Determine the concentration of linalool in a highly valued lavender essential oil. The peak areas of a series of standard solutions (calibrations standards) acquired from GC-MS (gas chromatography-mass spectrometry) is presented below. Concentration (mg/L) Peak area 0 201 25 5214 50 14658 75 23647 100 32657 125 42652 150 52478 QUESTION: Calculate the concentration of linalool in yourhighly valued lavender essential oil which returns a peak area of 27235.

Determine the concentration of linalool in a highly valued lavender essential oil. The peak areas of a series of standard solutions (calibrations standards) acquired from GC-MS (gas chromatography-mass spectrometry) is presented below. Concentration (mg/L) Peak area 0 201 25 5214 50 14658 75 23647 100 32657 125 42652 150 52478 QUESTION: Calculate the concentration of linalool in yourhighly valued lavender essential oil which returns a peak area of 27235.

Chemistry & Chemical Reactivity

10th Edition

ISBN:9781337399074

Author:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Publisher:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Chapter11: Intermolecular Forces And Liquids

Section11.6: Properties Of Liquids

Problem 1.2ACP

See similar textbooks

Similar questions

30 20 10 From the procedure 2. Assemble the simple distillation apparatus as generally shown in Figure SD.1 in the lab manual, ensuring that the thermometer bulb is aligned at, or slightly below, the Y in the distillation head. Each ground joint is greased by putting three or four stripes of grease lengthwise around the male joint and pressing the joint firmly into the other without twisting. 3. Attach a water condenser to the distillation head. 4. Remember, water goes in the bottom and out the top. Attach a clamp holder to the end of the drain tube to keep it weighted in the drain. Turn water to a trickle. If it is slowly draining, it is high enough. Begin a low flow of water through the condenser. 5. Place the set up on a heating/stir plate. 6. Turn on the hot plate to start heating the solution. Monitor the temperature and the boiling of the solution throughout the distillation process. 7. Record the temperature of the distillate when the first drops are recovered. 30.0 8. Adjust…
ASSAY Calibration solutions Calibration solutions of naproxen in the range 5 – 25 μg/mL were prepared. Sample preparation 20 tablets weighing 12.3819 g were crushed to a fine powder. A portion of the powder (145.4 mg) was shaken with approximately 150 mL of acetic acid (0.05 M) for 5 min and then made up to volume in a 250 mL volumetric flask (stock solution). Approximately 50 mL of the stock solution was filtered and a 25 mL aliquot was diluted to 100 mL in a volumetric flask. 10 mL of the resulting solution was further diluted to 100 mL with acetic acid (0.05 M). Analysis The standards and sample solutions were analyzed by HPLC under the following conditions: Column: octadecylsilyl (ODS), 4.6 mmx150 mm, mobile phase: acetonitrile : 0.05 M acetic acid (85:15), flow rate: 1 ml/min, UV detection at 243 nm. Results: A calibration curve of concentration versus peak area was constructed for the standard solutions and gave the straight-line equation: y = 3555.6x + 85, r = 0.9999 The area…
Should be 3 answers in total. Will thumbs up! Next the student conducts two different runs: In RUN 1, 10.0 mL of 5.00 M NAOH is combined with 10.0 mL of 0.010 M CO and 80.0 mL of wate In RUN 2, 20.0 mL of 5.00 M NAOH is combined with 10.0 mL of 0.010 M CO and 70.0 mL of wate The following plots were obtained for each of the runs: [crystal orange] vs time (RUN 1) In[crystal orange] vs time (RUN 1) 0.0012 0.001 -2 y--0.4463x- 7.3334 y =-0.0002x + 0.0007 R- 0.6565 R = 0.893 0.0008 4 0.0006 -6 0.0004 -8 0.0002 0.0002 -12 time (hr) time (hr) 1/[crystal orange] vs time (RUN 1) 1/[crystal orange] vs time (RUN 2) 12000 25000 10000 20000 8000 15000 6000 y = 2000x + 1000 R =1 10000 y 4000x + 1000 R =1 4000 2000 5000 time (hr) time (hr) Figure 4. Kinetic traces for the reaction between crystal orange and sodium hydroxide. What is the order with respect to CO? | Select ] What is the order with respect to NaOH? | Select ] What is the value of the averaged rate constant for the reaction above? Give…
aur X Macmilla X 2/ Course X 50 ~ T Sections X Submit Answer evo/index.html?deploymentid=5735112480241329813180832311&elSBN=9781305862883&id=1707786042&snapshot! References lancing Molecular Equations: This is group attempt 2 of 10 HOMEW X Use the References to access Important values if needed for this question. When the following molecular equation is balanced using the smallest possible Integer coefficients, the values of these coefficients are: Na (s) + H₂0 (1). NaOH (aq) + H₂ (8) ≡く □ □ A MindTap ㅁ Autosaved at 5:51 PM MacBook Air Gatoms to When the following molecular equation is balanced using the smallest possible Integer coefficients, the values of these coeffi Br₂(g) + Cl₂(g) →BrCl(g) X Dom
