Tutorials in Introductory Physics
1st Edition
ISBN: 9780130970695
Author: Peter S. Shaffer, Lillian C. McDermott
Publisher: Addison Wesley
expand_more
expand_more
format_list_bulleted
Concept explainers
Question
Chapter 11.1, Problem 2gT
To determine
If the nodal line and line of constructive interference change over time.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
A tube is open only at one end and has a length of 1.5 m. This tube sustains a standingwave at its third harmonic. What is the distance between one node and the adjacentantinode? Sketch the standing wave pattern.
(I know the answer is 0.5m I just really need to see the process. Please label variables for equations. I've included the equations we have been given in an image)
The two sources S1 and S2 shown in Fig. emit waves ofthe same wavelength λ and are in phase with each other. Suppose S1 isa weaker source, so that the waves emitted by S1 have half the amplitude of the waves emitted by S2. How would this affect the positions of the antinodal lines and nodal lines? Would there be total reinforcement at points on the antinodal curves? Would there be total cancellation at points on the nodal curves? Explain your answers.
Recall that the 2D Fourier transform essentially maps an image into a collection of
patterns. Consider the following k-space coordinates and sketch the pattern they
represent.
a. k, = kŷ
b. kz = 2k (0.5 & + 9)
c. kz =2
V3
Take the constant k to represent a pattern with a periodicity of that of the lines on a
piece of notebook paper, and scale each of them appropriately.
Chapter 11 Solutions
Tutorials in Introductory Physics
Ch. 11.1 - Prob. 1TCh. 11.1 - Prob. 2aTCh. 11.1 - Prob. 2bTCh. 11.1 - Prob. 2cTCh. 11.1 - The representation that we have been using...Ch. 11.1 - Prob. 2eTCh. 11.1 - Prob. 2gTCh. 11.1 - Each of the photographs at right shows a part of a...Ch. 11.1 - Obtain a piece of paper and a transparency with...Ch. 11.2 - Obtain a pan of water and form a barrier in it...
Ch. 11.2 - Prob. 2aTCh. 11.2 - Obtain an enlargement of the diagram at right that...Ch. 11.2 - Suppose that the width of one of the slits were...Ch. 11.2 - Red light from a distant point source is incident...Ch. 11.2 - Compare the situation in part II (in which a...Ch. 11.2 - For each of the lettered points, determine D (in...Ch. 11.2 - Suppose that one of the slits were covered. At...Ch. 11.2 - The pattern produced by red light passing through...Ch. 11.2 - Consider point B, the first maximum to the left of...Ch. 11.3 - Red light from a distant point source is incident...Ch. 11.3 - In a previous homework, you found an expression...Ch. 11.3 - Suppose that the screen were semicircular, as...Ch. 11.3 - Consider a point M on the distant screen where...Ch. 11.3 - Consider a point N on the screen where there is a...Ch. 11.3 - Obtain a set of transparencies of sinusoidal...Ch. 11.3 - Suppose that coherent red light were incident on a...Ch. 11.3 - Generalize your results from the 2-slit, 3-slit,...Ch. 11.3 - Coherent red light is incident on a mask with two...Ch. 11.3 - Prob. 3dTCh. 11.4 - Red light from a distant point source is incident...Ch. 11.4 - Suppose that point X marks the location of the...Ch. 11.4 - Suppose that only slit 1 is uncovered, and all...Ch. 11.4 - Show how you could group all ten slits into five...Ch. 11.4 - Suppose that the number of slits is doubled and...Ch. 11.4 - If we continued to add slits in this way (i.e.,...Ch. 11.4 - How is this pattern different from what you would...Ch. 11.4 - Consider the following dialogue: Student 1: "l...Ch. 11.4 - The photograph at right shows the diffraction...Ch. 11.4 - The photograph at right shows the diffraction...Ch. 11.4 - Describe what you would see on the screen if the...Ch. 11.4 - If a diffraction pattern has several minima (like...Ch. 11.4 - In part A, you drew a diagram that showed how find...Ch. 11.4 - Use the model that we have developed to write an...Ch. 11.5 - The minima that occur in the case of a single slit...Ch. 11.5 - Consider the following dispute between two physics...Ch. 11.5 - A second slit, identical in size to the first, is...Ch. 11.5 - Both slits are now uncovered. For what angles will...Ch. 11.5 - Suppose that the width of both slit, a, were...Ch. 11.5 - Suppose instead that the distance between the...Ch. 11.5 - The four graphs from part C that show relative...Ch. 11.5 - Consider the relative intensity graph shown at...Ch. 11.5 - Consider the following comment made by a student:...Ch. 11.5 - You