Production and Operations Analysis, Seventh Edition
7th Edition
ISBN: 9781478623069
Author: Steven Nahmias, Tava Lennon Olsen
Publisher: Waveland Press, Inc.
expand_more
expand_more
format_list_bulleted
Question
Chapter 12.6, Problem 27P
Summary Introduction
Interpretation:
An expression for average annual operating cost is to be determined.
Concept Introduction:
Probability is the likelihood of an event to occur.. It ranges between 0 to 1. O implies no chance of occurance while 1 implies 100% chance of occurance.
Expert Solution & Answer
Want to see the full answer?
Check out a sample textbook solutionStudents have asked these similar questions
The time to deliver packaged containers by a logistics company is found fromsamples of size 4. The mean and standard deviation of delivery times is estimated tobe 140 hours and 6 hours, respectively.(a) Find the 2 sigma and 3 sigma control limits for the average delivery time.(b) Explain a type I and type II error specifically in this context.(c) If the mean delivery time shifts to 145 hours, what is the probability of notdetecting this by the second sample after the shift?(d) What is the ARL? Explain
Meena Chavan Corp.’s computer chip production process yields DRAM chips with an average life of 1,800hours and s = 100 hours. The tolerance upper and lowerspecification limits are 2,400 hours and 1,600 hours, respectively. Is this process capable of producing DRAM chips tospecification?
A single sampling inspection scheme for large lot of mass-produced flanges states:From each lot take and inspect a random sample of 50. If 3 or more defectives, inspect the whole lot and remove all defectives, if less than 3 are found accept the lot without further inspection.a. Obtain the equation for Pa the probability that a lot containing a fraction p of defectives will be accepted, in terms of p.b. Evaluate Pa for p=0.01, 0.02, 0.03, 0.05, 0.07, 0.10, 0.15, 0.20, 0.30. Plotthe operating characteristics and average outgoing quality curve.c. Estimate: (a) the producer’s Risk at p of 2% (b) the consumer’s Risk for pof 5%.
Chapter 12 Solutions
Production and Operations Analysis, Seventh Edition
Ch. 12.1 - Prob. 2PCh. 12.1 - Prob. 3PCh. 12.1 - Prob. 4PCh. 12.1 - Prob. 5PCh. 12.1 - Prob. 6PCh. 12.2 - Prob. 7PCh. 12.2 - Prob. 8PCh. 12.2 - Prob. 9PCh. 12.2 - Prob. 10PCh. 12.2 - Prob. 11P
Ch. 12.2 - Prob. 12PCh. 12.2 - Prob. 13PCh. 12.3 - Prob. 14PCh. 12.3 - Prob. 15PCh. 12.3 - Prob. 16PCh. 12.3 - Prob. 17PCh. 12.4 - Prob. 18PCh. 12.4 - Prob. 19PCh. 12.4 - Prob. 20PCh. 12.4 - Prob. 21PCh. 12.5 - Prob. 22PCh. 12.6 - Prob. 23PCh. 12.6 - Prob. 24PCh. 12.6 - Prob. 25PCh. 12.6 - Prob. 26PCh. 12.6 - Prob. 27PCh. 12.6 - Prob. 28PCh. 12.9 - Prob. 29PCh. 12.9 - Prob. 30PCh. 12.9 - Prob. 31PCh. 12.9 - Prob. 32PCh. 12.9 - Prob. 33PCh. 12.10 - Prob. 34PCh. 12.10 - Prob. 35PCh. 12.10 - Prob. 37PCh. 12.10 - Prob. 38PCh. 12.10 - Prob. 39PCh. 12.10 - Prob. 40PCh. 12.11 - Prob. 41PCh. 12.11 - Prob. 42PCh. 12.11 - Prob. 43PCh. 12.11 - Prob. 44PCh. 12.12 - Prob. 46PCh. 12.12 - Prob. 47PCh. 12.12 - Prob. 48PCh. 12 - Prob. 49APCh. 12 - Prob. 50APCh. 12 - Prob. 51APCh. 12 - Prob. 52APCh. 12 - Prob. 53APCh. 12 - Prob. 54APCh. 12 - Prob. 55APCh. 12 - Prob. 57APCh. 12 - Prob. 58APCh. 12 - Prob. 59APCh. 12 - Prob. 60APCh. 12 - Prob. 61APCh. 12 - Prob. 62APCh. 12 - Prob. 63APCh. 12 - Prob. 64APCh. 12 - Prob. 65APCh. 12 - Prob. 66APCh. 12 - Prob. 67APCh. 12 - Prob. 68APCh. 12 - Prob. 69APCh. 12 - Prob. 70AP
Knowledge Booster
Similar questions
