Write a code to find out the critical points and investigate the type for the given linear system.

Question

Want to see the full answer?

Answer 1

Question

Chapter 6.2, Problem 33P

Program Plan Intro

Write a code to find out the critical points and investigate the type for the given linear system.

Expert Solution & Answer

Want to see the full answer?

Check out a sample textbook solution

See solution

Students have asked these similar questions

Suppose that a parachutist with linear drag (m=50 kg, c=12.5kg/s) jumps from an airplane flying at an altitude of a kilometer with a horizontal velocity of 220 m/s relative to the ground. a) Write a system of four differential equations for x,y,vx=dx/dt and vy=dy/dt. b) If theinitial horizontal position is defined as x=0, use Euler’s methods with t=0.4 s to compute the jumper’s position over the first 40 s. c) Develop plots of y versus t and y versus x. Use the plot to graphically estimate when and where the jumper would hit the ground if the chute failed to open.

7. A system is stable if all its roots of the characteristic equation are (a) positive (b) negative (d) any of the above

Q.4 In an experimental setup, mineral oil is filled in between the narrow gap of two horizontal smooth plates. The setup has arrangements to maintain the plates at desired uniform temperatures. At these temperatures, ONLY the radiative heat flux is negligible. The thermal conductivity of the oil does not vary perceptibly in this temperature range. Consider four experiments at steady state under different experimental conditions, as shown in the figure Q1. The figure shows plate temperatures and the heat fluxes in the vertical direction. What is the steady state heat flux (in W m) with the top plate at 90°C and the bottom plate at 45°C? [4] 30°C 70°C 40°C 90°C flux = 39 Wm-2 flux =30 Wm2 flux = 52 Wm 2 flux ? Wm-2 60°C 35°C 80°C 45°C Experiment 1 Experiment 2 Experiment 3 Experiment 4