may have already noticed that the maxima are...Ch. 11.6 - Prob. 1TCh. 11.6 - Prob. 2aTCh. 11.6 - When comparing two materials of different indices...Ch. 11.6 - Consider light incident on a thin soap film, as...Ch. 11.6 - Light of frequency f=7.51014Hz is incident on the...Ch. 11.6 - Suppose that an observer were located on the left...Ch. 11.6 - Observer A is looking at the part of the film that...Ch. 11.6 - Observer B is looking at the part of the film that...Ch. 11.6 - Observer C is looking at the thinnest part of the...Ch. 11.6 - Describe the appearance of the film as a whole.Ch. 11.6 - What are the three smallest film thickness for...Ch. 11.6 - The thickness of the film is 1650 nm at the bottom...Ch. 11.7 - Look at the room lights through one of the...Ch. 11.7 - Hold a second polarizing filter in front of the...Ch. 11.7 - Do the room lights produce polarized light?...Ch. 11.7 - Suppose that you had two marked polarizers (i.e.,...Ch. 11.7 - Suppose that you had a polarizer with its...Ch. 11.7 - Prob. 2dTCh. 11.7 - An observer is looking at a light source through...Ch. 11.7 - Consider a beam of unpolarized light that is...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.Similar questions
- Please use the picture provided to answer the following two questions: 1. are the two sources in phase or out of phase? Explain how you can tell from the diagram. if the two sources are out of phase, give the phase difference between the two sources. Explain. 2. What is the source separation, d, in terms of the wavelength lamda? Explain your reasoning.arrow_forwardIntroduction to Two-Source Interference Learning Goal: To gain an understanding of constructive and destructive interference. Consider two sinusoidal waves (1 and 2) of identical wavelength A, period T, and maximum amplitude A. A snapshot of one of these waves taken at a certain time is displayed in the figure below. (Figure 1) Let y₁ (z, t) and y2 (x, t) represent the displacement of each wave at position at time t. If these waves were to be in the same location (2) at the same time, they would interfere with one another. This would result in a single wave with a displacement y (z, t) given by y(z, t)= y(x, t) + y2(x, t). This equation states that at time t the displacement y (x, t) of the resulting wave at position z is the algebraic sum of the displacements of the waves 1 and 2 at position z at time t. When the maximum displacement of the resulting wave is less than the amplitude of the original waves, that is, when ymax A. the waves are said to interfere constructively because the…arrow_forwardA simple cubic crystal is illuminated with X- ray of wavelength 0.09 nm at a glance angle. The crystal is rotated and the angles at which Bragg reflection occurs are measured. 1. Which set of crystal plane will give the smallest angle for first - order reflection? Explain in details your answer. 2. If this angle is 8.9°, determine the spacing between these planes. 3. At what angle will first-order reflection be obtained from the (110) crystal planes? Will there be any higher order reflection from this plane?arrow_forward
- Please don't use the Chegg answer. We haven't discussed the phase difference equation 1. a. For the antireflective coating shown in the figure, how thick should the coating be to destructively interfere the incoming light and the reflected light (off the front of the glass) and why? Assume the light has a wavelength in air of 533 nm (green). b. What would the intensity be for 400 nm light and why? (Remember: intensity goes as the electric field squared!)arrow_forwardGive one example/experiment on how to demonstrate the wave behavior; reflection, refraction, diffraction andinterference? Please explain thoroughly. Write it clear so I can understand. Thank youarrow_forwardConsider the three layers described below. All layers have the same density.a. We’re interested in the seismogram that would be obtained at zero offset. Consider the reflection from the top of layer 2: What is the travel time for that reflection event and what is the value of the reflection coefficient?b. Consider the reflection from the top of layer 3. What is the travel time for that reflection event and what is the value of the reflection coefficient?c. Compute the transmission coefficients associated with waves that travel through the first interface; that is, the transmission coefficients for the downward and upward travelling waves.d. Plot the final reflectivity log as a function of time. Make sure you provide the amplitude of each event.e. Now consider the refracted wave along the first interface: What is the shortest offset you could measure the refracted wave?f. Why would you not expect refraction before this offset? g. Where would the refracted wave overtake the direct…arrow_forward