- You are a food specialist in a company that specializes inrefrigerated delicacies, and one of your brands requires beingmaintained at a temperature of 5°C. You determine averagewater activity (aw) at this temperature to be 0.2. One day, you are informed that the cooling systems onone of the delivery trucks carrying your company’s productsmalfunctioned while en route to its destination and it would notbe fixed until the next delivery. The driver has informed you thatthe temperature in the delivery bay of the truck is averaging55°C. You estimate a heat of sorption (Q) of 19 kJ/mol. Calculate the water activity of the brand at this elevatedtemperature and comment on it’s integrity. Should the deliverystill push through? Or should the products be recalled anddisposedarrow_forwardThe number of items in the population is 25,000. The number of blue items in the population is 315. The number of items in the sample is 500. The probability of observing more than 8 blue items in the sample is to 4 decimal places. Round your answer .1145 .8180 .1820 6.30 There is not enough information to answer this question None of the above QUESTION 8 The average number of phone calls to a call center on Thursday nights from 10:00 PM to 11:00 PM is 6.3. The probability of less than 3 calls being received by that call center on any given Thursday night from 10:00 PM to 11:00 PM is Round your answer to 4 decimal places. .1264 .0765 .0364 .0498 There is not enough information to answer this question None of the abovearrow_forwardGiven a normal distribution with μ= 105 and σ = 20, and given you select a sample of n = 16, complete parts (a) through (d). a. What is the probability that X is less than 92? P(X<92) 0.0047 (Type an integer or decimal rounded to four decimal places as needed.) b. What is the probability that X is between 92 and 93.5? P(92 X 93.5)= 0.0061 (Type an integer or decimal rounded to four decimal places as needed.) c. What is the probability that X is above 105.2? P(X 105.2)= 0.4840 (Type an integer or decimal rounded to four decimal places as needed.) d. There is a 67% chance that X is above what value? X = (Type an integer or decimal rounded to two decimal places as needed.)arrow_forward
- 2. A beverage company would like to use a mean chart to monitor how much liquid beverage it puts into each 500-ml bottle. They know from experience that whenever this process is under control, bottle weight is normally distributed with a mean of 500 ml and a standard deviation of 2 ml. The company plans to measure samples of 30 bottles from the production lineevery hour and record the mean weight of liquid beverage in the bottles. If the company uses z = 3 as its standard for establishing the mean chart, where will the upper and lower control limits be on the chart? (Noteshaper: Scenario #28)arrow_forwardWebster Chemical’s nominal weight for filling tubes of caulk is 8.00 ounces ± 0.60 ounces. The target process capability ratio is 1.33. The current distribution of the filling process is centered on 8.054 ounces with a standard deviation of 0.192 ounces. Compute the process capability ratios Cp and Cpk to assess whether the filling process is capable and set properly.arrow_forwardThe error measurement that gives weight based on the relative error is: O Bias Residual MSE MAD O MAPEarrow_forward
- The following data was recorded while observing the increase in the number of butterflies in two different ponds, Pond A and Pond B. Number of Butterflies Present Over 5 Years Year Pond A Pond B 0 50 65 85 1 2 3 4 5 100 O 110 121 133 146 161 110 143 186 What is the rate of growth, r, for each pond and which pond has the fastest average rate of growth over the five years? TA = 1.1, TB = 1.3, mg = 3.72 butterflies/yr TA=0.9, TB=0.8, mg = 3.72 butterflies/yr TA=0.9, TB=0.8, mg=27.2 butterflies/yr TA = 1.1, TB = 1.3, mg=27.2 butterflies/yrarrow_forward1. Statistical process control, hypothesis testing, and control charts Consumers value prompt service when they order takeout or delivered pizza, and pizza restaurants compete for customers by making time promises. Papa