the conductor, keeping
everything else the same:
iv)
Yes
No
Yes
Reduce the radius of the conductor by half, keeping
everything else the same:
v)
No
Chapter 28 Solutions
Physics for Scientists and Engineers: Foundations and Connections
Ch. 28.1 - Prob. 28.1CECh. 28.2 - Prob. 28.2CECh. 28.3 - Prob. 28.3CECh. 28.5 - When a lightbulb burns out, its filament breaks so...Ch. 28.6 - A battery with terminal potential is connected to...Ch. 28.7 - A battery of terminal potential is connected to a...Ch. 28 - Prob. 1PQCh. 28 - Prob. 2PQCh. 28 - Prob. 3PQCh. 28 - Prob. 4PQ
Ch. 28 - Prob. 5PQCh. 28 - Prob. 6PQCh. 28 - Prob. 7PQCh. 28 - Prob. 8PQCh. 28 - Prob. 9PQCh. 28 - Prob. 10PQCh. 28 - Prob. 11PQCh. 28 - Prob. 12PQCh. 28 - Prob. 13PQCh. 28 - Prob. 14PQCh. 28 - The current in a wire varies with time (measured...Ch. 28 - Prob. 16PQCh. 28 - The amount of charge that flows through a copper...Ch. 28 - Prob. 18PQCh. 28 - Prob. 19PQCh. 28 - Prob. 20PQCh. 28 - Prob. 21PQCh. 28 - Prob. 22PQCh. 28 - A copper wire that is 2.00 mm in radius with...Ch. 28 - Prob. 24PQCh. 28 - Prob. 25PQCh. 28 - Prob. 26PQCh. 28 - What is the electric field in an aluminum wire if...Ch. 28 - Prob. 28PQCh. 28 - Prob. 29PQCh. 28 - Prob. 30PQCh. 28 - Prob. 31PQCh. 28 - Prob. 32PQCh. 28 - Two concentric, metal spherical shells of radii a...Ch. 28 - Prob. 34PQCh. 28 - Prob. 35PQCh. 28 - Prob. 36PQCh. 28 - Prob. 37PQCh. 28 - A lightbulb is connected to a variable power...Ch. 28 - Prob. 39PQCh. 28 - Prob. 40PQCh. 28 - Prob. 41PQCh. 28 - Prob. 42PQCh. 28 - Prob. 43PQCh. 28 - A Two wires with different resistivities, 1 and 2,...Ch. 28 - A copper and a gold wire are supposed to have the...Ch. 28 - Gold bricks are formed with the dimensions 7358134...Ch. 28 - Prob. 47PQCh. 28 - Prob. 48PQCh. 28 - Prob. 49PQCh. 28 - Prob. 50PQCh. 28 - Prob. 51PQCh. 28 - Prob. 52PQCh. 28 - Prob. 53PQCh. 28 - Prob. 54PQCh. 28 - A two-slice bread toaster consumes 850.0 W of...Ch. 28 - Prob. 56PQCh. 28 - Prob. 57PQCh. 28 - Prob. 58PQCh. 28 - Prob. 59PQCh. 28 - Prob. 60PQCh. 28 - Prob. 61PQCh. 28 - Prob. 62PQCh. 28 - Prob. 63PQCh. 28 - Prob. 64PQCh. 28 - Prob. 65PQCh. 28 - Prob. 66PQCh. 28 - Prob. 67PQCh. 28 - Prob. 68PQCh. 28 - Prob. 69PQCh. 28 - Prob. 70PQCh. 28 - Prob. 71PQCh. 28 - Prob. 72PQCh. 28 - Prob. 73PQCh. 28 - Prob. 74PQCh. 28 - Review When a metal rod is heated, its resistance...Ch. 28 - Prob. 76PQCh. 28 - Prob. 77PQCh. 28 - Prob. 78PQCh. 28 - Prob. 79PQCh. 28 - Prob. 80PQCh. 28 - Prob. 81PQCh. 28 - A conducting material with resistivity is shaped...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- A copper and a gold wire are supposed to have the same resistance. The copper wire has a radius of 2.50 mm, and the gold wire has a radius of 3.25 mm. If the copper wire is 1.20 m long, what must be the length of the gold wire?arrow_forwardA conducting material with resistivity is shaped into a wire of length ( with a tapered cross section that decreases from radius r1 on the left end to r2 on its right end (Fig. F28.82). If the current density in the wire is a constant as a function of the horizontal distance x along the wire, what is the resistance of this tapered wire?arrow_forward(a) During surgery, a current as small as 20.0 ? applied directly to the heart may cause ventricular fibrillation. If the resistance of the exposed heart is 300 , what is the smallest voltage that poses this danger? (b) Does your answer imply that special electrical safety precautions are needed?arrow_forward