- What happens to the diffraction patters when the following are changed? Thoroughly describe each. a. The width of a single slit, w b. The width w and separation d of double slit c. The number of multiple slits N d. The distance from the slit plate to the sensor L e. The experimental y value collected from your data.arrow_forwardStanding Waves in Air Columns, fixed length- WT-1 You are designing an air-filled tube that is closed at one end and open at the other to have a sound wave with a fundamental frequency of 512HZ in air at sea level. a) Sketch a figure like the one shown to the right and draw below the tube the fundamental mode of vibration and the next three harmonics. Beside each pattern, write the tube-length-to-wavelength relationship. b) Find the length needed for this tube. c) Find the frequency needed for each standing wave pattem you sketched. Use your results from above to find the frequencies; do not use equations from memory. open closedarrow_forwarda. Explain the empirical relationship between mean ,median and mode for the data of your own field physics. Ilustrate graphically relative position of mean, median and mode for frequency curve which are skewed to right and to be left. b. Explain in your own words that how this course "Probability and Statistics" will be helpful to solve different problems in the field of Physics? Your answer should not be matched with other fellows. THE ENDarrow_forward
- Please show all steps. Label all variable symbols such as wavelength, wave speed, period etc before using them in a formula. Please write out answer if possible. DO NOT TYPE ANSWERS WITHOUT MULTIPLICATION OR DIVISION SIGNS.arrow_forwardThe below image shows the changing frequency, and therefore, wavelengths for light from a distant source. The image on the left shows the normal laboratory values of light absorbed from the spectrum. The image on the right shows a distant object in motion. What is the behavior of the object? O The light is red shifted and the object is moving away from Earth. O The light is blue shifted and the object is moving towards Earth. O The light is blue shifted and the object is moving away from Earth. O The light is redshifted and the object is moving towards Earth.arrow_forwardWrite an equation giving the wavelength of a line as a function of the inverse of the grating pitch, the order of the line and the angular position of the line. How will you identify the gas from its visible line spectrum? Describe clearly the method you will use.arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- College PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage LearningUniversity Physics (14th Edition)PhysicsISBN:9780133969290Author:Hugh D. Young, Roger A. FreedmanPublisher:PEARSONIntroduction To Quantum MechanicsPhysicsISBN:9781107189638Author:Griffiths, David J., Schroeter, Darrell F.Publisher:Cambridge University Press
- Physics for Scientists and EngineersPhysicsISBN:9781337553278Author:Raymond A. Serway, John W. JewettPublisher:Cengage LearningLecture- Tutorials for Introductory AstronomyPhysicsISBN:9780321820464Author:Edward E. Prather, Tim P. Slater, Jeff P. Adams, Gina BrissendenPublisher:Addison-WesleyCollege Physics: A Strategic Approach (4th Editio...PhysicsISBN:9780134609034Author:Randall D. Knight (Professor Emeritus), Brian Jones, Stuart FieldPublisher:PEARSON
College Physics
Physics
ISBN:9781305952300
Author:Raymond A. Serway, Chris Vuille
Publisher:Cengage Learning
University Physics (14th Edition)
Physics
ISBN:9780133969290
Author:Hugh D. Young, Roger A. Freedman
Publisher:PEARSON
Introduction To Quantum Mechanics
Physics
ISBN:9781107189638
Author:Griffiths, David J., Schroeter, Darrell F.
Publisher:Cambridge University Press
Physics for Scientists and Engineers
Physics
ISBN:9781337553278
Author:Raymond A. Serway, John W. Jewett
Publisher:Cengage Learning
Lecture- Tutorials for Introductory Astronomy
Physics
ISBN:9780321820464
Author:Edward E. Prather, Tim P. Slater, Jeff P. Adams, Gina Brissenden
Publisher:Addison-Wesley
College Physics: A Strategic Approach (4th Editio...
Physics
ISBN:9780134609034
Author:Randall D. Knight (Professor Emeritus), Brian Jones, Stuart Field
Publisher:PEARSON