The reason that leads to difficulty in the visualization of separation of cis-2-butene and trans-2-butene on thin layer chromatography plate should be explained. Concept introduction: Isomers (cis and trans) of but-2-ene have similar composition. The principle on which the thin layer chromatography works is that two different molecules interact differently with the mobile and stationary phase.Thus, it ends up getting separated. If two similar molecules or isomers are spotted on the plate, they might end up at the same distance from the base.

Question

Want to see more full solutions like this?

Answer 1

Question

Chapter 8, Problem 1Q

Interpretation Introduction

Interpretation:

The reason that leads to difficulty in the visualization of separation of cis-2-butene and trans-2-butene on thin layer chromatography plate should be explained.

Concept introduction:

Isomers (cis and trans) of but-2-ene have similar composition. The principle on which the thin layer chromatography works is that two different molecules interact differently with the mobile and stationary phase.Thus, it ends up getting separated. If two similar molecules or isomers are spotted on the plate, they might end up at the same distance from the base.

Expert Solution & Answer

Answer to Problem 1Q

Observing a separate spot of isomers of but-2-ene is difficult, because before they resolve into distinct spots, it evaporates.

Explanation of Solution

But-2-ene vaporizes too fast at room temperature due to very low boiling point. To obtain separate spots for the two isomers of but-2-ene , the sample mixture must move upward in the TLC column. But the mixture spot marked on the TLC plate evaporates.So, identifying and visualizing the two isomers separately becomes difficult.

Want to see more full solutions like this?

Subscribe now to access step-by-step solutions to millions of textbook problems written by subject matter experts!

Students have asked these similar questions

Which parameter between "solvent polarity function" and dielectric constant show better correlation with the peak positions? (cyclohexane, dioxane, acetonitrile, ethanol, ethylene glycol)

Why is there a need to specify regioselectivity and stereospecificity when dealing with products after a reaction mechanism? Choose one molecule and one type of reaction to substantiate your answer.

1. The hydrogen-bond stretching frequency in the acetic acid dimer is roughly 170 cm¹. Which of the following techniques should you choose to measure the stretching frequency? (a) UV-vis absorption (b) Fluorescence (c) IR absorption (d) Raman Scattering In 1-2 sentences, explain your reasoning:

Answer 2

Question

Chapter 8, Problem 1Q

Interpretation Introduction

Interpretation:

The reason that leads to difficulty in the visualization of separation of cis-2-butene and trans-2-butene on thin layer chromatography plate should be explained.

Concept introduction:

Isomers (cis and trans) of but-2-ene have similar composition. The principle on which the thin layer chromatography works is that two different molecules interact differently with the mobile and stationary phase.Thus, it ends up getting separated. If two similar molecules or isomers are spotted on the plate, they might end up at the same distance from the base.

Expert Solution & Answer

Answer to Problem 1Q

Observing a separate spot of isomers of but-2-ene is difficult, because before they resolve into distinct spots, it evaporates.

Explanation of Solution

But-2-ene vaporizes too fast at room temperature due to very low boiling point. To obtain separate spots for the two isomers of but-2-ene , the sample mixture must move upward in the TLC column. But the mixture spot marked on the TLC plate evaporates.So, identifying and visualizing the two isomers separately becomes difficult.

Want to see more full solutions like this?

Subscribe now to access step-by-step solutions to millions of textbook problems written by subject matter experts!

Answer 3

Question

Chapter 8, Problem 1Q

Interpretation Introduction

Interpretation:

The reason that leads to difficulty in the visualization of separation of cis-2-butene and trans-2-butene on thin layer chromatography plate should be explained.

Concept introduction:

Isomers (cis and trans) of but-2-ene have similar composition. The principle on which the thin layer chromatography works is that two different molecules interact differently with the mobile and stationary phase.Thus, it ends up getting separated. If two similar molecules or isomers are spotted on the plate, they might end up at the same distance from the base.

Expert Solution & Answer

Answer to Problem 1Q

Observing a separate spot of isomers of but-2-ene is difficult, because before they resolve into distinct spots, it evaporates.

Explanation of Solution

But-2-ene vaporizes too fast at room temperature due to very low boiling point. To obtain separate spots for the two isomers of but-2-ene , the sample mixture must move upward in the TLC column. But the mixture spot marked on the TLC plate evaporates.So, identifying and visualizing the two isomers separately becomes difficult.

Want to see more full solutions like this?

Subscribe now to access step-by-step solutions to millions of textbook problems written by subject matter experts!

Answer 4

Question

Chapter 8, Problem 1Q

Interpretation Introduction

Interpretation:

The reason that leads to difficulty in the visualization of separation of cis-2-butene and trans-2-butene on thin layer chromatography plate should be explained.