- Review When a metal rod is heated, its resistance changes both because of a change in resistivity and because of a change in the length of the rod. If a silver rod has a resistance of 2.00 at 22.0C, what is its resistance when it is heated to 200.0C? The temperature coefficient for silver is = 6.1 103 C1, and its coefficient of linear expansion is 18 106 C1. Assume that the rod expands in all three dimensions.arrow_forwardA copper wire that is 2.00 mm in radius with density 8.94 g/cm3 has a current of 8.00 A. The molar mass of copper is 63.5463, and each copper atom contributes one free electron. What is the drift speed of the electrons in the copper wire?arrow_forwardGold bricks are formed with the dimensions 7358134 inches. What is the maximum resistance of a gold brick? What is the minimum resistance? Include sketches to explain how each of these resistances is achieved.arrow_forward
- What is the electric field in an aluminum wire if the drift speed of the free electrons in the wire is measured to be 4.50 105 m/s? The resistivity of aluminum is 2.655108m.arrow_forwardDetermine the currents through the resistors R2, R5, R6, and R7 in the set of junctions and branches shown in Figure P29.27. Hint: Use Kirchhoffs junction rule, be sure to consider the branches where a current is shown, and assume the branches that appear disconnected are connected to other parts of the circuit. FIGURE P29.27arrow_forward(a) During surgery, a current as small as 20.0A applied directly to the heart may cause ventricular fibrillation. If the resistance of the exposed heart is 300 what is the smallest voltage that poses thisdanger? (b) Does your answer imply that special electrical safetyprecautions are needed?arrow_forward
- Figure P29.42 shows five resistors and two batteries connected in a circuit. What are the currents I1, I2, and I3? FIGURE P29.42arrow_forwardPart F and G Please An external resistor with resistance R is connected to a battery that has emf E and internal resistance r. Let P be the electrical power output of the source. By conservation of energy, P is equal to the power consumed by R.Part F What is the power output of this battery when it is connected to a resistor R, for R= 4.00 Ω? Part G What is the power output of this battery when it is connected to a resistor R, for R= 6.00 Ω?arrow_forwardChoose true or false for each statement regarding the resistance of a wire. While maintaining a constant voltage V, the current I increases when the length L of a wire increases. The resistivity p is inversely proportional to the resistance R of a wire. e While maintaining a constant voltage V, the current I increases when the resistivity p of a wire increases. Submit Answer Tries 0/2 Choose true or false for each statement regarding resistors in a circuit. O Three identical resistors in parallel have triple the resistance of each individual one. If you connect two different resistors in series in a circuit, then the voltage across each of them is different. If you connect two different resistors in series in a circuit, then the current that flows through each of them is different.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningCollege PhysicsPhysicsISBN:9781938168000Author:Paul Peter Urone, Roger HinrichsPublisher:OpenStax College
Physics for Scientists and Engineers: Foundations...
Physics
ISBN:9781133939146
Author:Katz, Debora M.
Publisher:Cengage Learning
College Physics
Physics
ISBN:9781938168000
Author:Paul Peter Urone, Roger Hinrichs
Publisher:OpenStax College
Circuits, Voltage, Resistance, Current - Physics 101 / AP Physics Review with Dianna Cowern; Author: Physics Girl;https://www.youtube.com/watch?v=q8X2gcPVwO0;License: Standard YouTube License, CC-BY