John's, for instance, offers a 10-minute takeout guarantee. Domino's advertises a 30-minute delivery time. Suppose that the quality control manager at a nationwide pizza chain defines this production variable: An order is processed on time or late. Every night, a random sample of pizza orders is selected, and data are collected on the production variable for each order in the sample. To detect a change in the number of orders that are late, the quality control manager uses Based on the control chart, the quality control manager decides that the variation in output is due to assignable causes. Consequently, the manager concludes that the production process is ; it is Statistical procedures for process control use a hypothesis-testing framework. The null and alternative…arrow_forwardYi is fixing up his road bike to prepare for a triathlon. He looks at his tires and wonders how much he should inflate them. Which of the following variables is an outcomevariable?a. The outside temperatureb. The rolling resistancec. The number of times he presses the pumpd. The size of the tirearrow_forward
- Two processes are used to produce forgings used in an aircraft wing assembly. Of 200 forgings selected from process 1.12 do not conform to the strength specifications. Where as of 300 forgings selected from process. 2.6 are nonconforming. Test the hypothesis that the two processes have identical fractions nonconforming.Use a=0.05, and explain the resultarrow_forwardThe director of research and development is testing a new drug. She wants to know if there is evidence at the 0.05 level that the drug stays in the system for more than 399 minutes. For a sample of 81 patients, the mean time the drug stayed in the system was 401 minutes. Assume the standard deviation is known to be 21. Step 1 of 5: Enter the hypotheses: Step 2 of 5: Enter the value of the z test statistic. Round your answer to two decimal places. Step 3 of 5: Specify if the test is one-tailed or two-tailed. Step 4 of 5: Enter the decision rule. Step 5 of 5: Enter the conclusion.arrow_forwardSuppose that material hardness is normally distributed with a mean of 52 and a standard deviation of 1. Specification limits for hardness are from 45 to 55. What is Cp?arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
- Practical Management ScienceOperations ManagementISBN:9781337406659Author:WINSTON, Wayne L.Publisher:Cengage,Operations ManagementOperations ManagementISBN:9781259667473Author:William J StevensonPublisher:McGraw-Hill EducationOperations and Supply Chain Management (Mcgraw-hi...Operations ManagementISBN:9781259666100Author:F. Robert Jacobs, Richard B ChasePublisher:McGraw-Hill Education
- Purchasing and Supply Chain ManagementOperations ManagementISBN:9781285869681Author:Robert M. Monczka, Robert B. Handfield, Larry C. Giunipero, James L. PattersonPublisher:Cengage LearningProduction and Operations Analysis, Seventh Editi...Operations ManagementISBN:9781478623069Author:Steven Nahmias, Tava Lennon OlsenPublisher:Waveland Press, Inc.
Practical Management Science
Operations Management
ISBN:9781337406659
Author:WINSTON, Wayne L.
Publisher:Cengage,
Operations Management
Operations Management
ISBN:9781259667473
Author:William J Stevenson
Publisher:McGraw-Hill Education
Operations and Supply Chain Management (Mcgraw-hi...
Operations Management
ISBN:9781259666100
Author:F. Robert Jacobs, Richard B Chase
Publisher:McGraw-Hill Education
Purchasing and Supply Chain Management
Operations Management
ISBN:9781285869681
Author:Robert M. Monczka, Robert B. Handfield, Larry C. Giunipero, James L. Patterson
Publisher:Cengage Learning
Production and Operations Analysis, Seventh Editi...
Operations Management
ISBN:9781478623069
Author:Steven Nahmias, Tava Lennon Olsen
Publisher:Waveland Press, Inc.