Concept introduction:

Isomers (cis and trans) of but-2-ene have similar composition. The principle on which the thin layer chromatography works is that two different molecules interact differently with the mobile and stationary phase.Thus, it ends up getting separated. If two similar molecules or isomers are spotted on the plate, they might end up at the same distance from the base.

Expert Solution & Answer

Answer to Problem 1Q

Observing a separate spot of isomers of but-2-ene is difficult, because before they resolve into distinct spots, it evaporates.

Explanation of Solution

But-2-ene vaporizes too fast at room temperature due to very low boiling point. To obtain separate spots for the two isomers of but-2-ene , the sample mixture must move upward in the TLC column. But the mixture spot marked on the TLC plate evaporates.So, identifying and visualizing the two isomers separately becomes difficult.

Want to see more full solutions like this?

Subscribe now to access step-by-step solutions to millions of textbook problems written by subject matter experts!

Answer 5

Chapter 8, Problem 1Q

Interpretation Introduction

Interpretation:

The reason that leads to difficulty in the visualization of separation of cis-2-butene and trans-2-butene on thin layer chromatography plate should be explained.

Concept introduction:

Isomers (cis and trans) of but-2-ene have similar composition. The principle on which the thin layer chromatography works is that two different molecules interact differently with the mobile and stationary phase.Thus, it ends up getting separated. If two similar molecules or isomers are spotted on the plate, they might end up at the same distance from the base.

Expert Solution & Answer

Answer to Problem 1Q

Observing a separate spot of isomers of but-2-ene is difficult, because before they resolve into distinct spots, it evaporates.

Explanation of Solution

But-2-ene vaporizes too fast at room temperature due to very low boiling point. To obtain separate spots for the two isomers of but-2-ene , the sample mixture must move upward in the TLC column. But the mixture spot marked on the TLC plate evaporates.So, identifying and visualizing the two isomers separately becomes difficult.

Answer 6

Chapter 8, Problem 1Q

Interpretation Introduction

Interpretation:

The reason that leads to difficulty in the visualization of separation of cis-2-butene and trans-2-butene on thin layer chromatography plate should be explained.

Concept introduction:

Isomers (cis and trans) of but-2-ene have similar composition. The principle on which the thin layer chromatography works is that two different molecules interact differently with the mobile and stationary phase.Thus, it ends up getting separated. If two similar molecules or isomers are spotted on the plate, they might end up at the same distance from the base.

Expert Solution & Answer

Answer to Problem 1Q

Observing a separate spot of isomers of but-2-ene is difficult, because before they resolve into distinct spots, it evaporates.

Explanation of Solution

But-2-ene vaporizes too fast at room temperature due to very low boiling point. To obtain separate spots for the two isomers of but-2-ene , the sample mixture must move upward in the TLC column. But the mixture spot marked on the TLC plate evaporates.So, identifying and visualizing the two isomers separately becomes difficult.

Answer 7

Chapter 8, Problem 1Q

Interpretation Introduction

Interpretation:

The reason that leads to difficulty in the visualization of separation of cis-2-butene and trans-2-butene on thin layer chromatography plate should be explained.

Concept introduction:

Isomers (cis and trans) of but-2-ene have similar composition. The principle on which the thin layer chromatography works is that two different molecules interact differently with the mobile and stationary phase.Thus, it ends up getting separated. If two similar molecules or isomers are spotted on the plate, they might end up at the same distance from the base.

Answer 8

Expert Solution & Answer

Answer to Problem 1Q

Observing a separate spot of isomers of but-2-ene is difficult, because before they resolve into distinct spots, it evaporates.

Answer 9

Expert Solution & Answer

Answer 10

Expert Solution & Answer

Answer 11

Explanation of Solution

But-2-ene vaporizes too fast at room temperature due to very low boiling point. To obtain separate spots for the two isomers of but-2-ene , the sample mixture must move upward in the TLC column. But the mixture spot marked on the TLC plate evaporates.So, identifying and visualizing the two isomers separately becomes difficult.

Answer 12

Ch. 8 - Prob. 1Q Ch. 8 - Prob. 2Q Ch. 8 - What problem will ensue if the level of the...Ch. 8 - Prob. 4Q Ch. 8 - Prob. 5Q Ch. 8 - Arrange the following in order of increasing Rf...Ch. 8 - What will be the result of applying too much...Ch. 8 - Prob. 8Q Ch. 8 - Prob. 9Q Ch. 8 - A TLC plate showed two spots with Rf values of...

Answer to Problem 1Q

Explanation of Solution

Want to see more full solutions like this?

Chapter 8 Solutions