Pesticide residues were found in a lot of oranges; the compound identified was the epoxide of heptachlor (EH). To quantify the amount of this pesticide in oranges, 20 grams were taken from fruit peels and mixed with methylene chloride to extract it. The concentration of heptachlor epoxide in the sample was determined by gas chromatography coupled to a detector mass (GC-MS); and calibration was performed using anthracene (A) as internal standard. For In this analysis, the anthracene had a concentration of 350 ppm and the same volume was added to each standard. The table below shows the concentrations of the standard and the ratio of the areas.and the sample is: 0.1080.Determine the concentration of heptachlor epoxide in the sample.
(Concentration) You are tasked to prepare 50.000 ppm of a caffeine standard for an analysis. If you need to prepare 500.00 (±0.08) mL of this solution, how much (in grams) solid, pure caffeine are you supposed to dissolve? What absolute uncertainty is associated with your mass measurement if the prepared solution has a 0.12% percent relative uncertainty? Write your answer using the appropriate number of digits. Note that the formula mass of caffeine is 194.194 g/mol with negligible error. (absolute error) How many significant figures does your reported mass have? --- (number of sig. figs.)
A 2.0 g of MgCO3 was dissolved and diluted to exactly 500-mL volumetric flask. If 50-mL aliquot was used in the analysis, what is the weight of MgCO3 present in the aliquot sample
In the Analytical Chemistry laboratory, one of the B.Sc student Ms. Fatma wanted to analyze the presence of Iron(II) ion in the water samples collected from Sohar Industrial Area in the Sultanate of Oman and analyzed by Spectrophotometric method. (1) 250.00 mL of this water sample (Solution A) known to contain unknown amount of FeSO4. She has diluted Solution A by a dilution factor 10 to make 250.00 mL solution, which she labeled Solution B. Using Spectrophotometer, she has measured the absorbance value (0.642) for Solution B at 508 nm using 1.00 cm cell (cuvet). The molar absorptivity value for Fe2* ion at 508 nm is ɛ508 = 30.8 M-1cm1. (i) What volume of the solution A did she require to make the 250.00 mL of Solution В? (ii) in (i)? What instrument should she use to transfer the volume of the Solution A calculated (ii) Concentration of FeSO4 in Solution B. (iv) Concentration of FeSO4 in Solution A. Mass of FeSO4 in Solution A (Show your calculation) (v)
Concentration of Acetic Acid in a Vinegar Solution. Average molarity of NaOH Volume HC₂H30₂ sample Final buret reading Initial buret reading Volume NaOH (Show all units and all calculations) Molarity of HC₂H30₂ (unrounded) Average molarity of HC₂H302 (unrounded) Deviations Average deviation Best estimate for molarity of HC₂H302 Average mass percent HC₂H302 46.4mL Oml Ran out of Base ↓ ↓ ↓ ↓ 10.014 HOA je beart giov isults weari?! ferottelucuny Cambia) 10 Kousad Question 1. A Rolaids tablet contains calcium carbonate that neutralizes stomach acid. If 44.55 mL of 0.448 M hydrochloric acid is required to neutralize one tablet, how many milligrams of calcium carbonate are in a Rolaids tablet? CaCO, (s) + 2HCl(aq) → CaCl₂ (aq) + H₂O (1) + CO₂ (g)
Q3/ A) 0.63 g of a sample containing Na,CO3, NaHCO, and inert impurities is titrated with 0.2 M HCI, requiring 17.2 mL to reach the phenolphthalein end point and a total of 43.5 mL to reach the modified methyl orange end point, How many grams NazCO3 and NaHCO, are in the mixture?
You are preparing a 100.0 mL standard solution needed for titration analysis. The NaOH (40 g/mol) pellets are measured to be 0.5341 g in a balance with acceptable uncertainty of +0.001 g. Mass of the pellets is recorded after taring the container. The pellets are put in a beaker and added with 50 ml distilled water measured by a graduated cylinder. The solution is then quantitatively transferred to a 100-mL volumetric flask with uncertainty of ±0.08 mL and diluted to a 100-mL mark. What is the concentration (M) of the solution and estimate its uncertainty by propagation? Assumption: There is no uncertainty in molar mass. Express your answer as C+/- u M.
2) As an example of precision and accuracy of data, suppose the % carbon in a single compound has been measured thrce separate times by 2 different students. The theoretical % carbon is 21.34%. Student 1: trial 1:26.11%, trial 2: 26.24% trial 3: 25.92 %, Avg - 26.09 Student 2: trial 1: 20.35%. trial 2: 22.64 % trial 3: 19.79 %. Avg = 20.93 a) Which student had the more precise data and how can you tell? b) Which student had the more accurate data and how can you tell? 3a) Calculate the % error of Student 1 data in problem 2 above. Show all work below. WATCH SIG FIGS